79128-00 Serial Atomizer Speed Select
Contents
1. Ransburg SERVICE INSTRUCTION SI 03 02 2 SERVICE INSTRUCTION 79128 00 SERIAL ATOMIZER SPEED SELECT KO 1 Il I E zZ ABLE 1 ENABLE 2 1 Jii uy 5 BLE 3 ENABLE 4 ON ORIO SPEED SELECT X1000 EN gt fee m ii CoD lI CD l q e o o o r00 ATOMIZER SELECT SPEED 4 ENTER 3 2 O 1 U 9 BT Dy TUUUT Serial Atomizer Speed Select Assy ACTIVE ERROR Teco Oo 8 Swi Bn u4 o g Ue iz i ite S D D D itr ngngnggan L1 mm ae Qing ATOMIZER Ho SPEED SELECT B Operational Procedure 1 Must be used with Serial Atomizer Module only 2 Must be used in Quarter Rack Motherboards 78145 or 78147 3 No motherboard wiring is required 4 Can run 1 4 Serial Atomizer Modules as stand alone system 5 The bell number 1 refers to the Serial Atom izer with the lowest serial rack address bell number 2 to the next highest etc 6 To command a speed set the Enable switch forthe desired bell to ON setthe Atomizer Select knob to that number e2. ative will direct you to the appropriate telephone number for ordering Spare Parts Form No SI 03 02 2 2013 Ransburg All rights reserved Litho in U S A Models and specifications subject to change without notice 02 13
3. nter a number in Krpm us ing the thumbwheels and then press the Speed Enter button 7 Can be used in conjunction with a Serial Node Adapter communicating on same bus Serial Atomizer takes its speed command from the Serial Speed Select Module only when its Bell Enable switch that bell only is in the Enabled position Otherwise Serial Atomizer receives command from the Serial Node Adapter This feature requires Serial Node Adapter software version 2 21 EPROM 77128 07 and Serial Speed Select software version 0 3 EPROM S10851 01 9 Once a speed has been entered a Se rial Atomizer will run at that speed until the Enable switch is set to OFF If the Enable is set back to ON the bell will run at the previ ously entered speed without an entry by the Speed Enter button If a Serial Node Adapter is used remember that it will supply the speed command when the Enable switch is in the OFF position 10 The zero position of the rotary switch will instruct the Serial Atomizer to display fault status The error codes are in the current Serial Atomizer Service Manual 8 With the Atomizer Select knob in the 0 fully CCW position all Serial Atomizer Modules will display their status number Manufacturing 1910 North Wayne Street Angola Indiana 46703 9100 Telephone 260 665 8800 Fax 260 665 8516 Technical Service Assistance Telephone 800 233 3366 Fax 419 470 2071 Technical Support Represent
Download Pdf Manuals
Related Search