Service Bulletin
Contents
1. Skill Level REPAIR WHONDA Service Bulletin 00 006 RAN Applies To 1988 00 Civic ALL May 23 2000 Clunk or Squeak From Rear Suspension Supersedes 00 006 C lunk From Rear Suspension dated March 28 2000 was mislabled under Body SYMPTOM REPAIR PROCEDURE A clunk or squeak from the rear suspension when 1 Remove the rear trailing arm Refer to section 18 of going over rough or bumpy roads the appropriate service manual 2 Mark the trailing arm at the arrow on the bottom of PROBABLE CAUSE the bushing Broken rear trailing arm bushing s CORRECTIVE ACTION Replace the rear trailing arm bushing s PARTS INFORMATION Rear Trailing Arm Bushing P N 52385 SR3 000 H C 4098299 TOOL INFORMATION Hub Driver T N 07965 6920201 H C 2294254 Hub Base T N 07GAF SE00401 H C 2257061 WARRANTY CLAIM INFORMATION In warranty The normal warranty applies Mark the trailing arm here OP Description FRT Template ID 419104 Replace right bushing 0 9 00 006A 419103 Replace left bushing 0 9 00 006B 419102 Replace both bushings 1 8 00 006C Failed Part P N 52385 SR3 000 H C 4098299 Defect Code 042 Contention Code B07 Skill Level Repair Technician Out of warranty Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Service Manager or your Zone Office You must request consideration and get a decision before starting w2. ork 2000 American Honda Motor Co Inc All Rights Reserved ATB 21350 21750 0005 1 of 2 CUSTOMER INFORMATION The information in this bulletin is intended for use only by skilled technicians who have the proper tools equipment and training to correctly and safely maintain your vehicle These procedures should not be attempted by do it yourselfers and you should not assume this bulletin applies to your vehicle or that your vehicle has the condition described To determine whether this information applies contact an authorized Honda automobile dealer 3 Place the arm on a hydraulic press supported by the hub base with the spindle facing up HUB Ce DRIVER O Do ee HUB BASE 4 With the hub driver press the old bushing out of the trailing arm 5 Align the arrow on the new bushing with the mark you made on the trailing arm Align the arrow on the new bushing with the mark on the trailing arm 2 of 2 6 Press the new bushing into the trailing arm until its edge is 10 to 12 mm above the surface of the arm 7 Reinstall the trailing arm Bleed the brake system Refer to section 19 of the service manual 9 Check the wheel alignment and adjust it if necessary Refer to section 18 of the service manual 00 006
Download Pdf Manuals
Related Search