INSTALLATION MANUAL
Contents
1. 27 27 oe ARITERM INSTALLATION MANUAL PXSF For a sustainable future CHIMNEY DRAUGHT FAN PXSF Installation ARITERM Remove the cover by unscrewing the clips see picture Pull a 2 pole cable through the conduit entry 1 and attach it to the connector 2 Refit the cover and fixate the cable so that it cannot touch the fan wheel The fan capacity is adjusted by turning the knob on the voltage regulator at the transtormer which means no me chanical adjustment is needed Attach the chain to the chimney the excess length allowing the fan unit to be lifted out of the chimney without straining the electric cable Adjust the long brackets to fit inside the chimney shaft Fastening is by means of four M6 thread screws Electrical connection CAUTION Make sure the stove or burner 15 dead by unplugging the power cord or unscrewing the fuse before commencing any electrical work Stove Attach the cable from the fan to the connector 47 Attach the black short wire one end to L other end to the power cord connector inside stove beside the brown wire Attach the blue short wire one end to N other end to the power cord connector inside stove Attach the white wire one end to Y1 other end to pole number 7 on the 7 pole connector on the control card in parallel with the existing white wire ARITERM SWEDEN installation Instructions 2007 12 14 2 4 CHIMNEY DRAUGHT FAN P2. XSF Burner e Attach the cable from the fan to the connector 47 e Attach the 230 VAC mains power supply to L and N e Attach the plug 2 to the feeder motor e Attach the plug 3 to the burner left side Attach one of the cords 1 from the cable kit Y1 NOTE if the fan starts when the burner is in OFF position switch to the other wire in cable 1 The fan should start only when the pellet feeder starts Make sure the switches on the time relay are Time relay In position 1 10 minutes maximum o clockwise and C respectively Speed This means the fan will start o regulator when the pellet feeder o starts and it stops 10 minutes after the last pellet feed Transformer 1 FAS SKYDDSTRANSFORMATOR 60 A P21802 V0508 50 60H 1 58 1 28A ta 40 C 44 as ARITERM Circuit diagram Stove pole number 7 on the 7 pole Burner one of the cords 1 from the cable kit gt Transformer Black C Black Blue ARITERM SWEDEN AB Installation Instructions 2007 12 14 3 4 If these instructions followed during installation operation and maintenance the obligations of Ariterm Sweden AB under the warranty regulations are no longer binding Ariterm reserve the right to alter any details and specifications without prior notice ARITERM Ariterm Sweden Flottiljvagen 15 SE 392 41 Kalmar www ariterm se
Download Pdf Manuals
Related Search