Main Features & FIG. 1 USER OPERATING INSTRUCTIONS
Contents
1. PER INTO PAPER FEED SLC THE BOTTOM OF PRINTER MECHANISM AND TUE RUBBER PAPER FEED ROLLER USING THUMB TC PAPER ROUND ROLLER AND OUT OF FRONT OF P THEN PULL TO LEAVE 150 mm APPROX LENGTH PAPER ALTERNATIVELY THE PAPER CAN BE FED THROI WITH THE PRINTER RIBBON FITTED AND WHEN PAPER IS PUSHED INTO THE PAPER FEED SLOT P ING ANY PRINT BUTTON TO TURN ROLLER amp FEI PAPER THROUGH PRINTER MECHANISM REMEMBER TO REFIT THE INK RIBBON IF IT WAS MOVED amp TENSION THE RIBBON USING THE SMA TENSION WHEEL ON THE RIBBON PLASTIC COVE REFIT THE PRINTER COVER AS DESCRIBED IN FIC2. USER OPERATING INSTRUCTIONS PRINTMAN 2 DESCRIPTION There are three buttons on the PRINTMAN key pad and a green power on LED After initial set up the green power LED light will be on indicating the unit is recording Main Features amp FIG 1 TO GAIN ACCESS TO PRINTER RIBBON PAPER ROLL AND RS232 COMMS PORT TURN BLACK LATCH 1 4 TURN ANTI CLOCKWISE USING A COIN lt a Pr gt normally THEN REMOVE PRINTER Fa There is no functional set up required as the unit is factory SAMPLE OF COVER BY LIFTING FROM THE set to operate as follows DELIVERY TICKET BOTTON TO REPLACE COVER LOCATE TICKET PRINTING SLOT AT TOP THEN PUSH SHUT Pressing the keypad buttons operates the printer to print as STORM CONTROLS ATBOTTOM TTN TURNEA TGH VEHICLE PMP02000 1 4 TURN TO SECURE lows DATE 12 08 10 TIME 14 37 ENSURE PAPER IS FED THROUGH SLOT AND IS FREE DELIVERY TICKET TO BE PULLED OUT o CURRENT VALUES Fa GREEN Power on LED gz DELIVERY TICKET The Delivery Ticket shows Company Name and Vehicle identification number if loaded on initial set up then date time and current values of temperature for sensors T1 normally turn air amp T2 normally compartment air A space is provided for the drivers signature before handing tc customer as proof of temperature at delivery Pressing this button starts the printing of a Pressing this button starts the printing of a JOURNEY TICKET The jour
3. ney ticket shows the Company Name and Vehicle Identification number date time and current values of sensors T1 amp T2 similar to the de livery ticket then prints the recorded sensor temperature readings back every 15 minutes or other set sample rate for 24 hours A space is also provided for a signature verifying the results have been checked before the Daily Journey ticket is filed for future reference FIG 2 REMOVE PRINTER RIBBON BY LIFTING OFF The printing can be stopped at any time if only a partial ticket is required To stop the printing function wait until a few Sensor temperature lines have been printed out then Press and hold down the JOURNEY TICKET button until the printing stops Then release the button the printer will start again and print out the Signed line before stopping completely Pressing this button starts the printing of a PRINTALL TICKET The Printall Ticket shows the same information as the Journey Ticket but continues beyond 24 hours and will print all the data stored in memory The Printall Ticket is used if a Journey Ticket is not taken on a journey but a record is still required for greater duration than 24 hours The printing can be stopped at any time if only a partial ticket is required To stop the Printing function wait until a few Sensor temperature lines have been printed SCL 2009 2011 FIT NEW PAPER ROLL IN PAPER BIN WITH PAPER AT THE BOTTOM PUSH FREE END OF PA
Download Pdf Manuals
Related Search