User guide - JCB Vacuum Cleaners
Contents
1. 1250W 20L Wet amp Dry Vacuum Cleaner 70130 1250W 201 Wet amp Dry Vacuum Cleaner 70130 Thank you for purchasing this JCB product JCB is a byword around the world for guality innovation and success With the application of stringent design parameters and utilising high performance modern materials and manufacturing processes your JCB product has been developed for optimum functionality and practical application Used for the purposes for which it is intended and with careful maintenance as outlined in this user guide your JCB product will give years of trouble free service IMPORTANT Please read all of the product safety and operating instructions carefully before using this product Please pay particular to all sections of this user guide that carry warning symbols and notices WARNING This is a Warning symbol This symbol is used throughout the user guide whenever there is a risk of personal injury Ensure that these warnings are read and understood at all times CAUTION This is a Caution symbol This symbol is used throughout the user guide whenever there is a risk of damaging your JCB product Ensure that these warnings are read and understood at all times en NOTE Used throughout the user guide to provide additional information hints and tips Our products are continually monitored to comply with changing technical standards and requirements The company reserves the right to alter design and speci2. For wet pick up the foam mesh filter must be fitted Make sure that the appliance is not plugged into the power mains Check to make sure that the tank B is free of dust and dirt Remove the paper dust bag and or the pleated filter Slide the foam mesh filter I over the filter basket Place the motor housing on the tank and close the clamps NOTE If you want to vacuum up a large quantity of liquid from a sink or a tank please don t put the entire suction nozzle in the liquid rather leave a little space so that some air can also be drawn in along with the liquid NOTE The appliance is equipped with a float switch that will stop the vacuuming when the tank is full You will notice that suction has stopped by the motor now running faster In this event switch the appliance off and unplug it Be aware that the full tank can be very heavy In this event remove the motor housing from the tank E and pour the rest of the liquid into a suitable tank or drain Then you can continue vacuuming after you have replaced the motor housing d After wet vacuuming switch off the appliance and unplug it Empty the container and clean dry it inside and outside TOOLS AND ACCESSORIES Hose handle with suction control valve Fit this between the hose and tubes This gives additional length to the tube and allows control of the suction Rotate the valve to open With the valve open the suction to t
3. is jammed by obstruction Check condition of the bag and pleated filter Gently brush clean or replace Replace bag Switch the product off and empty or if the product has been knocked over return the product to upright Check for blockage and remove When picking up a large volume of liquid do not fully immerse the nozzle in the liquid allow some air intake to ensure correct operation of the float valve Check operation of valve ensure foam mesh filter is fitted correctly Replace if necessary ADDRESS If you have any difficulty with your appliance do JCB not hesitate to call us Mexborough We are more likely to be able to help than the south Yorkshire store from where you bought it England 564 Please have the following information ready to enable our staff to deal with your guery guickly Name of the product e Model number as shown on the rear of the appliance e Serial number as shown the rating label UK Helpline and Replacement Parts 0844 871 0961 GUARANTEE It is important to retain the retailer s receipt as proof of purchase Staple your receipt to this back cover for future reference Please guote the following information if the product develops a fault These numbers can be found on the base of the product Model no Serial no All JCB products are individually tested before leaving the factory In the unlikely event of any appliance p
4. fications without prior notice amp E errors and omissions exempted CONTENTS SAFETY INSTRUCTIONS east 4 OVERVIEW OF THE APPLIANCE COMPONENTS 5 ASSEMBLY 5 6 6 6 55 0 66495 4946S e noad TERROR ORDA r ae 6 7 DRY VACUUM 7 8 WEI PICK UR hee boas na an ran 8 TOOLS AND 55 5 8 9 BLOWER FUNCTION tase naa 9 STORAGE 994444 bok eee arog he nat 9 MAINTENANCE 65 095 650 608 69550554 rear 9 TROUBLESHOOTING Rene 10 ADDRESS AND HELPLINE NUMBER 11 GUARANTEE 12 SAFETY INSTRUCTIONS Personal safety WARNING When using this vacuum cleaner basic safety precautions including the following should be followed to reduce the risk of personal injury and material damage Read all of this User Guide before using this vacuum cleaner Never use in the presence of explosive liquid or vapours Never pick up inflammable poisonous liguids such as petrol copier toner or other volatile substances Never pick up acids asbestos asbestos dust Never touch the plug or cable with wet hands Unprofessional repairs can be dangerous for users e The appliance must never be left running unsupervised e This app
5. he nozzle will be reduced making it easier to push For maximum suction have the valve fully closed 2 position wheeled floor nozzle Use this nozzle for dry vacuum cleaning large areas of floor when the particles are small to medium sized Use with the brushes down on hard floors and up on carpets Press the foot pedal to lower or raise the brushes as required Wet pick up large particle nozzle Use this nozzle with the brushes and flexible strip attached for wet vacuum cleaning floors When picking up larger particles the brush and flexible strip section of the nozzle may be removed by pressing the clips at either end of the nozzle Upholstery nozzle This may be used with either wet or dry vacuuming and is intended for smaller areas such as furniture Crevice tool This may be used with either wet or dry vacuuming and is useful for small gaps and when high spot suction is required Anti crush hose Avoid picking up very large particles especially when using the hose without a nozzle as these may become trapped in the hose Three plastic tubes with parking hook 6 The three plastic tubes simply push together Attach the parking hook 4 to the lower tube so that the hose tube assembly can be parked during use The parking hook slots into the U clip on the motor housing The position of the parking hook may be adjusted to suit each nozzle if required BLOWER FUNCTION When using the blower f
6. liance is intended for domestic use only Misuse or use for commercial or any other purpose will render the guarantee invalid e Always disconnect from the main supply after use or prior to emptying cleaning or maintaining the appliance e protect against fire electric shock and personal injury do not immerse cord plug or cleaner in water or other liquid e appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children Children do not understand the dangers associated with operating electrical appliances Never allow children to use this appliance Children should be supervised to ensure that they do not play with the appliance or stumble over the power cord Product safety CAUTION Never use the appliance without a filter being installed CAUTION Never use the AN appliance to vacuum hot ashes large pieces of broken glass or sharp objects Use only JCB approved spare parts and accessories Never modify the cleaner in any way Location Do not use or keep this product outside Do not store the appliance near hot surfaces eg ovens or heating appliances Mains lead Do not allow the mains lead to become strained or run
7. roving to be faulty within 28 days of purchase it should be returned to the place of purchase for it to be replaced If the fault develops after 28 days and within 3 years of original purchase you should contact the Helpline number guoting Model number and Serial number on the product or write to JCB at the address shown You may be asked to return a copy of proof of purchase Subject to the exclusions set out below the faulty appliance will then be repaired or replaced and dispatched usually within 7 working days of receipt If you suspect a fault follow the simple checks detailed below before retrying the appliance or calling the helpline Replace bag Check the tools tubes hose for blockages Check the plug is firmly in the socket e Check the socket is working by trying another appliance e Check the fuse in the plug If for any reason this item is replaced during the 3 year guarantee period the guarantee on the new item will be calculated from the original purchase date Therefore it is vital to retain your original till receipt or invoice to indicate the date of initial purchase To qualify for the 3 year guarantee the appliance must have been used according to the instructions supplied Exclusions JCB shall not be liable to replace or repair the goods under the terms of the guarantee where The fault has been caused or is attributable to accidental use misuse negligent use or
8. the connector NOTE NOTE Opening the bag out a little and bending the creases on the cardboard will ease the fitting Take care not to damage the dust bag DRY VACUUM CLEANING Pleated filter For dry vacuuming when picking up large particles the pleated filter may be used by itself no dust bag is needed After use the filter may be gently brushed or tapped to remove dust The pleated filter cannot be washed and should not be used for wet pick up Check the dust bag regularly and change it when it is 2 3 full If fine dust has been picked up the bag may need to be changed sooner as the pores of the bag may become blocked The dust bag is not reuseable NOTE Don t use the dust for vacuuming up objects with sharp edges or wet objects NOTE Place the motor housing the tank 9 and close the clamps Screw the large end of the hose into the connection for the anti crush hose on the tank Make sure that the ON OFF switch on the appliance is in the Off position position 0 before you plug the power plug into the socket Plug the power plug into the socket Switch the motor on ON OFF switch in position 1 When you have finished vacuuming switch the motor off by putting the ON OFF switch into the OFF position position O Unplug the power plug WET PICK UP NOTE Foam mesh filter NOTE Never vacuum up hazardous materials
9. this appliance over it If the electrical cable becomes damaged the cable assembly must be replaced Do not attempt this task yourself contact the Helpline number that is found on page 11 Electrical requirements Check that the voltage on the rating plate of your appliance corresponds with your house electricity supply which must be A C Alternating Current If the socket outlets in your home are not suitable for the plug supplied with this appliance the plug should be removed and the appropriate one fitted WARNING The plug removed A from the mains lead if severed must be destroyed as a plug with a bared flexible cord is hazardous if engaged into a live socket outlet e Should the fuse in the 13 amp plug require changing 13 amp 51362 fuse must be fitted OVERVIEW OF THE APPLIANCE COMPONENTS erme 2 rennen per cum 5 3xplastictubes I Connection for the anti crush hose p one Honda eae gt Former E aasa A ar formen 55 BLY 6 the tank over so that the motor housing is on the bottom Make sure that the appliance is not 7 the four castors into the holes on plugged in the bottom of the tank Hold the two clamps which hold the motor housing in its position and fold them upwards 8 Firmly push the castors down until they lock into position Loosen the clamps and lift the motor NoTE NOTE Take care not
10. to damage housing up and out EJ the tank by applying excess force M 9 Fasten the rollers with the four remaining screws Tighten the screws finger tight 4 then turn the tank over Slide the handle onto the upper section from the top Make sure that the guide of the handle fastener is inserted on the right side in the handle holder 9 10 Fit the appropriate filter or bag See later sections 11 Replace the motor housing on the tank Fasten the handle to the upper section with the two accompanying screws Tighten the screws finger tight P 12 Hook the clamps into the motor housing The product is supplied with the pleated filter and let them snap into place by pressing fitted To remove eg when using for wet the clamps downwards pick up pull gently K4 3 Screw the large end of the hose onto Paper dust bag the connection on the tank When picking up fine dust we recommend the paper bag should be fitted in addition to the pleated filter This stops the filter clogging and makes disposal of the dust easier Do not use the paper bag for wet pick up Fitting the paper dust bag Slide the paper dust bag over the hose inlet connection in the tank 14 Place the hose handle on the hose by pushing it into place Select a nozzle O or the three plastic tubes and slide it over the suction tube Press it until it locates firmly into place all around
11. unction to collect or clean away debris screw the anti crush hose into the blowing connector 6 Turn the machine on the vacuum cleaner will act as a blower This is useful to quickly clean out dusty areas STORAGE The tools and accessories may be stored on the storage sections at the rear of the product 9 To store attach the parking hook 6 to the U 9 clip on the motor housing then slide the hose end into the parking hook as shown When not in use the cable may be wrapped around the cleats on the rear of the vacuum as shown MAINTENANCE Remove the mains plug before carrying out any maintenance After using for wet pick up empty the container wash the foam mesh filter in clean cool water and leave the container open to fully dry before re assembling With the filter removed regularly check the operation of the float This must be able to move freely to shut off the suction when the maximum quantity of water is picked up TROUBLESHOOTING Possible causes Possible solutions Problem Poor suction Water escapes from the exhaust Dust escapes from exhaust Pleated filter clogged Dust bag clogged Note fine dust may clog the pores of the bag even if it does not appear full Float shut off valve has operated This operates when the maximum quantity of water has been reached but it may also operate if the cleaner is knocked over Blockage in hose tubes or nozzle Float valve
12. used contrary to the manufacturer s recommendations or where the fault has been caused by power surges or damage caused in transit 2 The appliance has been used on a voltage supply other than that stamped on the products 3 Repairs have been attempted by persons other than our service staff or authorised dealer 4 Where the appliance has been used for hire purposes or non domestic use 5 JCB are not liable to carry out any type of servicing work under the guarantee 6 guarantee excludes consumables such as bags and filters e guarantee does not confer any rights other than those expressly set out above and does not cover any claims for consequential loss or damage This guarantee is offered as an additional benefit and does not affect your statutory rights as a consumer jt ME electrical products sold within the European Community At the end ofthe electrical product s useful life it should not be disposed of with household waste Please recycle where facilities exist Check with your Local Authority or retailer for recycling advice in your country This JCB product is intended for household use only JCB has a policy of continuous improvement in product quality and design The company therefore reserves the right to change the specification of its models at any time JCB is used under license VC70130 MUK Rev2 09 10
Download Pdf Manuals
Related Search