SERVICE INSTRUCTION
Contents
1. 4 VACANT 5 VACANT 6 RED CENTER PIN 7 GREEN W YELLOW STRIPE Ransburg Maintenance Information 1 Connector Resistance 10 ohms or less see drawing 2 Do not soak or submerse in solvent or paint 3 Do not permit damage by stepping on driving on or pinching between doors or cabinets Maintain 3 75mm or greater bend radius 4 Recommended replacement frequency annually Low Voltage Cable Connection From Controller to Applicator CONNECT 4 PIN CONNECTOR TO THE RECEPTACLE ON THE APPLICATOR TIGHTEN WITH A WRENCH 6298 XX LOW VOLTAGE CABLE ONNECT 7 PIN CONNECTOR TO RECEPTACLE ON REAR OF LOW VOLTAGE CONTROLLER HAND TIGHTEN ONLY JEPSLMIN AIRINDUL IPS 2Ps o SI 11 01 1 Ransburg Low Voltage Cable Connection From Controller to Cascade CONNECT 7 PIN CONNECTOR TORI jA LOW VOLTAGE CONTROLLER HAND TIGHTEN ONLY CONNECT 4 DIN CONNECTOR TO RCEPTACLE ON THE SIDE OF THE CASCADE HAND TIGHTEN ONLY 76298 XX LOW VOLTAGE CABLE Manufacturing 1910 North Wayne Street Angola Indiana 46703 9100 Telephone 260 665 8800 Fax 260 665 8516 Technical Service Assistance 320 Phillips Avenue Toledo Ohio 43612 1493 Telephone toll free 800 233 3366 www ransburg com Technical Support Representatives can direct you to the appropriate telephone number for ordering Spare Parts ONNE 2013 Ransburg All rights reserved ISO 9001 K A Models and specifi2. SERVICE INSTRUCTION Ransburg a Replaces SI 11 01 SERVICE INSTRUCTION 76298 XX LOW VOLTAGE CABLE ASSEMBLY GENERAL INSTRUCTIONS 1 Only to be used with 9040 Cascade and controller 2 When routing cable ensure that no chaffing binding or pulling on the cable will occur Maintain a 3 or greater bend radius Torsion stress should be minimized 3 Considerations should be taken when routing cables next to other cabling and fluid tubing Be cognizant of the placement of such cable near control wires and fluid lines Follow NEC wiring standards where applicable Separation of AC control wiring and fluid tubing is advisable NOTE Reference 9040 Cascade Low Voltage Contol Unit Service Manual CP 97 04 X 4 This cable is used in systems requiring FM APPROVAL therefore no modifications can be made to it Modification will result in voiding the FM APPROVAL rating and void all warranties PIN 3 PIN 1 VACANT PIN 4 PIN 2 CASCADE END PLUG WIRING SEQUENCE NOTE CONTINUITY OF WIRES PIN WIRE AND PINS FROM CASCADE 1 BLACK END TO POWER SUPPLY END s OANT IS TO BE 10 OHMS OR LESS 4 GREEN W YELLOW STRIPE ALIGNMENT FEATURE PIN 6 PIN 5 VACANT PIN7 PIN 4 VACANT VACANT POWER SUPPLY END PLUG WIRING SEQUENCE PIN WIRE 1 BLACK 2 VACANT 3 VACANT
3. cations subject to change without notice Quality Systems a 5 Form SI 11 01 1 QZ Litho in U S A
Download Pdf Manuals
Related Search