SERVICE INSTRUCTION
Contents
1. rates checked Do not exceed 800 cc min minimum flow rate 25 cc min Bell cup checked for tightness on spindle motor shaft 50 70 Ibein 5 65 7 91 Nm Bell cup must be spinning 20 000 RPM minimum before fluid flow check interlocks Test bell cup wash function with bell cup spinning 20 000 RPM minimum Verify paint supply is regulated to applicator max pressure 200 PSI 1379 kPa Verify solvent supply is regulated to applicator max pressure 150 PSI 1035 kPa Test output voltage and output current reference service manual for Specifications Verify PLC Programming Robot Mounted Applicators Only Verify cup wash cycle cleans bell cup properly bell cup must be cleaned periodically Verify robot path is free from collision to painted part and or service grate Applicator Clean up Guidelines When Fixed or Robotic Mounted Use only non polar solvent for clean up of the applicator When cleaning applicator make sure bearing air is on to prevent solvent intrusion into air motor Do not spray down the applicator with solvent Wipe down with wetted towel carefully as required Make sure the rear well of the bell cup is clean from trapped paint to avoid air motor failures NOTE Additional information regarding applicator and or its capability can be found in the corresponding service manual For Spare Part Information reference the applicator service manual Always use genuine Ransburg replacement parts to assure maximum uptime with applicat2. SERVICE INSTRUCTION Ransburg Fuia SERVICE INSTRUCTION RMA MMA SERIES APPLICATOR START UP REQUIREMENTS Inspector s Initials For Ransburg Technical Service Call 800 233 3366 Before Start Up Site Inspection Ransburg air heater installed A11065 XX or A13230 xx reference service manual for proper settings Bell speed limits set min 20 000 RPM max 80 000 RPM Bearing air filters installed RPM 418 3 to 6 Micron Coalescing Filter 19 SCFM Turbine air filters installed RPM 417 3 to 6 Micron Coalescing Filter 136 SCFM Pneumatic and fluid lines connected look for possible kinks especially bearing air Bearing air interlocked with turbine air Reference www ransburg com Turbine air interlocked with paint trigger for service manual information Is fluid flow rate paint and solvent known fluid flow must be regulated 800ml min or less Robotic speed known max speed recommended 250 degrees angular velocity High voltage connections inspected verify connections and wiring Grounding checked to a known earth ground max 1 Mega ohm High voltage interlocked installed on booth door High voltage interlocked with solvent trigger HV locked off when solvent is sprayed Start Up Requirements Bearing air pressure set 90 PSI 5 51 6 90 bar Brake air supply regulated 60 100 PSIG 414 689 kPa Applicator inspected for air and fluid leaks prior to operation Customer s PLC programmed correctly review steps in code Fluid flow
3. or Facility Representative Date Ransburg Representative Date
Download Pdf Manuals
Related Search