Home

Troubleshooting

1. Remove the kink in the garden hose Problem Cause Solution Spray wand Broken O ring or Call the Toll Free extension or plastic insert Hotline nozzle leaks The pump is The pump is sucking Check if all hoses noisy air and fittings are airtight Turn the device OFF and purge the pump by pulling the trigger on the spray gun E until a steady flow of water emerges through the nozzle The water filter is Remove the filter clogged and rinse it with warm water Water leaks Loose fittings Check if all fittings from the pump are tight up to 10 drops Water seals are Call the Toll Free perminuteis damaged orworn Hotline permissible Oil is dripping Oil seals are Call the Toll Free damaged or worn Hotline Motor hums but Supply voltage Verify that only the fails to run below minimum pressure washer is running on this circuit System has residual Turn the device OFF pressure pull the trigger on the spray gun to release pressure and then turn the device back ON Voltage loss dueto Unplug any the extension cord extension cords attached and plug the unit directly into the outlet IF YOU ENCOUNTER ANY ADDITIONAL DIFFICULTIES NOT LISTED VISIT OUR WEBSITE AT WWW SIMONIZ CA OR CALL CUSTOMER SERVICE FOR HELP AT 1 866 4SIMONIZ 1 866 474 6664 SIMON 2 TM
2. Disconnect the device from the power source before making any Troubleshooting 1 repairs Problem Cause Solution The motor does The On Off switch is Turn the switch to not start in the OFF position the ON position The power cord is Plug in the power not plugged in cord The extension cord is Replace the too long extension cord with The extension cordis either a 7 6m 25 not the proper gauge 14 2 gauge cord or The extension cord is a 15m 50 14 2 damaged gauge cord The power outlet Try a different does not supply outlet adequate power Tripped pressure Allow the device washer circuit to cool and then breaker restart it The device does The garden hoseis Replace it with notreachhigh too small a 25mm 1 or pressures 13mm 5 8 garden hose Water supply is Check the garden restricted hose for kinks leaks or blockage Not enough water Open water source supply fully The water inlet filter is clogged Remove the filter and rinse it with warm water The pump is sucking air Check if all hoses and fittings are airtight Turn the device OFF and purge the pump by pulling the trigger on the spray gun E until a steady flow of water emerges through the nozzle Problem Cause Solution Output pressure Not enough inlet Turn faucet on fully fluctuates high water supply Check garden hose and low fo
3. r kinks leaks or blockage The pump is sucking Check if all hoses and air fittings are airtight Turn the device OFF and purge the pump by pulling the trigger on the spray gun E until a steady flow of water emerges through the nozzle The water inlet filter Remove the filter is clogged and rinse it with warm water The discharge nozzle Blow out or remove is obstructed debris with a fine needle Calcified gun hose Run distilled or power nozzle vinegar through the detergent container Detergent is not Detergent container Add more detergent working is empty Detergent bottle Check connections or suction tube not properly connected Detergent is too Dilute detergent thick Damaged or clogged Remove obstruction detergent suction or replace the tube detergent suction tube The discharge nozzle Blow out or remove is obstructed debris with a fine needle The garden Loose fittings Tighten fittings hose connection leaks Missing worn Insert new washer rubber washer SIMON 2 TM 2 Troubleshooting Problem Cause Solution Motor hums Residual friction Disconnect water but fails torun among components supply and power continued The device might ON for 2 to 3 hum seconds Repeat this procedure a few times or until the motor starts No water coming Water supply is OFF Turn on the water out of the nozzle supply Kink in the garden hose

Troubleshooting

Contents

Download Pdf Manuals

Related Search

Related Contents