Home
User guide - Steam Cleaner Reviews
Contents
1. Vax Ltd Kingswood Road Hampton Lovett Droitwich Worcestershire WR9 OQH UK email info vax co uk website vax co uk Steam mop steam hard floor master Get cleaning What s your Vax model number Located on the flap of the packaging e g S2 What s your serial number Located on the base of the machine Note these down in case you need them in future Please keep instructions for further use Machine Overview 6 Handle Upper cord clip Lower cord clip Power cord Clean water tank LED indicator a Water heating power on b Steam ready green LED Floor head Steam release trigger Microfibre cleaning pads x 2 dependant on model 10 J Carpet glider Long screw Short screw Measuring jug Hard water filter hidden Pre assembled in unit Washer x 2 Velcro microfibre cleaning pad x 2 dependant on model Accessories General Safety Information This steam mop is intended for household use only and NOT for commercial or industrial use IMPORTANT Please refer to floor manufacturer s care recommendations before use and test the steam mop on a discrete area of flooring to begin with PLEASE KEEP INSTRUCTIONS FOR FURTHER USE When using the steam mop basic safety precautions should always be observed including the following WARNING The stick steam mop head gets very hot during
2. at electrical items or wires Keep hair loose clothing fingers and all parts of the body away from openings Never fill the water tank with anything other than water Never put additives such as perfume stain remover or products containing alcohol in the water as they may damage the steam cleaner or make it dangerous to use Only carry the steam mop by the carry handle Store the steam mop in a cool dry area Do not use an extension cord with this product Using improper voltage may result in damage to the steam cleaner and possible injury to the user The correct voltage is listed on the rating label Do not use your steam mop if it is damaged or faulty Please make sure that the product is unplugged from the mains and call the Vax Careline on 0844 412 8455 Do not use the unit on leather wax polished furniture or floors synthetic fabrics velvet or other delicate steam or water sensitive materials Do not use on acrylic surfaces In wet rooms e g bathrooms connect the appliance to sockets with an RCD adaptor connected in series The device should not be used to clean electrical appliances such as ovens microwaves televisions and electrical heating systems etc 35 Be very careful when cleaning tiled walls with sockets 36 Keep the unit on the floor 37 Empty the water tank when the steam mop is not in use 38 Do not overfill the tank Do not exceed the maximum prescribed filling level
3. without hard water filter in place Your machine is fitted with a hard water filter If you live in an area of hard water the filter will discolour darken over time 2 Depending on water hardness and or frequency of use the filter should be changed every 12 months or once the filter has completely darkened Hard water filter in unit Hard water filter removed New filter Old filter discoloured and darkened Replacing the washers IMPORTANT Allow the unit to cool down fully before performing maintenance or troubleshooting checks Over time the floor head can become loose You may need to replace the washers at the end of the body unit with the replacement washers provided Storage Empty out any remaining water in the tank and clean the external surface with a dry cloth Maintenance Keep your Vax as good as new Clearing blockages IMPORTANT Turn unit off Allow unit to fully cool down before performing maintenance or troubleshooting checks rom this vent you should There is a small opening at the bottom of the trim that goes around the outside of the back of the unit This opening is a steam exhaust vent should the primary path become blocked If steam starts to escape J Steam exhaust vent Remove microfibre pad and inspect unit base for blockages f a blockage can be seen use a small thin object such as a ee SSS KL A
4. 0Hz Wattage 1400W 1600W dependant on model Water tank capacity 500ml Cord length 6m Weight 2 9kg Subject to technical change without notice CE EEC Statement of Compliance Manufacturer EEC importer Vax Limited hereby on our own responsibility declare that the S2 series is manufactured in compliance with the following Directives Safety 2006 95 EC Low Voltage Directive EMC 2004 108 EC Electromagnetic Compatibility Directive Waste electrical products should not be disposed of with household waste Please recycle where facilities exist Check with your Local Authority or retailer for recycling advice
5. Please use the measuring jug and funnel included 39 Always show these instructions to a third party if you are passing the steam mop on to them 40 Please ensure all parts are correctly fitted before using the product 41 Do not attempt to remove blockages with sharp objects as they may cause damage 42 Do not use without the hard water filter in place 43 Take extra care when cleaning on the stairs 44 Keep cleaning area well lit WARNING Always switch off and unplug the steam mop from the electrical outlet before assembling opening or empting the water tank or before connecting disconnecting the attachments IMPORTANT The liquid or steam must not be directed towards equipment containing electrical components such as the interior of ovens IMPORTANT The steam mop is equipped with a thermostat and a thermal cut out If for any reason the unit should overheat the thermostat will automatically turn the unit off Should this occur unplug the steam mop from the electrical outlet and turn off the switch Let the unit cool remove and empty the water tank To re start the machine plug it into an electrical outlet and switch it back on Operation Assembling your steam mop WARNING To reduce the risk of personal injury unp ug the steam mop when assembling Remove clean water tank nsert handle up the screw into main body Line Secure the handle in place with holes on
6. eel unit away Operation Steam cleaning hard floors IMPORTANT Please refer to floor manufacturer s care recommendations before use and test the steam mop on a discrete area of flooring to begin with WARNING Never leave the steam mop in one spot on any surface for an extended period of time with a damp or wet microfibre cleaning pad attached as this may damage the floor surface Your steam mop should only be used on tiles lino sealed wood flooring including sealed laminate WARNING Do not operate use steam mop without water in clean water tank IMPORTANT To reduce the risk of personal injury unplug the steam mop when assembling the accessories ee Plug into mains and wait for the green light on the main body to switch on within 1 min To recline the unit place foot on floor head and tilt handle To produce steam squeeze he trigger in short bursts To prevent overly wetting loors do not hold down continuously IMPORTANT For 1 x 500ml water tank 15 minutes steaming time aprox Refreshing carpets Move the steam mop slowly backwards and forwards across the floor paying particular attention to high traffic areas IMPORTANT When using on carpets always ensure the microfibre cleaning pad is properly attached to the floor Place unit into carpet glider To recline the unit place foot on floor head and tilt handle To produce steam squeeze
7. fter floor head is removed using a thin object such as a paper clip in the area shown attempt to remove the blockage paper clip to try to free blockage If steam path is still blocked remove screw on floorhead neck WARNING To reduce the risk of personal injury unplug the steam mop before performing maintenance or trouble shooting checks Is there an accessory missing e Check the Parts Overview page in the guide to make sure the part is definitely included in your unit e f the part is missing we re here to help Simply call us on 0844 412 8455 The steam mop cleaner has no power Unit may not be plugged into the electrical outlet correctly ensure the plug is pushed in securely The electrical outlet may not be working properly check the fuse or breaker or consult an electrician The power cord may be damaged if it is it must be replaced by the manufacturer or Vax authorised agent in order to avoid invalidating the guarantee When in use if the green light goes off the unit may be re heating The light should only take 1 minute before this comes on again What do do if an accessory the unit has become damaged or broken e Visit vax co uk for parts and spares e Please call our Careline to purchase new spares or order a replacement Why is the steam mop not producing steam e There may be no water in the tank please refer to the operation section The water tank may not be fitted cor
8. he trigger in short bursts To prevent overly wetting carpet do not hold down continuously Move the steam mop slowly backwards and forwards across the floor paying particular attention to high traffic areas Maintenance Keep your Vax as good as new Empty the water tank IMPORTANT Allow the unit to fully cool down before performing any maintenance or troubleshooting checks L Remove the clean water tank Twist the cap slightly Empty any excess water over the anti clockwise to remove sink replace water cap and return o the unit Removing the cleaning pad IMPORTANT Allow the unit to fully cool down before performing any maintenance or troubleshooting checks Microfibre cleaning pad Velcro microfibre cleaning pad dependant on model dependant on model N ri Undo drawstring Remove microfibre cleaning pad Hold corner of pad down with foo and peel unit away Cleaning the microfibre cleaning pad IMPORTANT Never use bleach or fabric softener when washing the microfibre cleaning pad Machine washable at warm temperature max 40 c Always use a mild detergent Allow to fully dry before use Maintenance Keep your Vax as good as new Replacing the hard water filter IMPORTANT The condition of the filter affects the performance of your machine Check and change filter depending on level of use Do not operate unit
9. operation WARNING 4 Danger of scalding 1 Do not leave the steam mop unattended when plugged in Unplug the product from the socket when not in use Only use the steam mop indoors Keep the steam mop away from rain and moisture Turn off the on off switch on the steam mop controls before disconnecting or connecting from the mains supply Always unplug the steam mop and allow it to cool before connecting or disconnecting the hose or accessories Children should be supervised to ensure that they do not play with the appliance his appliance is not intended for use by children under eight years of age and persons with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance in a safe way and understands the hazards involved Cleaning and maintenance shall not be made by children without supervision he appliance should only be used as described in the quick start guide or in the full online user guide Only Vax recommended attachments should be used with this appliance Do not use this steam mop if it has been dropped damaged left outdoors or dropped into water Do not use this steam mop with a damaged cord or plug If the supply cord is damaged return the steam mop to a Vax authorised Service Agent or a suitably qualified erson for examination repair or adjustment Do not pull or carry
10. rectly please refer to the operation section Hard water filter may be clogged and may need to be replaced See maintenance section Steam path may be blocked refer to cleaning blockages section Why won t the microfibre cleaning pad pick up dirt e The cleaning pad may already be saturated with dirt and needs washing please refer to the maintenance section were here if you need us Instead of taking me back to the shop simply visit vax co uk support vaxireland ie or call UK 0844 412 8455 ROI 1 800 928 308 This does not affect your statutory rights Other Information UK Service amp Help Vax Careline UK 0844 412 8455 ROI 1 800 928 308 Monday Friday 8 30am to 6 30pm Saturday 9 00am to 5 00pm Any queries or concerns about using your Vax call the Vax Careline Calls are charged at the UK local rate Please make a note of the serial number and model number of the steam mop before calling For the nearest Service Agent please call the Vax Careline or visit vax co uk Consumables To purchase spares and accessories please visit vax co uk S2 series hard water filter kit Type 1 1 1 130624 00 Microfibre cleaning pads Type 2 1 1 130625 00 Velcro microfibre cleaning pads Type 1 1 1 131448 00 dependant on model Coral cleaning pads Type 3 1 1 131643 00 Guarantee will only be valid with the use of genuine Vax spares and accessories Technical Specification Voltage 220 240 v 5
11. the handle one of the screws provided and the main body Fit the body of the unit onto the Secure the floor head with the floor head lining up the screw remaining screw hole Operation Before you begin cleaning IMPORTANT Do not use hot or boiling water to fill clean water tank Do not overfill the water tank NOTE Always ensure there is water in the clean water tank NOTE Do not over fill L Remove the clean water Twist the cap slightly Fill the tank with max Replace the clean water tank anti clockwise to remove 200ml of water and replace tank clicking into place he water cap Tighten by making sure the hard water wisting clockwise ilter is in place will illuminate when the unit is switched on at the plug and water is heating Within approximately 1 minute the Green LED will also illuminate showing steam mop is ready to use The Green LED will go off when unit water is re heating Attaching the cleaning pad WARNING To reduce the risk of personal injury unplug the steam mop when assembling the accessories IMPORTANT Never use the steam mop without the microfibre cleaning pad correctly attached to the loor head Microfibre cleaning pad Velcro microfibre cleaning pad dependant on model dependant on model Va XN Undo drawstring Remove microfibre cleaning pad Hold corner of pad down with foo and p
12. this appliance by the cord Do not use the cord as a handle close a door on the cord or pull the cord around sharp edges or corners Do not run the steam mop over the cord eep the cord away from heated surfaces Do not unplug the product by pulling on the cord 3 Do not handle the plug or the steam mop with wet hands 4 Do not use without the tank cap in place Ensure that the water tank cap has been screwed down fully before use Do not touch any hot areas on the steam mop It is normal for the steam mop to heat up during operation Accessories will become hot during use allow them to cool down before handling Do not use the steam mop to treat any items of clothing that are still being worn on the body The force and heat of the steam may have an adverse effect on some materials Always check whether a surface is suitable for treatment with the steam by carrying out a test before hand on a concealed area The steam mop must be kept level during operation Never immerse the steam mop in water or in other liquids Do not operate the steam mop without water in the tank Always top up with water in good time Always remove the mains plug from the socket and allow the steam mop to cool down completely before topping up with water Never aim the steam mop at people animals or plants there is a risk of scalding Never touch the steam jet from a short distance with your hands Do not aim the steam mop
Download Pdf Manuals
Related Search
Related Contents
第二部パネルディスカッション 司会) ご - 資源エネルギー庁 "取扱説明書" Hanging Signs/Banners Order Form AT&T 5840 User's Manual Candy CSD69S Quick Start Guide bienvenue - Bio à la une DeLOCK 61881 Copyright © All rights reserved.
Failed to retrieve file