Radio user manual.ai
Contents
1. ANCHORLIFT RADIO REMOTE INSTRUCTION IMPORTANT 1 Store this instruction for future use 2 Keep the device away from water 3 The working frequency is 433MHz check your other radio devices to avoid interference 4 Mount the transmitter holder and receiver inside the cabin away from water and sunshine 5 Always store the transmitter in its holder after each use 6 Once the 5 buttons on the transmitter not touched for more than 60 seconds the transmitter is power off by itself Press ON button to start 7 When re programming do not use other remote radio devices avoid any other ultrahigh frequency signal s interference within 50 meter scope OPERATION There are 5 buttons on the transmitter ON start the transmitter red light indicating the working status of the device UP keeping on pressing this button the windlass goes up release the button the windlass stops DOWN make a short press on this button the windlass goes down for approx 40 seconds and stops by itself if you wish to stop the windlass before 40 seconds press this button one more time IN keep on pressing this button the windlass goes up release the button the windlass stops OUT keep on pressing this button the windlass goes down release the button the windlass stops WIRES ON THE RECEIVER 1 black wire hard single core antenna 2 red wire soft power source 12V 24V positive 3 black2. 2 Solenoid g Black 12v Neg To C on solenoid Gray wire to A1 Solenoid Antenna Radio controll box ANCHORLIFT Red Grey wire from main panel 90801 to A2 Solenoid Black wire from main panel 90801 to A2 Solenoid battery Red wire from main panel 90801 12v posetiv 3 Conductor cable 1 5mm 16AWG From main switchpanel 90801
3. wire soft power source 12V 24V negative 4 gray wire soft corresponds with the UP button 5 brown wire soft corresponds with the DOWN button 6 blue wire soft corresponds with the IN button 7 yellow wire soft corresponds with the OUT button RE PROGRAMMING YOUR DEVICE AANCHORLIFT w ww anchoriliftt com Head office Ole Deviksvei 30 0666 Oslo Norway Ph 4722648040 Fax 4722648043 E mail post anchorlift com Usa office 1671 Nw 144th terrace suite 103 Sunrise Florida 33323 USA Ph 954 838 0701 Fax 954 838 0702 E mail sales anchorliftusa com In case you lose your original transmitter please follow the following steps to re program your new transmitter with the receiver 1 Dismount the receiver mounted inside the cabin 2 Unfasten the 2 screws in the back and take away the front panel you can see the green circuit board 3 Connect to 12V 24V power source as usual 4 Press the small black button under the red LED bulb 5 The red LED bulb shines 2 3 times and lights 6 Press any buttons on the transmitter 7 The red LED bulb shines and still lights 8 Press any buttons on the transmitter one more time 9 The red LED bulb shines and shuts off NOTE If windlass goes UP when DOWN is pushed change place on brown and gray wire from radio controll box to solenoid Blue wire output IN Yellow wire output OUT Brown wire to A
Download Pdf Manuals
Related Search