Troubleshooting Guide
Contents
1. Troubleshooting Swordfish Guide A5 amp A4 Paper Trimmers 500s amp 507s Please read the following guide in the unlikely event of any minor problems Broken pressure clamp For replacement clamps please contact Swordfish Customer Service on service swordfishuk com Cutting head jams very easily The cutting head is out of alignment To realign please follow the steps below Cutting head rides up on to the table The cutting head may be out of alignment To realign please follow the steps below If the cutting head is not out alignment then check if there is any other damage to your machine Blade is blunt The rotating circular blade is designed to be self sharpening but it will eventually become blunt with usage Signs of a blunt blade include greater effort required when cutting and a reduced cutting capacity For replacement cutting heads please contact your supplier quoting product code 40909 Realigning amp Changing the Cutting Head Step 1 Remove the end cap by sliding it upwards Fig 1 Step 2 Holding the cutting head pull out the guide rail just until the bar is released from the right hand side and pressure is released from the cutting head Fig 2 Step 3 If the blade is blunt remove the cutting head and slide a new cutting head onto the guide rail ensuring that it is the same way round as the old one Step 4 Align the cutting head ensuring 1 The rubber wheel inside the cutting head sit2. s on top of the plastic pressure clamp 2 The circular rotary blade runs alongside the Fig 3 Fig 4 metal cutting edge and does not sit on the table or plastic pressure clamp Step 5 Once aligned hold the cutting head firmly with one hand and gently slide the guide rail back into the right hand side location Fig 3 Step 6 Replace the end cap Fig 4 For advice and technical support please go to www swordfishsupport com
Download Pdf Manuals
Related Search