USER MANUAL - SIVA Portal
Contents
1. Condizioni di garanzia Speedstar is a product globally guaranteed for 24 months with the exception of batteries that are guaranteed for six months The warranty covers defects in materials or workmanship The warranty doesn t cover parts subject to usury or damaged parts by overload misuse alterations and repairs made by unauthorized third parties The warranty expires in case of tampering improper storage unauthorized or incorrect maintenance MODEL DATE OF CONSTRUCTION a E A E E EE MEN www neatech it 20 USER MANUAL SPEEDSTAR XTREME NEATECH IT Our Mission is transfer technology and solution from the aerospace industry to disability sector We are proud to offer the highest quality products and solution on the market N AI CH 2 L www neatech it2. s needs There is the possibility that the joystick changes depending on desired accessories Dynamic reclining backrest This equipment allows you to recline the backrest with the help of a lever installed on the back Pull the lever X and recline the backrest to the desired inclination so release the lever X Figure 14 Powered reclining backrest With the aid of two electronic pistons user can recline the backrest with the joystick Figure 15 www neatech it 14 5 ACCESSORIES Side pad right left It is an adjustable support thath acts laterally on the chest of the user to keep the desired position It can be mounted either in pairs or individually Figure 16 Adjustable headrest It is a headrest mounted on the back you can adjust either height and inclination With a pin you can also rotate it Figure 17 Seat belt Speedstar Xtreme has the predisposition for the installation of a seat belt that can be mounted on request You can also request heel straps calf straps and foot straps _ nn Tr a a A ES ETS EA www neatech it 15 6 CONTROL AND MAINENANCE Specifications Maximum allowed mass 150 kg Intended use Speedstar Xtreme is intended for all those groups of users that are confined to a sitting position who have the opportunity and the need not only to travel autonomously but even to carry out a true sport activity The wheelchair can t be used as a seat in La s
3. under the seating floor Loosen the 4 screws indicated in Errore L origine riferimento non stata trovata and move the armrest till the desired position tighten the screws again Be sure that the armrest can t move at all NOTE for this operation use a 10 mm open end wrench To adjust armrests width act under the seating floor Loosen the 2 screws indicated in Figure 9 and move the armrest in accordance with the directions indicated to reach the desired position and tighten the screws again NOTE for this operation use a 6 mm allen wrench Figure 9 RE ES www neatech it 11 4 ADJUSTMENTS Joystick Loosen the lever L as shown in Figure 10 so it is possible to move the joystick in depth to reach the desired position Retighten the lever To adjust the angle of the joystick you must act on the screw V Backrest depth Figure 11 Seeing Figure 11 Loosen the screws V move back up to the desired position and retighten the screws NOTE for this operation use a 4 mm allen wrench www neatech it 12 4 ADJUSTMENTS Backrest inclination To adjust the backrest angle it is necessary to remove the insert I and replace it once you get the desired angle as shown in Figure 12 Figure 13 Figure 12 Figure 13 www neatech it 13 5 ACCESSORIES Speedstar Xtreme can be equipped with many accessories that NEATECH make available to meet different customer
4. SPEEDST R USER MANUAL with CE Mark Statement DECLARATION OF CONFORMITY The manufacturer Neatech it 4 A A De Curtis St 80040 Cercola NA Italy under its responsibility states that the wheelchair Speedstar Xtreme satisfies the conditions laid down by European Directive 93 42 according to the criteria for classification of annex IX of this Directive the Speedstar Xtreme is classified as class medical device It also complies with the requirements of the harmonized standards UNI EN 12182 Ausili tecnici per persone disabili UNI EN 12184 Sedie a rotelle a propulsione elettrica motorette e loro sistemi di carica Table of contents WHEELCHAIR PRESENTATION a ai 1 STARTING UP EE 2 USE OFTHE WHEELCHAIR erantsien ee 4 ADJUSTMENTS sirr E A 10 14 MAINTENANCE ais 26 FAULT REPAIR AND ASSISTANCE 18 TIPPING HAZARD Any transport on a slope greater than the maximum security slope can be dangerous ELECTROMAGNETIC RADIATION DANGER The behavior of the wheelchair while driving may be affected by electromagnetic fields such as mobile phones and other devices It is recommended to avoid the use of the wheelchair in the presence of such devices TEMPERATURE The temperature of some surfaces may increase when the chair is exposed to exte
5. e on the frame of each Speedstar Xtreme a a a EEE EE MEN www neatech it 17 7 FAULT REPAIR AND ASSISTANCE POSSIBLE FAULT PROBABLE CAUSE ACTION t button to ON power button is set to OFF A see Figure 2 joystick cable not insert properly joystick properly inserted cable Joystick does not turn l l on electrical fault contact assistance il cavo della joystick E inserire il cavo joystick inserito correttamente guasto all impianto contattare il fornitore elettrico set the lever as shown in Figure 5 the chair doesn t drive set the lever as shown in Figure 5 wheelchair in push mode wheelchair in push mode release lever not properly insert correctly the inserted release lever Wheelchair makes noise mechanical failure contact assistance Wheelchair doesn t have Tires are not set to the Set the tires pressure to a good grip correct value of pressure the correct value end of the life cycle of the contact assistance for the Low nomy of batteries batteries replacement of the batteries A A AA ELE EN www neatech it 18 7 FAULT REPAIR AND ASSISTANCE Spare parts list DESCRIPTION Bearing pair for front forks Specify Speedstar version 66 55 Specify if position light directions light or NOTE For any other problem contact the manufacturer a E A E E EE MEN www neatech it 19 7 FAULT REPAIR AND ASSISTANCE
6. edia non deve essere utilizzata come sedile su motor vehicles Temperatura di utilizzo Temperatura di utilizzo from 10 C to 40 C Class UNI EN 12184 Dimensions mm height Empty weights kg Maximum safe slope Maximum height of the platform from which the 100mm chair can descend safely mm Range km Batteries 2 batteries ZGL 12054 12 V 80Ah TE EEE EEE u Eu www neatech it 16 6 CONTROL AND MAINENANCE Maintenance and cleaning Regular maintenance help to preserve functionality and safety of the Speedstar The lack or inadequacy of care and maintenance implies a limitation of the warranty from the manufacturer To clean the chair don t use any device to spray water at high pressure and in any case protect the control device from water and humidity For plastic or metal parts use a soft cloth moistened with a non aggressive detergent For pads linings and covers of the seat and backrest use warm water and mild detergent Do not use chemical cleaners solvents acids etc Tires can be cleaned with water and detergent OPERATION PERIODICITY Checking tightness of chassis screws Annual For this operation contact your vendor Replacing the batteries Biennial For this operation contact your vendor Tire pressure monitoring Weekly Checking of tire usury Monthly Complete cleaning Monthly Serial number For any report or requests for assistance communicate the unique identification cod
7. ge the batteries when the il display indicates that they are almost discharged Each battery is subject to a normal self discharge so batteries that are not used for long time will discharge by itself Charging time is influenced by multiple factors such as remaining battery power battery state of aging and temperature However the approximate charging time is about 7 9 hours If the charge duration was reduced about 1 hour that is a sign of failure contact the vendor for a possible replacement of batteries Don t use the wheelchair during the charge SHOCK HAZARD Check 1f charger data sheet matches with the network power voltage frequency RELEASE DANGER Any impact to the batteries could cause a loss of fluids Pay attention ENVIRONMENTAL HAZARD lt is recommended to properly recycle used batteries Contact your local agency for waste disposal for more information M A a 2 2 I EI www neatech it 9 4 ADJUSTMENTS Armrest It is possible to make several adjustments on the armrests height width and depth of the aid and position of the joystick Shown operations can be performed on both armrests e Height Seeing Figure 7 loosen the screws A and set armrests height to desired value and retighten the screws A NOTE for this operation use a 6 mm allen wrench a A ZO QA a I EET www neatech it 10 4 ADJUSTMENTS e Profondit To adjust armrests depth act
8. hereafter to ensure that no damage is caused by a careless transport e Make sure the surface of the device is not damaged scratched bended etc e Any fault or damage found must be immediately reported on the shipping documents and promptly communicated to the carrier For any other questions please contact the manufacturer Ifyou dont want to use the Speedstar Xtreme for a long time store it in a safe place fre from dust and moisture Inside the box there is Speedstar Xtreme wheelchair N 1 Charger N 1 pair of armrests Documentation and manuals N 1 joystick PACKAGING DIASPOSAL To properly recycle the packaging materials follow the Te instructions provided by your local waste disposal service www neatech it 2 2 STARTING UP Connection of the Joystick Connect the cable of the joystick as shown in Figure 1 Make sure it is fully engaged If it appears difficult to insert the connector try to invert and reinsert E a Figure 1 Trasporto e immagazzinamento If you don t use the Speedstar Xtreme for a long time make sure you set the switch I OFF You should keep the Speedstar in a place free from dust and moisture and away from heat sources If you must ship the Speedstar Xtreme turn off the switch I unplug the joystick and remove the footrests and armrests Figure 2 www neatech it 3 3 USE OF THE WHEELCHAIR Checks before use For a safe use and to avoid any situat
9. ions of risk to the user before using the product perform the following checks e Checking tire pressure Verify that the tire pressure is consistent with the values given in table e Checking battery charge level Check the battery charge level on the indicator located on the joystick e Check of electric cables Check that the wires don t constitute a hindrance to the movements of the wheelchair _ nn Tr a a A ES ETS EA www neatech it 4 3 USE OF THE WHEELCHAIR Consolle di comando PROFILE On Off button Beeper MODE button MIN speed selector Display LCD a colori PROFILES button MAX speed selector Controller Figure 3 Qo IPP Figure 4 NOTE it is possible that the control console of the Speedstar is different depending on the accessories chosen Main controls remain unchanged A ES ETS AA www neatech it 5 3 USE OF THE WHEELCHAIR Powered mode Set the release engine lever as shown in Figure 5 In this conFiguretion wheels are normally brake Use the switch I see Figure 2 to turn on and turn off the Speedstar Figure 5 Seing Figure 3 and Figure 4 use the button 1 to turn on the command console Use button 4 and 7 to select the travel speed Use the controller 8 to get in gear Its proportional functionality allows you to adjust speed and direction according to the intensity with which you act on the controller By re leasing the lever of the controller automa
10. rnal heat sources as sunlight DISPOSING This product and all its components can not be treates as household waste For more detailed information on how recycling and disposal this product contact your local waste disposal service 1 WHEELCHAIR PRESENTATION Thank you for purchasing the electronic wheelchair Speedstar Xtreme Speedstar Xtreme is designed to be used mainly for competition use The aeronautical technology used to manufacture all Neatech IT products made possible to create rigid and foldable frame highly customizable and reliable Frame and canvas are available in different colors Characteristic e Pair of engines of 350W e Joystick e Mechanical electromagnetic 360mm wheel drive with parking brake increased section e Custom colors e Range of 45 km e Adjustable armrests e Fully charged in 7 ore e Adjustable backrest e Maximum slope 22 e Maximum speed 15 km h WARNING It is prohibited to use wheelchair or its parts for any purpose other than that indicated for a correct use please follow the instructions given in this manual NEATECH IT disclaims any responsibility for damages caused by improper use of aids a a a a a Eu www neatech it 1 2 STARTING UP Checks to be made on delivery Check the integrity of the original packaging e Check for any anomalies on the shipping documents e Check the functionality and integrity of the device in all of its parts at the time of or immediately t
11. tically starts the electromagnetic brake that looks the wheels of the Speedstar Xtreme Use button 3 to navigate between the driving modes set during programming of the console Use button 6 to navigate between profiles set during programming of the console Don t turn on or turn off the console while wheelchair is moving www neatech it 6 3 USE OF THE WHEELCHAIR Push mode If you need to use the push mode use switch I Figure 2 to turn off the Speedstar and set the release engine lever as shown in Figure 6 Figure 6 In the push mode electromechanical brakes are off and therefore use of the Speedstar Xtreme in presence of slopes may be dangerous nn Tr a a A ES ETS EA www neatech it 7 3 USE OF THE WHEELCHAIR Charge of the batteries To recharge the batteries use only the provided charger The manufacturer is not responsible for damage to person or property resulting from the use of non original product Connect the power cord to a power supply 230 V If the led A doesn t turn on check the voltage and the fuse inside the charger Connect the cable to the joystick as shown in figure All led of the charger light up and after a second led C turns off and the charge starts If not check the connections made Battery correctly loaded Unplug the power cord and the battery cable nn Tr a a A ES ETS EA www neatech it 8 3 USE OF THE WHEELCHAIR It is recommend to char
Download Pdf Manuals
Related Search