Grab Air Sample Pump 222-2301 Operating Instructions 40098 PDF
Contents
1. Operating Instructions Grab Air Sample Pump Catalog No 222 2301 SKC Inc 863 Valley View Road Eighty Four PA 15330 Form 40098 Rev 1005 Description The Grab Air Sample Pump is a handheld battery operated sample pump designed to fill bags at 1 L min efficiently and reliably A simple turn on and sample pump Grab Air operates on a disposable 9 volt battery An LED indicates low battery The Grab Air Sample Pump is recommended for sample bags with a capacity up to 10 liters Pump exhaust port for bag sampling Pump inlet port Case screws Remove to access battery On Off switch Low battery LED indicator Case screws Remove to access battery Grab Air Sample Pump Cat No 222 2301 Performance Profile Flow Rate ina Approx 1 L min Operation Time cocinan Approx 1000 liters volume per battery dependent on battery quality Batter ys cnica Disposable 9 volt alkaline Pumping Action nenne Diaphragm Caicara Sturdy lightweight plastic Intrinsic Safety nen Not intended for use in hazardous locations D Protect sample pump from weather when in use outdoors D Failure to follow warnings and cautions voids any warranty Operation 1 Check battery If the low battery LED on the pump is lit insert a fresh 9 volt alkaline battery a Remove four case screws and remove the pump faceplate b Remove the old battery insert the new battery replace the faceplate and secure with case screws2. D Before use allow pump to equilibrate after moving it from one temperature extreme to another 2 Attach PTFE tubing to the exhaust fitting on the top of the pump Attach the free end of the tubing to the inlet valve on the sample bag See bag operating instructions for details on operation of bag fitting s D Protect sample pump from weather when in use outdoors Grab Air bag sampling train 3 Slide the pump s On Off switch to On D Do not operate pump in hazardous locations 4 Sample until the bag is filled properly Properly Filled Bag Improperly Filled Bag 5 Slide the pump s On Off switch to Off 6 Disconnect the tubing close the bag inlet valve identify the sample and send to a laboratory for analysis The pump should be purged after bag sampling To purge the pump run it for several minutes in a clean air environment If the contaminant is hazardous take all necessary safety precautions O Failure to follow warnings and cautions voids any warranty 5 SKC Limited Warranty and Return Policy SKC products are subject to the SKC Limited Warranty and Return Policy which provides SKC s sole liability and the buyer s exclusive remedy To view the complete SKC Limited Warranty and Return Policy go to http www skcinc com warranty asp www skcinc com
Download Pdf Manuals
Related Search