OIL FILLED RADIATOR OPERATING INSTRUCTIONS
Contents
1. A Do not use the timer function unattended B The heater will not operate if timer is set to the D position and the pins are not Activated according to the times required C If the heater looses its electricity supply e g Switched off at the mains socket or in the even of a power failure the time should be reset after the power on again 4 The pilot light will be on when the timer is set to ON position or the timing function is activated USE OF FAN HEATER lf you want to fasten the speed of heating efficiency when you turn on the unit power you can just push the fan heater switch ON the room temperature will be raised in high speed Push the fan heater switch OFF the fan heater power will be off immediately INSTRUCTIONS FOR USE 1 Before using the heater make sure that it is on a flat and stable surface damage may occur if it is placed on an incline or decline 2 Set all the controls to OFF position and insert the plug into a socket outlet with well grounded Be sure that plug fits firmly 3 Rotate the thermostat knob clockwise to MAX position and switch the heater on as follow the switch for low heat the switch II for medium heat and both switches on for high heat 4 When your room reaches the desired temperature now slowly rotate the thermostat knob counter clockwise until the pilot light goes out The thermostat can now be left at this setting As soon as the room temperature has dropped below the set tem2. UNITED OIL FILLED RADIATOR OPERATING INSTRUCTIONS MODEL NO UHR 811 2500W WARNING READ THIS OWNER S MANUAL CAREFULLY BEFORE USE When using an electrical appliance basic safety precautions should always be observed including the following EE on WARNING To reduce the risk of fire electrical shock or injury to person 1 This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety 2 Children should be supervised to ensure that they do not play with the appliance 3 The product is for household use only 4 Connect the appliance to single phase AC supply of the voltage specified on the rating plate 5 In order to avoid overheating do not cover the heater 6 Never leave the heater unattended while it is in use Always turn the product to the OFF position and unplug it from the electrical outlet when not in use 7 Extreme caution is necessary when any heater is used by or near children invalids or elderly person and whenever the heater is left operating and unattended 8 The heater must not be located immediately below an electrical socket outlet 9 Do not run cord under carpeting and do not cover cord with throw rugs runners or the like Arrange cord away from traffic area and where it w
3. en moving the product 18 Be sure that no other appliances are in use on the same electrical circuit as your product as an overload can occur 19 This heater is filled with a precise quantity of special oil 20 Repair requiring opening of the oil container are only to be made by the manufacturer or his service agent who should be contacted if there is an oil leakage 21 Regulations concerning the disposal of oil when scrapping the appliance have to be followed 22 The heater should not be used in a room of which the floor area is less than 5 M 23 The cord shouldn t be placed nearby the hot surface of the appliance SPECIFICATIONS 1 Thermostat knob 2 Power switch VAAL 3 Cord storage 4 Radiant fins Technical data Model UHR 811 1000W 1500W 2500W ASSEMBLY INSTRUCTIONS The heater is packaged with the feet unattached You must attach them before operating the heater WARNING Do not operate without feet attached Do operate the heater only in upright position feet on the bottom controls on the top any other position could create a hazardous situation 1 Place the radiator body upside down on a scratch free location make sure it is stable and will not fall 2 Screw off the wing nuts from the U shaped bolt provided attach the U shaped bolt to the U facing flange between first and second fins near the front cover 3 To attach the castor mounting plate to the radiator body you should ins
4. ert the threaded ends of the U bolt in the holes on the castor mounting plate 4 Screw the wing nuts back to the U bolt and fasten the wing nut properly Note do not over tighten which may cause the damage of radiator flange 5 Screw off spherical nut from the castor align the shaft to the hole of the castor mounting plate insert in and screw on the spherical nut 6 Repeat 2 3 4 and 5 on the rear of radiator for mounting of the rear castors Note the rear castors must be mounted between the end two fins ZS lly Ui LA C d ie ley er a lt N K x gt wa ee N on L Uv i D NO ff E J NJ e Bi i er lt Pi ULTRE py 2 SS S oS NIN f ___4 wo asd ca Paes 2 a GY aaa ES LM KASS gt i Sh oo gt aN D head SA Mi fe 4 ili MAN USE OF TIMER 1 Regulate the time of timer according to the clock by turn it Clockwise DO NOT TURN IT COUNTER CLOCKWISE 2 The timer has a small swich the function is as follow l Unit is always On Timer function is ON 3 Setthe timer to position There are 96 small plastic pins on the timer each correspond to 15 minutes interval Push ourward the pins corresponding to the time you want the heater to turn ON and push inward the pins corresponding to the time you want the heater to turn OFF CAUTION
5. ill not be tripped over 10 Do not operate the heater with a damaged cord or plug or after the heater malfunctions has been dropped or damaged in any manner 11 If the supply cord is damaged it must be replaced by the manufacturer or its service agent or a similarly qualified person to avoid a hazard 12 Avoid the use of an extension cord as this may overheat and cause a risk of fire 13 Use the heater in a well ventilated area Do not insert or allow objects to enter any ventilation or exhaust opening To prevent a possible fire do not block air intakes or exhaust openings in any manner Do not use on soft surfaces like a bed where openings may become blocked Use the heater on flat dry surfaces only 14 Do not place this heater near flammable materials surfaces or substances as there may be a risk of fire Keep the above flammable materials surfaces or substances at least 1m from the front of the product and keep them away from the sides and rear 15 Do not use the heater in any areas where petrol paint or other flammable liquids are stored e g Garages or workshops as a hot arcing or sparking parts inside the heater 16 Don t use this heater in the immediate surroundings of a bath a shower or a swimming pool Never locate the heater where it may fall into bathtub or other water container 17 This heater is hot when in use To avoid burns and personal injury do not let bare skin touch hot surfaces If provided use handles wh
6. perature the unit will switch it self on automatically until the set temperature has been reached again In this way the room temperature remains constant with the most economical use of electricity 5 If you want to change the room temperature setting rotate the thermostat knob clockwise to raise the temperature or counter clockwise to lower it 6 This heater includes an overheat protection system that shuts off the heater when parts of the heater are getting excessively hot 7 To completely shut the heater off turn all the controls to OFF and remove plug from the socket outlet MAINTENANCE 1 Always remove the plug from the socket outlet and allow the radiator to cool down before clean it 2 Wipe radiator with a soft damp not wet cloth WARNING Do not immerse the heater in water Do not use any cleaning chemicals such as detergents and abrasives Do not allow the interior to get wet as this could create a hazard 3 To store away the heater wind the cable round bobbin and store the heater in a clean dry place 4 In case of malfunction or doubt do not try to repair the radiator yourself it may result in a fire hazard or electric shock CONFORMITY WITH DIRECTIVES This product is CE marked to denote conformity with Directives 2006 95 EC Low Voltage and the EMC directive 2004 108 EC as amended Notice about recycling Your product is designed and manufactured with high quality materials and components which can be
7. recycled and reused This symbol means that electrical and electronic equipment at their end of life should be disposed of separately from your household waste Please dispose of this equipment at your local community waste collection recycling centre In the European Union there are separate collection systems for used electrical and electronic products Please help us to conserve the environment we live in EXCLUSIVE IMPORTER IN GREECE Amiridis Savidis S A 33 Vas Olgas Street P O 54641 Thessaloniki Greece Tel 30 2310 850107 2310 850108 Fax 30 2310 867835 45 Posidonos St O P 18344 Moschato Athens Greece Tel 30 210 9402064 Fax 30 210 9402137
Download Pdf Manuals
Related Search