Agio Boat-shaped Inlaid Glass Table Assembly Instruction
Contents
1. IMPORTANT PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY PARTS LIST DESCRIPTION QTY PCS Step1 Carefully remove glass and set aside until Step 6 Lay Step3 Attach a leg to the leg connector bracket by carefully glass flat do not stand glass on edge Remove all guiding the bolts already in place on the table legs each leg A GLASS TOP 1 protective materials and set parts on a flat non abrasive has two bolts through the holes in the leg connector bracket surface Identify parts packed in carton against the parts Add a washer and a nut to the end of each bolt Hand tighten list If you are missing an parts or are unsure how to 3 4 revolutions only Do not tighten completely Repeat on B TABLE RIM 1 proceed with assembly call our Customer Service Center other three legs at 1 800 416 3511 Do not attempt assembly if any parts are missing or damaged Step4 Attach topside support to leg connector bracket using a LEG CONNECTOR 1 4 x 25mm bolt and a washer as shown in diagram Guide C 1 Step2 Place the table rim without glass upside down on a flat bolt with washer through hole in leg connector bracket into BRACKET non abrasive surface Attach table leg to rim using a the pre drilled hole in the topside support Hand tighten 3 4 1 4 x 20mm bolt and washer as shown in diagram revolutions only Do not tighten completely Repeat for D TABLE LEG 4 Guide bolt through hole in table leg into pre drilled hole opposite topside supp2. ort in the table rim Hand tighten 3 4 revolutions only Do not tighten completely Some adjustments may be necessary to ensure proper alignment of the table legs Repeat for other three legs Attach topside supports with 1 4 x 20mm bolts and washers using same procedure TOPSIDE SUPPORT 2 EF 1 4 X 20MM BOLT 6 21 NUT 8 _ WASHER 16 Step5 After making any necessary adjustments to the alignment of J the table legs and the leg connector bracket use the hex bolt driver and hex wrench to tighten all nuts and bolts Note each bolt must be tightened a few revolutions at a time In K order to apply equal pressure to all bolt joints we recommend working in a cross corner X fashion Repeat until all bolts are tight Do not over tighten Over tightening may HEX WRENCH 1 HEX BOLT DRIVER 1 A gt umm hmmm 1 4 x 25MM BOLT 2 o strip bolts Cover all nuts and bolts with PVC covers L B PVC BOLT COVER 8 Step6 With the help of another person turn the table in the upright position Note the clear bumpers spaced evenly throughout O the inside of the rim Carefully place glass inside the rim M PVC NUT COVER 8 resting on the clear bumpers Your table is now ready for use If you have any questions please call our Customer Service Center at 1 800 416 3511 MODEL 55 40685 22 702 Page 2
Download Pdf Manuals
Related Search