2007-2013 KTM Adventure 990 Z-Fi MX Installation
Contents
1. BSE YVes V4 2007 2013 KTM Adventure 990 Z Fi MX Installation Instructions P N F582 WARNING USE ONLY IN RACE OR OTHER CLOSED COURSE APPLICATIONS AND NEVER ON PUBLIC ROADS Parts List Z Fi MX Control Unit Fuel Harness Download Z Fi Mapper Software amp it s Instructions from Website USB Cable Small Cable Tie 7 Velcro Stickers Read through all instructions before beginning installation This is not a replacement for the ECU This document is intended for use by qualified technicians For more specific stock component identifition and location information refer to a factory service manual To create the ideal map s we recommend using the optimal Z AFM self tuning module and eliminate the secondary air valve with the KTM Bazzaz eliminator kit 15330 Fairfield Ranch Rd Unit E Chino Hills CA 91709 Phone 909 597 8300 Fax 909 597 5580 www Bazzaz net B4148 BAZZAZ HARNESS CONNECTOR IDENTIFICATION Injector amp TPS Ground Lug 12V Switched Power gt Nps LG 1 Remove the following components seat upper glove box between the two tanks right and left fair ings Remove right side gas tank and make sure to turn off the petcock on the bottom of the tanks before removing any hoses Then remove left side of gas tank Note this side has the fuel pump in it so make sure you unplug it prior to removing the tank 2 Mount the control unit in the accessory box under the seat and plug main connector into co2. g using map 2
3. ntrol unit photo 1 Photo 1 3 Route the harness out of the accessory box using the access slot on the left side photo 2 5 Connect the 12V switched power on the Bazzaz harness to the white connector in the accessory box photo 4 Photo 4 6 Next connect the Bazzaz CKPS inline with the factory CKPS photo 5 Bazzaz ground lug 8 Remove right side radiator fan Connect the Bazzaz injector and TPS 16 pin gray connector inline with the factory 16 pin grey connector Re install the radiator fan photo 7 R SIS Factory Inj amp TPS Photo 7 9 Unplug factory 02 sensors and install Bazzaz 02 eliminators Make sure you install the 02 ground lug to a good chassis ground photos 8 amp 9 Ground 4 Ground Za lt Photo 8 Photo 9 10 Now that the installation is complete take a moment to secure the Bazzaz harness along its routing path with the supplied cable ties Reinstall the components removed in step one of these instructions The Bazzaz controller is capable of storing two maps These maps can be selected through the use of a map select switch which can be mounted on the handlebar for easy access and can be purchased seper ately Or these maps can be selected by connecting or disconnecting the map select jumper supplied with the kit When the map select jumper is connected the control unit is operating using map 1 When the map select jumper is disconnected the contol unit is operatin
Download Pdf Manuals
Related Search