Operating Instructions Geberit AquaClean 8000
Contents
1. again after 30 s Increase the spray intensity Clean or replace the spray nozzle Restore the power supply The spray arm will retract automatically Switch off the shower toilet and contact customer service 15 Operating Instructions Geberit AquaClean 8000 Malfunction Lowering function not working Water is continuously dripping into WC ceramic appliance Water is dripping onto the floor Red LED on control panel flashes 16 Cause Hydraulics are defective Left and right hinges are not closed Flush valve system is leaky There is a leak A safety device has switched off the shower toilet for a short period Fault clearance Contact customer service Close hinges fully Contact customer service Switch off the shower toilet Cut off the water supply and pull out the mains plug If the power outlet and the water supply valve are located inside the casing contact customer service Switch the power switch off and back on again after 30 s MGEBERIT2. Operating Instructions Geberit AquaClean 8000 DANGER A Danger of fatal electric shock gt Never open and repair the device yourself Never replace damaged mains connection cables yourself gt Contact customer service Malfunctions during operation Malfunction Cause No function Mains plug is not connected to power outlet Power switch is OFF Defective fuse on electrical distributor User detection IR window on upper housing section is dirty Software error Power supply is interrupted Shower watertemperature is Heating element is not switched too low on Warm up time too short when heating element is in economy mode Software error Shower spray is too weak or Spray intensity is set too low no wel tat all ro water is Spraying outatal Spray nozzle clogged or blocked with limescale Spray arm does not retract Power supply is interrupted Shower toilet is defective MGEBERIT Fault clearance Connect the mains plug If the power outlet is located inside the casing contact customer service Switch on the power switch Replace the fuse on the electrical distributor Clean the IR window with a soft cloth Switch the power switch off for 30 s and then back on again Have the power supply checked bya skilled person Set the lt water heater function gt to ON on the control panel Set the lt water heater function gt to ON on the control panel Switch the power switch off and back on
Download Pdf Manuals
Related Search