INSTALLATION MANUAL: - Horse Power Ignition
Contents
1. is disconnected from the ground curve 1 is selected When connected through the switch to the ground curve 2 is selected Green optional Powerjet Connect this to the powerjet Will switch to ground at programmed values optional Fasten all the cables to the frame and keep them clear of hot places Please keep in mind the following items the CDl unit must not be exposed to mechanical stress the CDl unit must not be exposed to excessive heat not behind the radiator close to the cylinder or the exhaust the CDl unit must not be exposed to electrical interferences not close to the ht coil the CDl unit must not be directly exposed to fluids water gasoline oil Place the CDl unit so the wiring loom from the pick up can reach the CDl units wiring loom Don t extend or shorten the cables Installing the rotor and the pick up The rotor needs to be placed on an axis which rotates at the same RPM as the engine The pick up needs to be placed at a distance of 0 5mm to 0 6mm from the tooth of the rotor In this case there is a reliable signal transmitted to the CDI Fix the pick up to the engine block Now put the engine in its OT remove spark plug and use a micrometer to make a correct measurement Now place the rotor on the axis and position as it s shown on this drawing Note that the end of the tooth is still 2mm from the center of the pick up Tighten the rotor to the axis in this position 0 9mm O omm left rot2. Horse INSTALLATION MANUAL HPI UNIVERSAL DIGITAL BATTERY IGNITION 12V OSCILLATOR DC AC HPI Kuilenstraat 97 3960 Bree Belgium l n iti on TEL 0032 089 46 74 39 FAX 0032 089 47 33 28 GSM 0032 0495 53 90 21 g Email hpi hpi be Website www hpi be This manual explains how the CDl unit wiring loom rotor pick up and ht coil should be installed on the engine Follow all these steps to ensure the correct functioning of the CDI unit Installing the CDl unit Fix the CDl unit to the frame Connections Black Ground Connect cable to the ground of the bike Red Power Connect cable throught the on off switch to the 12V of the battery Always use this switch to turn off the engine Black with ring Ground Attach the HT coil together with this cable to the frame for mass Orange HT coil Connect cable to the HT coil To minimize electrical interference try to keep this cable clear of other cables and fasten it near to the frame Red white Pick up White blue Pickup Connect this 2 pole connector to the pick up sensor Black white Kill switch Connect to kill switch on bike Needs to be switched to the ground to kill the ignition This doesn t power down the CDl unit so it shouldn t be used to turn off the engine ALWAYS use the on off switch power switch to turn off the engine Yellow optional Curve switch Connect this cable to a switch on off like which connects to the ground When this cable through the switch
3. ating right rotating Programming the CDI unit All our digital CDI units are programmable using the TuneBox software and a USB interface Whit this powerful software tool you are able to design your own ignition curves to obtain maximum performance of your engine You can freely download TuneBox from our website www hpi be To avoid damaging your CDI and engine stop the engine and switch off the power to the CDI during programming of the unit ATTENTION Use resistor spark plug type with resistor spark plug cap
Download Pdf Manuals
Related Search