Safety Information and Operating Instructions
Contents
1. MARWOD GROUP LTD Safety Information and Operating Instructions Drinking Water Bowser DWI Approved 1 0 General Information ONLY TO BE USED BY A TRAINED COMPETENT PERSON The main purpose of the bowser is to store fresh and clean water for drinking The tank is elliptical in section it is moulded from PLP 330 A602 Blue Polyethylene Drinking Length Width Height Gross Unladen Pump Hose size Water mm mm mm Weight Weight Fitted Fitted Bowsers kg kg mm 250 2750 1500 1220 1400 260 Patay RPVC1 Gallons DD 25 ID X 1125 70 31 OD Litre 500 3581 1879 1854 2900 600 Patay HDPVC1 Gallons DD 25 ID X 2550 70 33 OD Litre 2 0 Safety Instructions Only a qualified or competent person is authorised to operate the bowser The drinking water bowser is recommended to be used on a flat and stable surface ALWAYS CHECK IF THERE IS NO LEAK OR DAMAGE BEFORE USAGE IN WARM WEATHER THE WATER SHOULD BE CHANGED AT LEAST ONCE A MONTH THE REPLACEMENT OF THE WATER DEPENDS ON THE COMSUPTION OF THE END USERS 3 0 Operation Practice before Usage MO 00 LO OY oe ee a a Park the Drinking Water Bowser on as near as possible to a level surface Slacken off the securing clamp handle on the front support leg Lower the front support leg or telescopic jockey wheel Re tightened the clamp securely Remove the pin from the towing vehicle Disconnect the bowser from the towing veh2. icle Slacken off the rear support leg clamp Lower the rear support leg if fitted Re tightened the clamp securely MG467 0810 Important Note DO NOT OPERATE WITHOUT LOWERING AND LOCKING SECURELY THE REAR SUPPORT LEGS If fitted with 4 0 Opening Instructions for the 250 Gallons 1125 Litre Drinking Water Bowser 1 Open the top hinged lid cover 2 Open the inner black lid by turning the cover anti clockwise approximately 45 degrees and lift open gently 5 0 Opening Instructions for the 500 Gallons 2550 Litre Drinking Water Bowser 1 The 500 gallons contains one filling inlet and one air vent The filling inlet is 3 75 mm inlet 2 Remove the filler and air vent cap and before filling with water 6 0 Filling Instructions of the Drinking Water Bowser Open all drain valves and taps to empty stored water Thoroughly flush out tank with clean fresh water Close all drains valves and taps Fill the tank with clean fresh water gt eh 7 0 Maintenance of the Drinking Water Bowser A competent person examines the drinking water bowser every six months The whole equipment including taps and valves should be checked The Drinking Water Bowser should not be modified or disassembled If there is any concern any defect or damage please contact your nearest Marwood Group Ltd Depot MG467 0810
Download Pdf Manuals
Related Search