Portable Industrial Rapid Power Fan – MB50 Operating Instructions
Contents
1. Portable Industrial Rapid Power Fan MB50 Operating Instructions PLEASE ENSURE YOU HAVE READ AND UNDERSTOOD THESE INSTRUCTIONS FULLY BEFORE ATTEMPTING TO OPERATE THIS PORTABLE INDUSTRIAL FAN General Safety e Never place anything on top of the fan or obstruct its air inlet outlet grills at the front and rear of the fan Leave a 300mm gap all round the unit to let the air circulate e Always switch OFF and unplug the fan when not in use Electrical Safety e This portable fan plugs into either a standard 230v 13amp or 110v power supply depending on model see Dataplate for voltage type The plug 230v models only is fitted with a 13amp fuse e Extension leads should be correctly rated for the inductive load fully unwound loosely coiled and never run through water or over sharp edges e To reduce the risk of electric shock use a suitable RCD residual current devise e Never pull the fan by the flex e Ensure the fan and power socket are both switched OFF before plugging into the power supply MB50 Industrial Rapid Fan Set Up and Operation e Always position the fan on a firm level surface and do not site the fan close to personnel wearing contact lenses sensitive to any dust movement hay fever suffers etc The fan moves air only but minute particles of dust pollen etc will also be moved especially on the highest fan setting So careful location fan angle use of speed control will require consideration e The body of2. the fan is held in position via the side mounted hand wheels To adjust slacken the wheels to allow the fan body to be moved Once the desired angle is reached ensure the hand wheels are turned hand tight to prevent movement e The air flow from the fan exits from the side with the speed controller on it the front the intake side is opposite e Plug the unit into the relevant power supply and switch the supply to ON e Press the red rocker switch on the front of the unit to ON which will illuminate e ALWAYS START THE FAN ON THE HIGHEST SPEED SETTING e The fan blade should immediately start to turn and the speed can be controlled with the knob on the control panel turning CLOCKWISE to increase and ANTI CLOCKWISE to decrease e Do not force the knob past the stop point you will damage the controller Equipment Care and Storage e Never use an air mover except for its intended purpose e Keep the fan unit clean especially the grill faces Blow out the grills with compressed air if clogged up e Never move the unit whilst it is operating e Switch the unit OFF and unplug from its power supply Wrap the cable around the storage ears Troubleshooting Please find below a troubleshooting guide which will help should any operating difficulties be experienced with your Industrial Power fan Always consult this guide before contacting ourselves as the majority of reported problems can easily be solved by using this guide PROBLE
3. M LIKELY CAUSE SOLUTION Unit fails to operate Power Failure Check unit is plugged in to the power supply Check plug fuse 230v ONLY for failure amp correct 13amp rating Check speed controller fuse located at the rear of circuit board 110v models check power supply is suitable for the inductive load Check building ring circuit is not overloaded Poor Airflow 1 Speed control on low setting Turn speed control knob clockwise to increase airflow Blow compressed air through grills to clean Remove obstruction 1 Grills dirty 1 Air inlet grills obstructed London Cool air conditioner and heater rental amp Sales 0800 440 444 This document has been compiled in good faith but no representation is made or warranty given either express or implied as to the completeness or accuracy of this information
Download Pdf Manuals
Related Search