Instruction Manual
Contents
1. service personnel only There shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels Regulations concerning the discharge of air have to be fulfilled This appliance if not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person slide for their safety Children should be supervised to ensure that they do not play with the appliance Do not flambe under the range hood The range hood is not intended to be installed over a hob having more than four hob elements Electrical Shock Hazard Only plug this unit into a properly earthed outlet If in doubt seek advice from a suitably qualified professional Failure to follow these instructions can result in death fire or electrical shock INSTALLATION VENT OUTSIDE Prepare for installation lf you have an outlet to the outside your cooker hood can be connected as below picture by means of an extraction duct enamel aluminum flexible pipe or inflammable material with a2. 2 Afresco INSTALLATION AND USER S MANUAL INTRODUCTION SAFETY INFORMATION INSTALLATION VENT OUTSIDE INSTALLATION RECIRCULATION MODE OPERATION MAINTENANCE TROUBLESHOOTING ENVIRONMENTAL PROTECTION COCO N Y gy N gt INTRODUCTION Thank you for choosing this cooker hood This instruction manual is designed to provide you with all required instructions related to the installation use and maintenance of the appliance In order to operate the unit correctly and safety please read this instruction manual carefully before installation and usage The cooker hood use high quality materials and is made with a streamlined design Equipped with large power electric motor and centrifugal fan it also provides strong suction power low noise operation non stick grease filter and easy assembly installation SAFETY INFORMATION Never let the children operate the appliance The cooker hood is for home use only not suitable for grill chicken barbecue roast etc shop and other commercial purpose The cooker hood and its filter should be clean regularly in order to keep in good working condition Clean the cooker hood according to the instruction manual and keep the unit from danger of burning Forbid the direct baking from the gas cooker Please keep the kitchen room a good convection Before connecting this appliance check that the power supply cord is not damaged A damage supply cord must be replaced by qualified
3. accordance with the graphics above Light button MAINTENANCE Before cleaning switch the unit off and disconnect from the power supply Regular Cleaning Use a soft cloth moistened with hand warm mildly soapy water or household cleaning detergent Never use metal pads chemical abrasive material or stiff brush to clean the unit Monthly Cleaning for Grease Filter ESSENTIAL Clean the filter every month can prevent any risk of fire The filter collects grease smoke and dust so the filter is directly affecting the efficiency of the cooker hood If not cleaned the grease residue potential flammable will saturate on the filter Clean it with household cleaning detergent OPTIONAL IF INSTALLED Annual Cleaning for Activated Carbon Filter Apply SOLELY to unit that installed as a recirculation unit not vented to the outside This filter traps odours and must be replaced at least once a year depending on how frequent the cooker hood used REPLACEMENT OF LAMPS To replace a lamp first disconnect the rangehood from the power supply Find where the bulb located in the lamp body Remove the cover and old bulb insert the replacement lamp into the lamp holder replace the lens and lamp cover Change the halogen lights with similar fittings and power max 20W Fig 3 20W TROUBLESHOOTING Fault Cause eon ANI Switch of the unit and repair by fan does not jammed wari The motor is dama
4. ged qualified service personnel only Both light and Halogen light bulb burn Replace the bulb with correct fan do not rating work Power supply looses Plug in to the power supply again The fan blade is Switch of the unit and repair by damaged qualified service personnel only Serious The fan motor is not Switch of the unit and repair by Vibration of fixed tightly qualified service personnel only the unit Take down the unit and check The unit is not hung properly on the bracket whether the bracket is in proper location Suction Too long distance performance between the unit and Readjust the distance to 65 75cm not good the cooking plane ENVIRONMENTAL PROTECTION Waste electrical products should not be disposed of with household waste Please recycle where facilities exist Check with your Local Authority or retailer for recycling advice
5. n interior diameter of 150mm The cooker hood should be placed at a distance of 65 75cm above the cooking plane for best effect Installation 1 Drill 3 x 8mm holes to accommodate the bracket Screw and tighten the bracket onto the wall with the screws provided Rawl plug Screw 4mm x 30mm Wall bracket Cooker hood 3 Fix the one way valve to the air outlet of the cooker hood Then attached the exhaust pipe onto the one way valve as shown below Exhaust pipe Cooker hood 4 Chimney installation For glass model and T shape model By Put the upper chimney into lower chimney Then pulling out the T M al F Ni sign i NAY li Sliding the chimney to adjust the chimney height When the height you required is reached then hang the fixing hole to the fixing screws as showed in below pictures ix NA Upper chimney pa Lower chimney iii Drill 2 x 8mm holes to accommodate the plate Il Screw and tighten the plate 11 onto the wall with 2 screws provided Assembly the chimney onto the unit and fix it with 2 screws Plate Il trrL _ Screw 4mmx8mm Rawl plug De NT For Tower model i By Put the inner chimney into upper chimney Then pulling out the upper chimney upwards Adjust to reach the height required li Fix the lower chimney with 2 pcs of 4
6. x8mm screws Screw Pa ll iii Sliding the chimney to adjust the chimney height When the height you required is reached then fix 2 pcs of 4x8mm screws onto the hole fixing with plate as showed in Kala pictures Plate iv Drill 2 x 8mm holes to accommodate the plate Il Screw and tighten the plate 11 onto the wall with 2 screws provided Assembly the chimney onto the unit and fix it with 2 screws ate ER Ta dnfimm pa oo Ne a LE INSTALLATION RECIRCULATION MODE If you do not have an outlet to the outside exhaust pipe is not required and the installation is similar to the one show in section INSTALLATION VENT OUTSIDE 1N Activated carbon filter can be used to trap odors In order to install the activated carbon filter the grease filter should be detached first Press the lock and pull it downward Plug the activated carbon filter into the unit and turn it in clockwise direction Repeat the same on the other side CLOSE NOTE o Make sure the filter is securely locked Otherwise it would loosen and cause dangerous o When activated carbon filter attached the suction power will be lower OPERATION Push button Electronic Control vO tO O Fan Turn Off button 0 Fan Low Speed button Fan Medium Speed button Y Fan High Speed button 4 Fan can be run at three different speeds depending on the cooking requirements and is controlled in
Download Pdf Manuals
Related Search