Home

TSB 11-145-14R - Subaru Outback Forums

image

Contents

1. 102e Legacy and Outback w 26L NA 22765AE06Fpak 22765AE06F 22765AE06A 8 C D E CVTCAL EA1P102d 22765AE07F pak 22765AE07F 22765AE07A B C D E CVT FED EAIP 1024 PACK FILE APPLICABILITY Page of 3 Step 1 Reprogram the ECM using the applicable pack file from the table above NOTES SOA now highly recommends connecting the Midtronics GR8 Diagnostic Battery Charger to the vehicle and utilizing the Power Supply Mode feature anytime a vehicle control module is being reprogrammed Once the GR8 is connected to the vehicle as long as the battery is fully charged it takes less than 3 minutes to boot up the charger select the Power Supply Mode and have the battery voltage stabilized and ready for reprogramming VERY IMPORTANT This information is applicable to the Midtronics GR8 Diagnostic Battery Charger ONLY It does not apply to any other brand type of generic battery charger whatsoever ONLY the GR8 and its Power Supply Mode feature has been tested and approved by Subaru of America Inc SOA e If the GR8 indicates the vehicle s battery must be charged charge the battery using the GR8 before proceeding to reprogram the vehicle while using the Power Supply Mode e Control module failures as a result of battery discharge during reprogramming are not a matter for warranty Should any DTCs reset after the reprogramming update is performed diagnose per the procedure outlined in the applicable Service Man
2. TSB 11 145 14R Reprogramming File Availability for Oil Level Detection 2013 2014 Legacy and Outback 2 5L Models Availability of reprogramming files and a revised oil level switch to optimize the ECM logic for engine oil level detection in the event of false or premature low engine oil level warning lamp illumination Should a customer present a concern with a low engine oil warning lamp illumination and the diagnosis indicate the oil level is full or nearly full oil level between the full and add marks holes on the dipstick and the customer has not added any engine oil the ECM must be updated with this new logic and the oil level switch replaced The new oil level switch part number supplied in this bulletin must be used If the customer has added oil determine how much was added Based upon the information provided estimate where the oil level was when the lamp illuminated in order to determine if additional action is required beyond what is described in this bulletin such as an oil consumption test The ECM must still be updated with this new logic and the oil level switch replaced The new oil level switch part number supplied in this bulletin must be used PART INFORMATION PARTNUMBER DESCRIPTION 11136AA140 Oil Level Switch PACK FILE APPLICABILITY MODEL NEW ECM PART 22765AE04F pak 22765AE04F 22765AE04A B C D E 6MT CAL EAIP 1020 2013 14MY 55765AE05Fpak 22765AE05F 22765AE05A B C D E 6MTFED EA1P
3. ual Step 2 Always confirm any low oil level lamp false illumination is not a result of a poor electrical connection or grounding concern Inspect the circuit following the diagnosis found in the applicable Service Manual to insure no other related concern exists Step 3 Once the ECM reprogramming has been completed and the oil level switch wiring has been confirmed to be OK proceed with replacing the oil level switch assembly shown in the illustration below following the procedure outlined in the applicable Service Manual Torque the 2 retaining bolts to 6 4 Nm 56 inch pounds Torque the 2 retaining bolts to 6 4 Nm 56 inch pounds Page 2 of 3 Oil Level Switch Step 4 Confirm the engine oil level has been restored to the FULL mark on the dipstick before releasing the vehicle An Approved j2534 Device can be used to reprogram the PCM Subaru reprogramming files using a generic non OEM SAE J2534 pass thru vehicle programming device are available by contacting Service Technical Information Company toll free at 1 866 428 2278 The cost for the CD ROM with all reprogramming files is 75 00 plus S H and applicable state tax Files will be updated four 4 times per year in CD ROM format with all available reprogramming service information at the same above offered cost Authorized Subaru Dealers are provided the same reprogramming information 11 145 14R Page 3 of 3

Download Pdf Manuals

image

Related Search

Related Contents

CV REAL Thomas APEC  FLYPRO PX400 User Manual  CH10 Convector Heater User Manual CH10 Convector Heater User  BM 47 - janv 14  Carrera de Diseño Gráfico y Comunicación Visual  fichetechnique  3200 Linear Imager - Honeywell Scanning and Mobility  FLEX Polyclonal Rabbit Anti-Human CD3 Ready-to  PDFファイル - 医薬品医療機器総合機構  Manuel d`utilisation  

Copyright © All rights reserved.
Failed to retrieve file