GQ/GU Patrol Superflex Radius Arms
Contents
1. side of the radius arms as per figure 2 NOTE Check ABS sensor lines are free to move through the full range of travel Figure 2 ABS lines NOTE ABS LINES HOLES DO NOT COME STANDARD AND MUST BE OPTIONED WHEN ORDERING 12 Re fit sway bar if performance series radius arms and tie rod as per vehicle service manual 13 Tighten all the bolts up to recommended torque settings Figure 3 shows plates fitted on passenger side Superior Engineering 499 Uhlmann Rd Burpengary QLD 4505 Australia2. Page 1of2 Superior Engineering s22e2zax ENGINEERING COM AU PREMIUM AXA ACCESSORIES Installation Instructions 499 Uhlmann Rd Part Description Nissan GQ GU Super Flex Radius Burpengary QLD 4505 Arm Australia Part Nos SUPRARM NOTE Read and understand these Installation Instructions before beginning the installation process Retain these installation Instructions for future reference It is recommended this item is installed by a Qualified Person Kit Includes mushroom bushes and steel washer s in QTY DESCRIPTION there correct position then loosely fit the Long Radius Arm Short Radius Arm M16 nut Refer to figure 1 for assembly Superflex Adaptor Plates M14X 100mm Bolt 7 i M14 Nylock Nut p M16 x 100mm Bolts Crush Bar NOTE working on one side at a time can make installation easier Check shock length after fitting item as they may no longer be long enough to suit the suspension travel CAUTION Please ensure all bolts are tightened to correct torque setting Recheck in 500km 5 Then push the front of the arm up into It is Recommended the vehicle be wheel the factory mounting spot on the diff aligned after fitting this item Reuse the OEM M16 x 90mm bolts NOTE that front bolts may not be able to be Figure 1 Mushroom Bush Assembly fitted if so just fit either top or bottom 1 Chock wheels front and rear with vehicle in gear and handbrake on bolt for the moment 2 Remove the tie
3. rod and sway bar as per 6 Remove passenger side factory radius arm vehicle services manual If fitting the off and fit the new short radius arm following road series Superflex Arm the whole sway the same procedure as the driver s side bar assembly will need to be removed including swaybar mounts 7 While supporting the radius arm in place fit the Superflex Adapter Plates either side 3 Place jack under the pinion to hold the of the radius arm The crush bar fits in between the two plates and the supplied M16 x 100mm bolts fits in the front diff in position 4 Remove the factory radius arm on the 8 The other supplied M16 x100mm bolt is for the top rear passenger hole and the M14 x 100mm bolt fits in the lower rear hole driver s side following the vehicle services manual and replace with the long radius arm Start by fitting the rear of the arm in to the factory mounting spot on the chassis making sure to have the Superior Engineering 499 Uhlmann Rd Burpengary QLD 4505 Australia Page 2 of 2 WARNING 9 Move the pinion up or down to fit the last Caution should always be taken when working around brake and ABS lines as failure can cause injury or death bolts in place 10 Place the driver s side last bolt in place if necessary 14 It is recommended that the vehicle recive a wheel alignment after fitting of this 11 If your vehicle in equipped with ABS bolt product the OE ABS bracket to the top
Download Pdf Manuals
Related Search