998731 GP-A-RFKT Manual
Contents
1. for which it was designed and manufactured 8 Any use of the product where installation instructions and or instructions for use were not followed 9 Products connected to voltage other than indicated on nameplate 10 Products where the pump was exposed to any of the following sand gravel cement grease plaster mud tar hydrocarbons hydrocarbon derivatives oil gasoline solvents etc or other abrasive or corrosive substances 11 Products in which the pump has been used for pumping of liquids above 140 F 12 Products in which the pump was allowed to operate dry fluid supply cut off 13 Products in which the sealed motor housing has been opened or the product has been otherwise dismantled by customer 14 Products in which the cord has been cut to a length of less than three feet The Company reserves the right at any time and from time to time to make changes in the design and or improvements upon its product without thereby imposing any obligation upon itself to make corresponding changes or improvements in or upon its products already manufactured and or previously sold The Company further reserves the right to substitute parts or components of substantially equal quality in any warranty service required by operation of this Limited Warranty This written Limited Warranty is the entire warranty authorized and offered by the Company There are no warranties or representations beyond those expressed in this docu2. proper capacity A separate branch circuit is recommended sized according to the National Electric Code for the current shown on the pump nameplate and literature WARNING The GP A RFKT has a full load amp FLA rating of 13 9 This product must be installed according to National Electric Code NEC guidelines It is the responsibility of the installer to ensure that the existing wiring and circuit breakers are adequate to meet these guidelines WARNING Electrical wiring and enclosures must be in accordance with the National Electric Code and any other applicable state and electrical requirements Before servicing a pump always shut off the main power breaker making sure you are wearing insulated protective sole shoes and not standing in water Under flooded conditions contact your local electrical company or a qualified licensed electrician to disconnect electrical service before removing the pump Refer to the original installation service manual for any precautions that need to be followed For example the pump could have more than one power source or connection Remove electrical power to the panel and pump 2 Check the existing electrical panel to ensure that breakers and wire gauges meet or exceed National Electric Code NEC guidelines 3 If water is present in the basin drain it to the level of the intake using an external pump or vacuum Dispose of all septic in accordance with local state and national codes 4
3. D OR 2 DEFECTS THAT WERE NOT FOUND AT THE TIME OF SALE DUE TO SCIENTIFIC AND TECHNOLOGICAL REASONS This Limited Warranty gives you specific legal rights You may have other rights which vary according to the applicable laws and regulations Where any term of this warranty is prohibited by such laws it shall be null and void but the remainder of this warranty shall remain in full force and effect DISCLAIMER Any oral statements about the product made by the seller the Company the representatives or any other parties do not constitute warranties shall not be relied upon by the user and are not part of the contract for sale Seller s and the Company s only obligation and buyer s only remedy shall be the replacement and or repair by the Company of the product as described above Before using the user shall determine the suitability of the product for his intended use and user assumes all risk and liability whatsoever in connection therewith Franklin Electric Co Inc Oklahoma City OK 73127 www LittleGiantPump com CustomerService Igpc com For Technical Informations call 1 800 701 7894 o One or more of the following patents apply U S Patent No 6 059 208 7 237 736 L I t t e Form No 998731 08 2012 Rev 001 a
4. Disconnect the electrical quick disconnect plug located inside the basin if applicable 5 Remove the bolts securing the existing assembly if applicable 6 Rotate the ball valve lever to the CLOSED position 7 Remove the existing pump assembly from the basin and set it aside 8 Remove the packaging from the kit retaining the assembly pack and instructions 9 Thoroughly read the pump owner s manual to familiarize yourself with its operation 10 Attach the discharge assembly to the discharge pipe protruding through the plate assembly applying PTFE tape to form an adequate seal Position the fitting away from the center of the plate once tightened completely Fig 1 11 Remove the nameplate from the cord and set it aside 12 Apply gasket tape to the bottom perimeter of the plate assembly 13 Use an awl or similar tool to poke through the gasket tape at the bolt holes on the plate assembly perimeter This will allow the bolts to be installed through the cover and into the basin 14 Apply Magic Lube included to the O rings on the discharge assembly to help the component slide into place 15 Use the rope to lift the kit into the basin and lower it into place 16 Align the tabs on the plate to the slots on the basin 17 Align the discharge fitting to the ball valve on the basin and lower in completely The assembly should rest on the plate with the discharge fitting nesting into the existing ball valve fitti
5. Littie GIANT Franklin Electric Co Inc Oklahoma City OK 73127 www LittleGiantPump com CustomerService Igpc com INTRODUCTION This instruction sheet provides you with the information required to safely own and operate your Little Giant product Retain these instructions for future reference RETROFIT KIT GP A RFKT The Little Giant product you have purchased is of the highest quality workmanship and material and has been engineered to give you long and reliable service Little Giant products are carefully tested inspected and packaged to ensure safe delivery and operation Please examine your unit carefully to ensure that no damage occurred during shipment If damage has occurred please contact the place of purchase They will assist you in replacement or repair if required READ THESE INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO INSTALL OPERATE OR SERVICE YOUR LITTLE GIANT PRODUCT KNOW THE PRODUCT S APPLICATION LIMITATIONS AND POTENTIAL HAZARDS PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION FAILURE TO COMPLY WITH THESE INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND OR PROPERTY DAMAGE Due to continuous product improvement programs changes to the product may occur As a result of such programs Little Giant reserves the right to change products without prior written notification INSTALLATION WARNING Make sure the pump electrical supply circuit is equipped with fuses or circuit breakers of
6. allation repair or removal or for any tools supplies or equipment needed to install repair or remove any product lli LIMITATIONS APPLICABLE TO THIS LIMITED WARRANTY THIS WARRANTY DOES NOT APPLY TO ANY OF THE FOLLOWING 1 Brushes impeller or cam on models with brush type motors and or flex vane impellers 2 Any product that is not installed applied maintained and used in accordance with the Company s published instructions applicable codes applicable ordinances and or with generally accepted industry standards 3 Any product that has been subject to misuse misapplication neglect alteration accident abuse tampering acts of God including lightning acts of terrorism acts of war fire improper storage or installation improper use improper maintenance or repair damage or casualty or to an excess of the recommended maximums as set forth in the product instructions 4 Any product that is operated with any accessory equipment component or part not specifically approved by the Company 5 Use of replacement parts not sold by the Company the unauthorized addition of non Company products to other Company products and the unauthorized alteration of Company products 6 Products damaged by normal wear and tear normal maintenance services and the parts used in connection with such service or any other conditions beyond the control of the Company 7 Any product that has been used for purposes other than those
7. e warranty period Any distributor sub distributor recipient end user and or consumer agrees that by accepting the receipt of the products the distributor sub distributor recipient end user and or consumer expressly agrees to be bound by the terms of the warranty set forth herein I APPLICABLE WARRANTY PERIOD The products accompanied by this warranty shall by covered by this Limited Warranty for a period of 24 months from the date of original purchase by the consumer In the absence of suitable proof of purchase date the warranty period of this product will begin to run on the product s date of manufacture Il INSTRUCTIONS APPLICABLE TO THIS LIMITED WARRANTY 1 Consumers wishing to submit a warranty claim must return the products accompanied by this warranty to the point of purchase for warranty consideration 2 Upon discovery of a defect any personal injury property damage or any other type of resulting damage if applicable shall be reasonably mitigated to the extent possible 3 At its discretion the Company may inspect products either at its facilities or in the field and after determination of a warranty claim will at its option repair or replace defective parts Repaired or replaced parts will be returned freight prepaid by the Company 4 This warranty policy does not cover any labor or shipping charges The Company shall not be liable for any costs or charges attributable to any product testing maintenance inst
8. ment THIS WARRANTY AND REMEDY IS IN LIEU OF ALL OTHER WARRANTIES AND REMEDIES INCLUDING WITHOUT LIMITATION WARRANTIES OF MERCHANTABILITY AND OR FITNESS FOR A PARTICULAR PURPOSE WHICH ARE HEREBY SPECIFICALLY DISCLAIMED AND EXPRESSLY EXCLUDED CORRECTION OF NON CONFORMITIES IN THE MANNER AND FOR THE PERIOD OF TIME AS SET FORTH ABOVE SHALL CONSTITUTE FULFILLMENT OF ALL LIABILITY OF THE COMPANY TO THE PURCHASER WHETHER BASED ON CONTRACT NEGLIGENCE OR OTHERWISE THE COMPANY SHALL NOT BE LIABLE FOR INCIDENTAL CONSEQUENTIAL OR SPECIAL DAMAGES SUCH AS BUT NOT LIMITED TO DAMAGE TO OR LOSS OF OTHER PROPERTY OR EQUIPMENT LOSS OF USE OF EQUIPMENT FACILITIES OR SERVICE LOSS OF PROFIT OR SALES COST OF PURCHASES OR REPLACEMENT GOODS CLAIMS OF CUSTOMERS OF THE PURCHASER FAILURE TO WARN AND OR INSTRUCT LOSS OF OTHER PRODUCTS OR COSTS OF ENVIRONMENTAL REMEDIATION OR DIMINUTION IN PROPERTY VALUE THE REMEDIES OF THE PURCHASER SET FORTH HEREIN ARE EXCLUSIVE AND THE LIABILITY OF THE COMPANY SHALL NOT EXCEPT AS EXPRESSLY PROVIDED HEREIN EXCEED THE PRICE OF THE PRODUCTS UPON WHICH SUCH LIABILITY IS BASED DAMAGES AS SET FORTH IN THIS PARAGRAPH SHALL BE REASONABLY MITIGATED TO THE EXTENT POSSIBLE THIS PARAGRAPH SHALL ALSO APPLY TO ALL DAMAGES RESULTING FROM CONDITIONS SET FORTH IN SECTION Ill ABOVE AND 1 DEFECTS IN PRODUCT PROTOTYPES OR REPLACEMENT PART PROTOTYPES THAT HAVE NOT BEEN PUT INTO PRODUCTION CIRCULATED AND SOLD BY THE COMPANY AN
9. ng 18 Connect the 6 pin plug and receptacle and tighten the screws 19 Install the 6 bolts included through the plate and into the basin then tighten them 20 Restore electricity to the panel and pump 21 Fill the basin with water and observe that the pump operates properly If the pump does not operate properly refer to the troubleshooting section of the pump owner s manual 22 Replace the basin lid and lock the unit if applicable 23 Affix the pump nameplate included to the existing control box or panel so that the pump can be identified NOTE TO INSTALLER Please provide this manual and the pump owner s manual to the home owner or the party responsible for maintaining the system PUMP CORDSET POWER ITEM PART NO DESCRIPTION 1 950269 High water alarm float 1 2 940005 1 1 4 cast iron ball check anti siphon valve 1 3 950346 Pump float switch 1 4 520875 GP A231 2 HP high head grinder pump 1 LIMITED WARRANTY THIS WARRANTY SETS FORTH THE COMPANY S SOLE OBLIGATION AND PURCHASER S EXCLUSIVE REMEDY FOR DEFECTIVE PRODUCT Franklin Electric Company Inc and its subsidiaries hereafter the Company warrants that the products accompanied by this warranty are free from defects in materials or workmanship of the Company that exist at the time of sale by the Company and which occur or exist within the applicabl
Download Pdf Manuals
Related Search