SERVICE MANUAL
Contents
1. TRUST SERVICE MANUAL Indoor rollator Let s Go from TrustCare Trustcare Citadellsvagen 23 SE 211 18 Malm Sweden Tel 46 40 15 61 20 info trustcare se www trustcare se TABLE OF CONTENTS Exchange of brake wire Exchange of brake inner part Exchange of handle rubber Exchange of joint cover Exchange of wheel Exchange of front swivel and bearing page 3 page 3 page 4 page 4 page 5 page 5 TRUST 1 Unscrew the two Allen screws at the bottom end of the rear profile i B a i lt w s a i s a Ta t PE 2 Pull out the rear wheel and the brake mechanism 3 Turn it upside to make it easier to loosen the wire from its fixture 4 Remove the spring from the end of the wire 7 Pull out the wire through the slotted hole at the side of the rear profile 10 If the Brake Inner Part is damaged it can also be exchanged Turn it a quarter of a turn and pull it off the bow 5 Unscrew the wire adjustment screw from the brake frame and remove the wire from the frame 8 Unscrew the three parker screws from the brake housing 11 Put the new wire into the Brake Inner Part Put the wire into the rear profile as shown in picture 7 6 5 4 3 2 1 3 6 Take out the white foam tube that lies as noise absorbent around the wire Pig 9 Loosen the wire from the Brake Inner Part at the brake bow The wire can now be exchanged for a new wire 12 Push in the peg into t2. cap 4 Put the new wheel and bearings onto 5 To fix the starlock washer use a mallet 6 Hit the metal tube with the mallet the axle To fix the wheel use anew star and a piece of metal tube 15 16mm not too hard until the washer is firmly in lock washer diameter place and the wheel easily rotating Exchange of front swivel and bearing ST oy 1 Use a wooden stick as protection Hit 2 When the bearing has come out long the top of the swivel bar with a mallet enough it can be pulled out until the bearing comes out 4 Push in the new swivel and bearing into 5 Use the wooden stick as protection 6 Hit the bearing until it is all down to the tube Note left and right are different Hit the bearing from under with the mallet the bottom 5
3. he hole in the handle tube and screw the cover in place Replace all as in picture 7 6 5 4 3 2 1 Exchange of handle rubber 1 To exchange the Handle Rubber first 2 Remove the wires and brake bow from 3 Cut the old rubber all through with a unscrew the brake housing covers on the brake housing both sides Now you sharp knife both sides of the handle tube can pull up the handle from the rollator 4 Pull off the old rubber entirely from the 5 Remove the brake housing from one 6 Put back the brake housing on the handle tube side of the tube Push the new rubber on handle tube and then put the handle Use soap and water to make it slide back into the rollator r 7 Put back the wire into the plastic inner 8 Push in the peg into the hole in the 9 Screw the covers on both sides of the part Then put the inner part with wire handle tube and put the cover in place handle tube tightly with the three parker and brake bow into the brake housing screws Exchange of joint cover Ai Al el 1 To remove the old Joint Cover use a 2 Let the pegs under the new Joint 3 Press the Joint Cover down until it screwdriver Cover fit into the holes in the rear profile snaps in place 4 Exchange of wheel ta 1 To exchange a wheel first unscrew the 2 Break loose the starlock washer with 3 Remove the old wheel and the old Allen screw in the middle of the wheel an awl bearings from the axle cap and remove the
Download Pdf Manuals
Related Search