SERVICE INSTRUCTION
Contents
1. SERVICE INSTRUCTION Ransburg ale SERVICE INSTRUCTION HIGH VOLTAGE CONTROLLER START UP REQUIREMENTS Inspector s Initials For Ransburg Technical Service Call 800 233 3366 Before Start Up Site Inspection Control panel installed in a convenient area located in a suitable environment See manual for more details Make sure that the customer s main disconnect that supplies power to the HV Controller is off Verify the incoming power to the disconnect Model Remove fuses at control panel Verify incoming voltage wiring for correct termination point Verify Ethernet I P cable connected Reference www ransburg com Grounding checked to a known earth ground for service manual information Ensure high voltage cable is properly connected and routed Ensure low voltage cable is properly connected and route Ensure all necessary high voltage interlocks are installed Start Up Requirements Turn on the customer s main disconnect that supplies power to the HV Controller Verify correct incoming voltage at the control panel Turn off the customer s main disconnect that supplies power to the HV Controller Re install fuses in the Control Panel Turn on the customer s main disconnect that supplies power to the Voltage Master Turn on the disconnect at the panel Verify DC power supplies for proper voltage output Verify the power at the HV Controller Enable Di Dt or Dv Dt as required Set Di Dt or Dv Dt sensitivity le2. vel Set Local Remote switch to the appropriate position Set kV Set to a low level 20 kV Set uA Set to a low level 20 uA Ensure the area around the applicator being charged is clear of personnel and any ungrounded containers Ensure the applicator is a minimum of 10 from the nearest grounded object Turn on HV and record the actual kV and uA If no faults repeat at 50 kV and 50 uA Record the actual kV and uA If no faults repeat at 100 kV and 100 UA Record the actual kV and uA Set to the desired production kV and uA set points Perform overload safety validation verification NOTE Additional information regarding applicator and or its capability can be found in the corresponding service manual For Spare Part Information reference the applicator service manual Always use genuine Ransburg replacement parts to assure maximum uptime with applicator Facility Representative Date Ransburg Representative Date Manufacturing 1910 North Wayne Street Angola Indiana 46703 9100 Telephone 260 665 8800 Fax 260 665 8516 www ransburg com Technical Service Assistance Telephone 800 233 3366 Fax 419 470 2071 Technical Support Representative will direct you to the appropriate telephone number for ordering Spare Parts Form No SI 08 18 1 Litho in U S A 2013 Ransburg All rights reserved ISO 9001 Models and specifications subject to change without notice EK
Download Pdf Manuals
Related Search