PDF Instructions
Contents
1. Bolt On Fairing kit for Dyna Part 06 033 and 06 035 Fits 2006 and up Dyna models w 49mm legs Thank you for purchasing this Arlen Ness product We believe that our products are the very best available and are engineered to provide a lifetime of use Basic hand tools and a service manual for your year and model motorcycle are all you need to complete this installation IMPORTANT NOTE The 06 035 fairing is designed to be painted Please check fitment before paint ing Under no circumstance will Arlen Ness warranty damaged paint due to improper installation Parts 1 Fairing body 1 Windshield 1 Headlight mount 2 Fairing bracket 2 Fork clamp 2 Zip ties 8 Windshield mounting bolt 3 1 4 20x5 8 buttonhead allen chrome 2 1 4 20 nylock nut chrome 2 1 4 lock washer 1 1 4 Flat washer 1 3 8x16x2 1 2 allen chrome 1 3 8 nylock nut chrome 1 Instructions 1 Remove OEM headlight from OEM mount Remove OEM mount from lower tree Install new headlight mount using 3 8x16x2 1 2 allen and 3 8 nylock nut provided Install headlight onto new mount using OEM hardware Pic 1 NOTE It will be necessary to pull extra wire from inside of the frame to allow the headlight to move forward on new mount Aim headlight using procedure outlined in OEM service manual 2 Make a felt pen mark on the outside edge of each fork tube 1 2 inch bellow bottom of top tree 3 Install clamps onto fork tube lining the top of the clamp up wit2. 0
3. h the pen mark NOTE The threaded portion of the clamp should be on the front side of the tube pointing out at 90 Pic 2 Using a zip tie temporarily zip the clamp closed around the fork tube to hold it in place for now Pic 3 4 Install one lock washer and the notched side of one upper fairing bracket onto the threaded portion of clamp with the offset facing out Install the nylock that came with the clamp and snug down do not tighten with bracket facing up Pic 4 5 Install windshield to the inside of fairing body using plastic hardware provided starting at the front middle screw working your way back evenly DO NOT OVER TIGHTEN THE BOLTS WILL BREAK 6 Using one 1 4x20x5 8 buttonhead allen w one 1 4 flat washer attach front of fairing to the bottom of the new headlight mount Pic 5 Center the opening in the fairing around the headlight then snug down the allen Do not tighten yet 7 Align the holes in the upper fairing brackets with the holes in the fairing body Ng and install two 1 4x20x5 8 buttonhead allens one in each side snug down 8 Tighten up all hardware evenly while making sure fairing is aligned and sym 1a ee metrical with the headlight fork legs triple trees etc NOTE The clamps and upper brackets can be moved around to achieve proper alignment Cut Zip Ties and remove after all is tight 6050 Dublin Boulevard Dublin Ca 94568 Technical assistance 925 479 6379 www arlenness com 06033 rev 3 19 1
Download Pdf Manuals
Related Search