English - Black & Decker Service Technical Home Page
Contents
1. RS SO SO J gt Original instructions Intended use Your BLACK DECKER FSM1605 and FSM1615 steam mop has been designed for sanitising and cleaning sealed hardwood sealed laminate linoleum vinyl ceramic tile stone and marble floors This appliance is intended for indoor household use only Safety Instructions Warning Read all Safety Maintenance Service manual carefully before operating this appliance Read all of this manual carefully before operat ing this appliance Safety of others e This appliance can be used by children aged from 8 years and above and persons with reduced physical sen sory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved e Children shall not play with the appli ance Cleaning and user maintenance shall not be made by children without supervision lf the supply cord is damaged it must be replaced by the manufacturer its service agent or similarly qualified persons in order to avoid a hazard The plug must be removed from the socket outlet before cleaning or main taining the appliance The liquid or steam must not be directed towards equipment contain ing electrical components such as the interior of ovens The appliance shall n2. assembly chapter of the manual for correct fitting of parts and accessories Where can get further information accessories for my steam mop Capacity 7 Ye aso aso ac producing too little Cap mo f PETA Australia Black amp Decker Australia Pty Ltd Tel 03 8720 5100 20 Fletcher Road Mooroolbark Fax 03 9727 5940 Victoria 3138 New Zealand Black amp Decker Tel 64 9 259 1133 5 Te Apunga Place Fax 64 9 259 1122 Mt Wellington Aukland 1060 United Kingdom amp Black amp Decker Tel 01753 511234 Republic Of Ireland 210 Bath Road Fax 01753 512365 www blackanddecker co uk emeaservice sbdinc com Slough Berkshire SL1 3YD 90627244 REV 0 07 2015
3. 6 Caution Always place your steam mop with the handle 4 supported in the upright position when stationary and make sure the steam mop is turned off when not in use Removing a cleaning pad Caution Always wear suitable shoes when changing the cleaning pad on your steam mop Do not wear slippers or open toed footwear Return the handle 4 to the upright position and turn the steam mop OFF Wait until the steam mop cools down approximately 5 minutes Lift the steam mop away from the cleaning pad freeing it from the velcro fastening Caution Always place your steam mop with the handle 4 supported in the upright position when stationary and make sure the steam mop is turned off when not in use Filling the water tank Fig D The water tank on your steam mop is removable for convenient and easy filling Note Fill the water tank with clean tap water Note In areas of hard water the use of de ionised water is recommended Remove the water tank 3 Remove the filter cap by unscrewing in an anti clockwise direction Fill the water tank 3 with water Warning Your water tank has a 350ml capacity Do not over fill the tank Replace the filter cap by screwing in a clockwise direction Re fit the water tank 3 Note Ensure the filter cap is firmly secured Note Do not use chemical cleaners with your steam mop water tank Use Important This unit will kill 99 9 of bacteria and germs when used in accordanc
4. e with the instructions in this manual and with the micro fibre pad fitted and a continuous run time of 90 seconds Switching on and off To switch the appliance on press the ON Off button 1 It takes approximately 15 seconds for the steam mop to heat up Press the steam operation button 2 This will operate the pump and the unit will begin to produce steam To stop steam generation turn the steam operation button 2 to off This will maintain power to the boiler for quicker start up Original instructions gt To switch the appliance off press the ON Off button 1 Caution Never leave the steam mop in one spot on any surface for any period of time Always place the steam mop with the handle 4 supported in the upright position when stationary and make sure the steam mop is turned off when not in use Caution Always empty the steam mop after use Note When first filled or after running dry it can take up to 45 seconds for steam to be produced Hints for optimum use General Caution Never use the steam mop without first attaching a cleaning pad Always vacuum or sweep the floor before using the steam mop The easiest way to use the appliance is to tilt the handle to a 45 angle and clean slowly covering a small area at a time Do not use chemical cleaners with your steam mop To remove stubborn stains from vinyl or linoleum floors you can pre treat with a mild detergent and some water before us
5. ing the steam mop Steam Cleaning Place a cleaning pad 6 on the floor with the velcro loop side facing up Lightly press the steam mop down onto the cleaning pad 6 Connect the steam mop to the mains Press the ON OFF button 1 It takes approximately 15 seconds for the steam mop to heat up Press the steam operate button 2 After a few seconds steam will start to come out of the steam head Note When first filled or after running dry it can take up to 45 seconds for steam to be produced It takes a few seconds for steam to enter the cleaning pad The steam mop will now glide easily over the surface to be sanitized cleaned Push and pull the steam mop slowly across the surface to thoroughly steam clean each section When you have finished using the steam mop return the handle 4 to the upright position making sure that it is supported and turn it OFF Wait until the steam mop cools down approximately five minutes Caution It is important to monitor the water level in the water tank 3 To refill the water tank and continue to sanitize clean stand the mop upright making sure that the handle is supported and turn the steam mop OFF Unplug the unit from the electrical wall outlet remove and refill the water tank 3 gt Original instructions Caution Never leave the steam mop in one spot on any Troubleshooting surface for any period of time Always place the steam mo
6. ot be left unat tended while it is connected to the sup ply mains The appliance is not to be used if it has been dropped if there are visible signs of damage or if it is leaking keep the appliance out of reach of children when it is energized or cooling down Labels on appliance The following pictograms along with the date code are shown on the appliance CAUTION Hot Steam Features On off switch Steam operate button Removable water tank Handle Steam Head Steam Head cleaning pad Bottom cable tidy hook Top cable tidy hook Grip Hanging bracket DTDOONDOAR WD Assembly A Attaching the handle Fig A Slide the bottom end of the handle 4 into the top end of the stem mop body 11 until it clicks into place The arrow on the handle 4 should be aligned with the top of the steam mop body 11 Warning Before attempting any of the following instructions make sure that the appliance is switched off and unplugged and the appliance is cold and does not contain any water Attaching the water tank Fig B Slide the water tank 3 into the steam mop body 11 ensure that the water tank is firmly seated Attaching a cleaning pad Fig C Replacement cleaning pads are available from your BLACK DECKER dealer cat no FSMP20 XJ Place a cleaning pad 6 on the floor with the velcro loop side facing up Lightly press the steam mop down onto the cleaning pad
7. p If your appliance seems not to operate properly follow the with the handle 4 supported in the upright position when instructions below If this does not solve the problem please stationary and make sure the steam mop is turned off when contact your local BLACK DECKER repair agent not in use After use Fig E Problem Step Possible solution Turn the steam mop OFF turn the steam operation fining on mop isnot T 1 wall button 2 to off and then press the ON OFF button 1 socket Wait until the steam mop cools down 2 Check the unit is Unplug the steam mop from the electrical wall outlet Eee Fa ty Empty the water tank 3 Check the fuse in the FE 4 Remove the cleaning pad 6 and wash it ready for next use l The steam mop is not Check the water tank Clip the supply cable around the cable tidy hooks 7 producing steam 3 is full and correctly fitted and 8 NOTE When first filled There is a hanging bracket 10 built into the hand grip 9 ae it which allows your steam mop to be hung from a suitable seconds for steam to hook on the wall Always ensure that your wall hook is be produced capable of supporting the weight of the steam mop safely 5 ee a er the ON position Technical Data The steam mop stops Check step 1 then 2 producing steam then 3 FSM1605 FSM1615 during use Type 1 Type 1 The steam mop stops then 3 producing too little Voltage steam during use Refer to the
Download Pdf Manuals
Related Search