User manual - KG Electronic
Contents
1. Signal to Noise Ratio gt 55 dB Total Harmonic lt 1 Distortion MP3 Link Input 650m V RMS Amplifier Speaker Impedance Speaker Driver 4 ohm 19 EN 9 General information AC DC switching adapter Operation Power Model AS250 050 AE400 Input 100 240 V 50 60 Hz 1 2 A Output 5 V 4 A or Model MSP C4000IC5 0 24M DE Input 100 240V 50 60 Hz 0 6 A Output 5 V 4 A lt 25 VV Consumption Standby Power lt 1W Consumption USB Charging voltage DC5V USB Charging current lt 1000 mA iPod iPhone Charging DC5V voltage iPod iPhone Charging lt 2100 mA current Dimensions Main Unit W x H x D Weight Main Unit 10 EN 225 x 149 x 96 mm 0 83 kg 6 Troubleshooting Warning Never remove the casing of this device To keep the warranty valid never try to repair the system yourself If you encounter problems when using this device check the following points before requesting service If the problem remains unsolved go to www philips com support When you contact Philips make sure that the device is nearby and the model number and serial number are available No power e Make sure that the AC power plug of the unit is connected properly e Make sure that there is power at the AC outlet No sound or poor sound e Adjust the volume of your docking speaker or your iPod iPhone No response from the unit e Disconnect and reconnect the AC p2. turn on or off the bottom light Set time and date format Press TIME DATE repeatedly to display time or date Set time format 1 in standby mode press TIME DATE to selected time format 2 Press and hold TIME DATE for 2 seconds to select the 12 or 24 hour format 3 Press TIME DATE to confirm Set date format 1 in standby mode press TIME DATE to selected date format 2 Press and hold TIME DATE for 2 seconds to select MONTH DAY or DAY MONTH display 3 Press TIME DATE to confirm Update the firmware Adjust volume With the ClockStudioapp on your iPod During play press repeatedly to increase or iPhone iPad you can update the firmware of decrease the volume DS1600 1 Make sure that your iPod iPhone iPad is connected to the Internet 2 Mount the iPod iPhone iPad onto the lightning dock of DS1600 L gt ClockStudio starts to search for available firmware update L gt When the firmware update is available a message is displayed 3 During the firmware updating keep the iPod iPhone iPad powered on and docked on DS1600 Want to upgrade now 1 new firmware update found Cancel Follow onscreen instructions to complete firmware updating Note 5 Product information Note Product information is subject to change without prior notice Specifications Amplifier Max Output Power Frequency Response 2 X 2 5 W RMS 125 16000 Hz 3 dB
3. Always there to help you Register your product and get support at www philips com welcome ff oN Question Contact DS1600 1 2 Philips User manual PHILIPS Contents 1 Important 2 Safety 2 Notice 2 2 Your Docking Speaker 3 Introduction 3 What s in the box 3 Overview of the main unit 4 3 Get started 5 Connect power 5 Turn on 5 4 Play 6 Play audio from iPod iPhone iPad 6 Play through an audio cable 7 Other features 8 Update the firmware 8 5 Product information 9 Specifications El 6 Troubleshooting 10 EN 1 Important Safety Only use attachments accessories specified by the manufacturer Use only power supplies listed in the user manual The product shall not be exposed to dripping or splashing Do not place any sources of danger on the product e g liquid filled objects lighted candles Where the plug of the Direct Plug in Adapter is used as the disconnect device the disconnect device shall remain readily operable IM Warning Never remove the casing of this apparatus Never lubricate any part of this apparatus Never place this apparatus on other electrical equipment Keep this apparatus away from direct sunlight naked flames or heat e Make sure that you always have easy access to the power cord plug or adaptor to disconnect the apparatus from the power Notice Any changes or modifications made to this device that are not expressly
4. approved by WOOX Innovations may void the user s authority to operate the equipment CE This product complies with the radio interference requirements of the European Community 2 EN ae Your product is designed and manufactured with high quality materials and components which can be recycled and reused A When this crossed out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2002 96 EG Please inform yourself about the local separate collection system for electrical and electronic products Please act according to your local rules and do not dispose of your old products with your normal household waste Correct disposal of your old product helps to prevent potential negative consequences for the environment and human health Environmental information All unnecessary packaging has been omitted We have tried to make the packaging easy to separate into three materials cardboard box polystyrene foam buffer and polyethylene bags protective foam sheet Your system consists of materials which can be recycled and reused if disassembled by a specialized company Please observe the local regulations regarding the disposal of packaging materials exhausted batteries and old equipment The making of unauthorized copies of copy protected material including computer programs files broadcasts and sound recordings may be an infringement of copyrights an
5. d constitute a criminal offence This equipment should not be used for such purposes Made for iPod iPhone JiPad Made for iPod Made for iPhone and Made for iPad mean that an electronic accessory has been designed to connect specifically to iPod iPhone or iPad respectively and has been certified by the developer to meet Apple performance standards Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards Please note that the use of this accessory with iPod iPhone or iPad may affect wireless performance iPod and iPhone are trademarks of Apple Inc registered in the U S and other countries iPad is a trademark of Apple Inc Class Il equipment symbol o CLASS ll apparatus with double insulation and no protective earth provided Note The type plate is located on the bottom of the apparatus 2 Your Docking Speaker Congratulations on your purchase and welcome to Philips To fully benefit from the support that Philips offers register your product at www philips com welcome Introduction With DS1600 you can e enjoy audio from your iPod iPhone iPad e enjoy audio from an external audio device e charge any generation of iPod iPhone iPad and external audio devices What s in the box Check and identify the contents of your package e Main unit e 1x AC adapt
6. des to the left Play audio from iPod iPhone iPad You can enjoy audio from iPod iPhone iPad by connecting DS1600 Compatible iPod iPhone iPad The docking system supports the following ead the 7 iPod iPhone iPad iPod iPhone iPad models SE Pod iPhone iPad models with a lightning 1 Connect your iPod iPhone iPad to the connector dock connector e iPod nano 7th generation e iPod touch 5th generation e Phone 5 e Pad mini e iPad 4 iPod iPhone iPad models with a 30 pin connector e iPod classic e iPod touch 2nd 3rd 4th generation e iPod with video e iPod nano 1st 2nd 3rd 4th 5th and 6th generation e iPod with color display iPod mini e iPhone 3G iPhone 3GS iPhone4 cl mi iPhone 4S I e iPad 1 iPad2 new iPad 2 When using DS1600 for the first time a Saichthedeck required software application automatically pops up Switch the dock between the lightning connector and 30 pin connector for different Application Not Installed generation of Apple device This accessory requires an 1 Slide the switch to the right application you do not have L gt The dock swivels and the alternate installed Would you like to install it i from the App store connector is accessible T Se ee 2 Select your desired connector and press No Yes down until a click sound 6 EN 3 Tap Yes yes to accept the installation request 4 Follow the on screen instr
7. or Short user manual Safety and notice EN 3 e Adjust volume Overview of the main unit Toggle switch for lightning 30 pin control 19 Je e Adjust brightness of display and bottom light 30 pin connector Lightning connector TIME DATE e Set time and date AUDIO IN e Audio input connector for connecting an external audio device POWER OUT e USB socket for charging your mobile phone DC IN e AC power connector for the supplied AC power adapter Bottom light Display panel eos e VOO A EN 3 Get started Always follow the instructions in this chapter in sequence Connect power EN Caution Risk of product damage Make sure that the power supply voltage corresponds to the voltage printed on the back of the unit e Risk of electric shock When you unplug the AC adapter always pull the plug from the socket Never pull the cord Connect the AC power adapter to e the power socket at the back of the docking speaker e the wall power outlet shy Turn on In standby mode the docking speaker turns on automatically when it detects an audio signal from docked iPod iPhone Switch to standby mode DS1600 switches to standby mode in the following situations e In dock mode no audio signal from the docked iPod iPhone iPad over 15 minutes e In AUDIO IN mode no audio signal detected over 15 minutes EN 4 Play The f switch sli
8. ower plug EN 11 PHILIPS Specifications are subject to change without notice 2013 WOOxX Innovations Limited All rights reserved This product was brought to the market by WOOX Innovations Limited or one of its affiliates further referred to in this document as WOOX Innovations and is the manufacturer of the product WOOX Innovations is the warrantor in relation to the product with which this booklet was packaged Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N V All rights reserved DS1600_12_UM_V1 0
9. uctions to complete the installation Ly DS1600 synchronizes time and date from the docked iPod iPhone iPad Remove the iPod iPhone iPad To remove the iPod iPhone iPad e Pull your iPod iPhone iPad out of the dock Tip e When placing or removing the iPod iPhone iPad hold the iPod iPhone iPad at the same angle as that of the connector of DS1600 e Before disconnecting the iPod iPhone iPad pause the audio play Listen to the iPod iPhone iPad Note e Make sure that the iPod iPhone iPad is loaded correctly e Start music play in your iPod iPhone iPad L gt You can hear music from DS1600 Charge the iPod iPhone iPad When the docking speaker is connected to power the docked iPod iPhone iPad charges automatically Play through an audio cable Through an MP3 link cable you can also play on DS1600 from an external audio device such as an MP3 player 1 Use an MP3 link cable to connect DS1600 with an external audio device 2 OnDs1 600 do the following e Make sure that you have paused the music on your iPhone iPod docked on DS1600 3 On the external audio device start music play and change the volume Charge your mobile phone Charge your mobile phone through the USB socket in DS1600 with a USB cable not supplied Other features Adjust brightness e Press repeatedly to select different levels of display light e Press and hold to
Download Pdf Manuals
Related Search