USER GUIDE - Herbertek
Contents
1. OPTIC ELECTRONIC LTD OP MD3 DIGITAL DISPLAY FOR POTENTIOMETRIC SENSORS OR 0 5V DC INPUT USER GUIDE VER 1 0 OP MD Analog Linear TECHNICAL SPECIFICATION Electrical Specification Supply Voltage 220V 20 50 Hz Power Consumption lt 2VA 50mA Fuse Sensor Supply Voltage 5VDC Sensor Supply Current Max 25mA Without Fuse Physical Specification Dimension 48 x 48 x 100mm Panel Cut Dimension 45 x 45mm Operating Temp 0 60 C Store Temp 10 C 80 C Humidity lt 90RH PROGRAMMING OP MD3 1 TWO POINT CALIBRATION For Lower Calibration Point Press F button continuously until the word CALL appears on the screen Move the sensor to the zero position 1 By using the da and w buttons the value on the screen is set to Zero 2 By using the same buttons a desired value can be fixed When the sensor is at that position Wait 2 second without pressing any button will appear on the screen After this the equipment goes back to operation mode So the Zero position is defined For Upper Calibration Point Press da button continuously until the word CALLH apears on the screen Move the sensor to the maximum position By using the 4 amp and SW buttons the desired value designated as maximum position set to the screen Wait 2 second without pressing any button will appear on the screen After this the equipment goes back to oper2. ation mode So the maximum position is defined 2_ SETTING THE DECIMAL POINT Press d and F buttons at the same time continuously until appears on the Screen By using the ld and F buttons the decimal point is selected Wait 2 second without pressing any button will appear on the screen After this the equipment goes back to operation mode So the position of the point is defined Terazidere Mah 60 Yil Cad No 5 K 3 Bayrampasa ISTANBUL Tel 0212 501 48 63 Fax 0212 501 48 83 e mail opkoninfo opkon com tr www opkon com tr
Download Pdf Manuals
Related Search