quadrapaddle signal ita for wire wrap contact installation and removal
Contents
1. QUADRAPADDLE SIGNAL CONTACTS AND MODULES USER S MANUAL SECTION 4 VIRGINIA PANEL CORPORATION QUADRAPADDLE SIGNAL ITA FOR WIRE WRAP CONTACT INSTALLATION AND REMOVAL PART 610 138 122 TOOLS REQUIRED QuadraPaddle Wire Wrap ITA Insertion Tool Part 910 113 106 QuadraPaddle ITA Extraction Tool Part 910110111 CONTACT INSTALLATION INSTRUCTIONS NOTE For information concerning the process of wrapping the contact see contact assembly instructions in Section 3 of this User s Manual 1 Insert the contact into the back wiring side of the module Figure A Make sure the contact is inserted as far as possible 2 Place the QuadraPaddle Wire Wrap ITA Insertion Tool Part 910 113 106 onto the contact Figure B 3 Using the insertion tool push the contact into the module until it is fully seated 4 To ensure the contact is fully seated pull on the square post lightly If the contact is not seated it will be pulled out of the module CONTACT REMOVAL INSTRUCTIONS 1 Remove the module from the ITA frame NOTE For more information concerning the process of removing the module from the ITA frame see module installation and removal instructions in Section 5 of this User s Manual 2 Place the QuadraPaddle ITA Extraction Tool Part 910 110 111 Figure C over the mating end of the contact to be removed replaced Use care to keep the tool perpendicular to the surface of the module as to not bend the tool or the contact t2. o be removed Rotate the tool slightly while pushing it into the counter bore on the mating side of the module 3 Once the extraction tool is seated properly and the tabs on the retaining ring are compressed push the plunger The contact will be pushed out of the rear of the module DO NOT DEPRESS THE PLUNGER ON THE BACK OF THE EXTRACTION TOOL UNTIL THE TIP OF THE EXTRACTION TOOL HAS BEEN FULLY SEATED INTO THE MODULE AND COMPRESSED THE RETAINING RING TABS ON THE CONTACT NOTE The process shown here uses standard 90 series modules The same process is used for modules from other series NOTE If you are using a hybrid module you may need fo reference the User s Manual for the other contact type for extraction instructions Figure A Contact inserted into the back of the module INSERTION TOOL DETAIL A Figure B Ensure that the fool is kept perpendicular to the module face to avoid damage to the contact or tool Le qe l EXTRACTION TOOL RETAINING RING TAB Figure C Ensure that the tool is kept perpendicular to the module face to avoid damage to the contact or tool 4 4 For more information visit voc com 12 20 12
Download Pdf Manuals
Related Search