DR020. - MSA World
Contents
1. IMPORTANT Please Fisher amp Paykel read this bulletin and appliances Technical Bulletin pass on to others in your organisation Dryer Creaking Inlet Bearing Noise MARKETS USA only MODELS DEGX1 DGGX1 ACTION If a creaking noise is encountered emitting from the inlet bearing area during operation it could be due to either lack of oil in the bearing or a defect in the housing bearing drum inlet Inlet Bearing Housing Bearing Drum Inlet There is no method to check for lack of oil in the bearing however the bearing housing can be inspected for hairline cracks in the inner surface Either way we would recommend fitting Kit Bearing Inlet part number 479332 Included in the kit are the following components Part Description 479332 KIT BEARING INLET 1 x Drum inlet cap screw 1 x Drum inlet cap 5 x Inlet bearing retainer screws 1 x Thrust washer 1 x Inlet bearing retainer 1 x Inlet drum bearing 1 x Bearing housing a 4 x Shaft Exploded view of inlet bearing kit components 1 x Instruction sheet Fisher amp Paykel Appliances Ltd 78 Springs Road East Tamaki PO Box 58 732 Greenmount NZ New Zealand Auckland New Zealand Ph 09 273 0600 Fax 09 273 0656 AU Australia Fisher amp Paykel Customer Services Pty Ltd ROW International Markets A C N 003 3335 171 19 Enterprise Street Cleveland QLD 4163 USA United States of America amp Canada PO Box 798 Cleveland QLD 4163 Ph 07 3826 9100 F2. ax 07 3826 9164 GB or UK Great Britain amp Ireland Fisher amp Paykel Appliances EU Europe 150 Ubi Avenue 4 Sunlight Building 02 00 Singapore 408825 Ph 6547 0100 Fax 6547 0123 D RO 2 0 Fisher amp Paykel Appliances Inc A 27 Hubble Irvine California CA92618 USA October 2004 Ph 949 790 8900 Fax 949 790 8911 Fisher amp Paykel Appliances Ltd UK Ph 08450 662200 Fax 08450 662201 COPYRIGHT FISHER amp PAYKEL LTD 2004 ASSEMBLY METHOD Step 1 Remove the drum inlet cap by unscrewing with a M5 or 3 16 allen key Step 2 Remove the 5 screws securing the bearing retainer to the drum and remove the retainer Step 3 Lift the drum upwards slightly to take pressure off the bearing then rotate the bearing housing and slide the bearing and the housing off the shaft Step 4 Refit in the reverse manner Ensure that the bearing housing is orientated so that the rivet heads sit in the clearance holes and the thrust washer is in place Lift the drum upwards while sliding the bearing onto the shaft Do not overtighten the screw securing the drum inlet cap Tighten to 10 Newton metres 7 foot pounds Note It is important that all components contained in this kit are fitted with the exception of the shaft This will only need to be replaced if there is any evidence of damage on the surface of the shaft For the shaft replacement procedure refer to the SmartLoad Service Manual part number 517760 L
3. ong Drying Times Radio Frequency Interference MARKETS USA only MODELS DEGX1 DGGX1 ACTION The screw that secures the power module to the base panel see photo below is used by the electronics to provide a ground earth reference If the screw is missing or not tightened sufficiently it can cause either long drying times up to 3 hrs or radio frequency interference It is recommended that this is the first thing to check for either of these problems This is not a safety issue as the ground is only used as a reference rather than an electrical grounding Note When fitting or re tightening the screw be careful not to over tighten it to the point where it can strip the screw only needs to be nipped up DRO20 October 2004 COPYRIGHT FISHER amp PAYKEL LTD 2004
Download Pdf Manuals
Related Search