Installing the TBUS-5i Insert Plate
Contents
1. Installing the TBUS 5i Insert Plate The TBUS 5i nsert Plate see Figure 1 is designed as a replacement for the connecting surface of the TBUS 5 letting you install Kramer inserts and modules according to your needs Power Module Opening 2 x Blank Plate Cable Pass through Figure 1 The Insert Plate The inserts can be installed before or after installing the TBUS Si unit To mount an insert do the following 1 Unscrew the blank insert plate 2 Place and align the insert under the opening insert the two screws to fix the insert in place and tighten them To install the TBUS 5i Insert Plate do the following 1 Remove the five height adjustment screws see item 5 in Table 1 of the TBUS 5 user manual on the sides of the enclosure while supporting the surface from underneath with your hand keep the screws 2 Take out the connecting surface The complete list of Kramer inserts and interfaces is on our Web site at www kramerelectronics com Unscrew the two power module screws that fasten the power module to the connecting surface keep the screws and remove the power module from below Insert the power module into the designated opening make sure you place the power module in the correct position on the Insert Plate and tighten with the two power module screws Place the Insert Plate inside the enclosure and raise or lower the conn2. ecting surface to the required height Fasten the screws and tighten them in place Height Adjustment Screw Figure 2 Removing the Height Adjustment Screws TBUS 5i Insert Plate Installation Instructions For the latest information on our products and a list of Kramer distributors visit our Web site www kramerelectronics com CE Kramer Electronics Ltd Web site www kramerelectronics com E mail info kramerel com P N 2900 001205 REV 1
Download Pdf Manuals
Related Search