Extraction Tool for Dynamic 1000 Series
Contents
1. HOUSING LANCE IProcedure 1 Insert tool tip from mating side of the COnnector until it touches and moveSs the housing lance 2 Hold an electric wire in this condition and extract a contact Notes When a case of extracted contact make sure that there no damage on the contact If the contact is damaged DO NOT reuse Contact lance could be released by just Inserting the extraction tool Do not apply excess force when you Dush in the tool into housing Housing lance and or tool may be damaged Do not insert the extraction tool into contact The contact may be damaged and must be replaced with new one This TE controlled document is subject to change For latest revision call local TE representative Rev D1 2 of 22. TE connectivity 1827862 1903129 X 1827869J X 1903130 X 1871057 X 1903131 X Xe71465X X827864X X27579X X 1903127X X1903128 X 3 TIP OF THE TOOL HOUSING LANCE Fig2 1 2 EN Instruction Sheet 411 78241 P N P N X871465X 827864X 827579X X 1903127X X1903128 X 3 Extraction Procedure Extract a contact in the following procedure NS TIP OF THE TOOL sa 7 SSN i
3. TE Instruction Sheet 41 1 8241 connectivity 17 FEB 2014 Rev D1 Extraction Tool for Dynamic 1000 Series Connector 1000 TOOL P N 1891526 1 Fig 1 Extraction Tool 1 1 INITRODUCTION 1000 This Instruction Sheet explains the handling of the RS extraction tool P N1891526 1 used in Dynamic 1000 Series Contact is extracted from a housing 1891526 1 READ THIS MANUAL CARHEFULLY BEFORE OPERATION 2 2 APPLICABLE PRODUCTS X827569X X1908111X X 1 EN eles UN 0 en prefix numDer is 0 zero prefix omitted 2014 Tyco Electronics Japan G K Trademark TE Connectivity Ltd 1 of 2 a TE Connectivity Ltd Company All Rights Reserved TE logo is a trademark Other products logos and company names might be trademarks of their respective OwnerS LOC B
Download Pdf Manuals
Related Search