Installation and Troubleshooting Guide
Contents
1. H r Installation and Troubleshooting Guide pie Hectronmics All rights reserved Reproduction or use of content in any manner without express written permission by CDI Electronics Inc is prohibited INSTIT CDI P N s 133 0875K1 The 133 0875K1 kit consists of the following items NEAL UTE QTY Part 1 Replacement sensor 1 Sensor gap tool 2 Mounting screws Installation Remove the flywheel per the service manual Disconnect and remove the OEM timer base Remove the outer sensor ring and the old sensor from the timer base Install the new sensor in the original mounting holes using the original screws observing the TOP position eee 5 Set the sensor gap using the enclosed gap tool This gives approximately an 020 air gap from the sensor to the flywheels triggering magnet 6 Route the wires through the timer base and install the outer ring to the timer base 7 Verify that no wires were pinched during the assembly 8 Install the timer base on the engine Make sure the clips are securing it in place and the timer base is mounted correctly The timer base should move freely 9 Install the 553 9702 gap tool on the crankshaft and seat it lightly 10 Set the sensor in place and screw it down allowing it to move 11 Slide the sensor toward the gauge until it touches the gauge 12 Hold the sensor against the 553 9702 gap tool and tighten the screws holding the sensor down 13 Carefully2. Inc is prohibited Rev B e 1 08 13 Page 2 of 2 QF 319
3. remove the 553 9702 gap tool 14 Connect the sensor leads to the power pack 15 Replace the flywheel according to the service manual 16 Set the ignition timing according to the service manual Troubleshooting 1 Check the resistance between the two sensor wires you should read between 16 and 19 ohms 2 Check DVA output you should read over 1 volt between the two wires while the wires are connected to the power pack 3 Check DVA readings from each sensor wire to engine ground while the wires are connected to the power pack The sensor readings should be close to what is read on the stator CDI Electronics 353 James Record Road SW e Huntsville AL 35824 Web Support www cdielectronics com Tech Support 1 866 423 4832 Order Parts 1 800 467 3371 All rights reserved Reproduction or use of content in any manner without express written permission by CDI Electronics Inc is prohibited Rev B e 1 08 13 Page 1 of 2 QF 319 HTT Installation and Troubleshooting Guide LLa Hectronics All rights reserved Reproduction or use of content in any manner without express written permission by CDI Electronics Inc is prohibited T UTE CDI Electronics 353 James Record Road SW e Huntsville AL 35824 Web Support www cdielectronics com Tech Support 1 866 423 4832 e Order Parts 1 800 467 3371 All rights reserved Reproduction or use of content in any manner without express written permission by CDI Electronics
Download Pdf Manuals
Related Search