After `13 TRX420 All (Except `14 FA/FPA)
Contents
1. LS HONDA INSTALLATION INSTRUCTIONS SUB HARNESS Sold separately P N 08Z01 HR3 A20 The Accessory Socket requires the use of the Accessory Sub Harness Roy 2013 Honda Motor Co Ltd All Rights Reserved ACCESSORY SOCKET P N 08U70 HR3 A20 10f6 Application Publication No Issue Date TOOLS AND SUPPLIES REQUIRED Rotary tool w carbide burr Power drill 25 64 inch 10 mm drill bit 1 5 16 inch 33 mm hole saw Tape After 13 TRX420 All Except 14 FA FPA TORQUE CHART Refer to the Service Manual for the torque values of the removed parts The holding nut is to be hand tightened USE AND CARE INFORMATION e Read through instructions completely prior to installation of the accessory socket e Check the accessory mounts frequently and retighten if necessary 08U70 HR3 A20 3 Disconnect the headlight wiring harness from the 1 Using the procedures in the Service Manual remove main wiring harness the right front assembly trim clips e Repeat on the left side 4 Remove the fuel cap the right front assembly bolts 2 Using the procedures in the Service Manual remove e Repeat on the left side PKA 1 ie gt ON pa Y m A A FEN at 2 of 6 5 Remove the front assembly 7 Drill the large hole with a 1 5 16 inch 33 mm hole saw at the indicated mark Drill two 25 64 inch 10 mm holes at the i2. emoved parts THIS PAGE LEFT BLANK INTENTIONALLY lt CUTTING TEMPLATE gt Cut out along the outer black line Oc Ol ATVOS ww0g OV OF SCALE 10 20 30 40 50mm If you print this template from your local computer make sure the printer settings do not scale or shrink the page 6 of 6
3. ndicated marks Drill holes at the indicated marks 8 After drilling the holes use a rotary tool and carbide 6 Cut out the cutting template from page 6 burr to connect the circles by cutting along the dotted From the under side of the front assembly attach line making a window the cutting template with tape Connect the circles by cutting along the dotted line Attach supplied cutting template with tape in this area 3 of 6 9 Install the accessory socket Place the inner socket trim on the inside of the fender Place the outer socket trim on the outside of the fender Insert the accessory socket through both trim pieces and secure it with the socket nut ACCESSORY SOCKET TRIM OUTER ACCESSORY SOCKET ACCESSORY SOCKET NUT ACCESSORY SOCKET TRIM INNER 10 Remove the dummy plug from the Red 4 pin connector and disconnect it from its clip holder Remove the dummy pug 40f6 10 Install the accessory sub harness to the Red 4 pin connector and secure it to the clip holder Secure the sub harness with the provided wire tie as shown EXISTING WIRE TIE PROVIDED WIRE TIE E B m Y El TS 2 N N 2 Se SN AS Me RED 4 PIN CONNECTOR ACCESSORY SUB HARNESS 11 Temporarily reinstall the front fender assembly and connect the accessory socket to the accessory sub harness 2 pin connector Test the accessory socket operation 12 Reinstall the r
Download Pdf Manuals
Related Search