IN1123 Operating Instructions Harmony & Stanford
Contents
1. gt Euroheat Natural Energy Company i E E P ut 2 T E 7 4 3 L 1 Per AT ate P e DUM v pe ie a F Wu 2 ss ETT n s ef d P i Ww z ay d T ga de lg ad GF A AT Jat la r Lim L Hu LL T M fa uo A d EU iv Li ile F we F i Operating In Harmony Stanford T tructions Conventional Flue 6 Balanced Flue Gas Stoves IN1123 Edition G June 2009 PART NUMBER SERIAL NUMBER IMPORTANT READ BEFORE OPERATING THE STOVE Do not operate the stove with its door open or if its glass is damaged Do not operate the stove if the ceramic log effect or coal effect kit is damaged or are not as Illustrated in the installation manual Do not add additional coals or logs to those supplied with the stove No attempt should be made to adjust the appearance of the flame by adjusting the burner or ceramic log effect kit without suitable gas analysis equipment Any change in the appearance of the flame pattern should be reported to your installer Improper installation adjustment alteration service or maintenance can cause injury or property damage This appliance must only be installed and maintained by a suitably qualified Gas Safe heating engineer Ensure this and all other manuals remain with the appliance Do not store or use petrol or other flammable vapours and liquids in the vicinity of this or any other heating appliance This appliance is designed2. On Off Pilot Setting and Ignition Control Main ss Burner Control Vertical orientation Horizontal orientation On first lighting the stove will produce a smell and some smoke from the body of the stove as at the high temperature the paint cures For the paint to cure fully it requires the stove to be run on its maximum setting for a period of about ten hours or until the smell of curing stops This can smell unpleasant and there may be a smoke haze in the room which may activate smoke detectors We recommend that the room be vacated over this period doors to the rest of the property are closed and the windows of the room opened to allow the smell to dissipate Once cured a cast iron stove produces no smell To ensure the stove operates at its maximum setting if fitted with a thermostatic remote control option ensure that the thermostatic control has been disabled Please see the remote controls instruction manual IN1203 for instructions on how to do this or the stove may not run at its maximum output for the required time to cure the stove O Euroheat Distributors H B S Ltd June 2009 Z EG OE Instructions Part Number IN1123 Ed G Mertik Maxitrol Gas Valve Main Burner Control The main burner control will set the output from the burner from maximum to minimum output On Off Pilot Setting and Ignition Control Lighting Ensure that the main burner control knob is in the off position see below Tur
3. occur to adapt documents to customer requirements and appliance changes For the latest editions of all Euroheat documentation visit our web site www euroheat co uk We would request that you inform Euroheat of information which you feel is not provided in this document which would assist other users in the future The Euroheat Technical Team O Euroheat Distributors H B S Ltd June 2009 6 E amp OE Instructions Part Number IN1123 Ed G Need more info with over 10 000 pages of technical information spare parts product shots news and 1001 other things you will not find a more comprehensive solution to your gueries whatever time of the day www euroheat co uk Natural Energy Company Court Farm Business Park Bishops Frome Worcestershire WR6 SAY Pre sales 01885 491112 Technical 01885 491117 Reception 01885 491100
4. ain burner by turning fully clockwise and turn the On Off control clockwise to the pilot position The pilot light can stay alight at all times allowing for quick and easy use of the stove On Off Turn the control knob clockwise to the small flame pilot symbol Main Burner Control Turn the control knob clockwise to its OFF position Turning off the Stove and Pilot Light To turn off the pilot light push the On Off control in and turn clockwise to the OFF position NOTE You will be unable to relight the stove for a period of about 3 minutes after the stove has been extinguished This is a safety feature and not a fault of the stove Euroheat Distributors H B S Ltd June 2009 EG OE Instructions Part Number IN1123 Ed G Cleaning Your Stove The Glass For safety reasons never attempt cleaning the glass when the stove is operating or still hot the stove must be extinguished and allowed to cool The glass in your stove is specially formulated to withstand the very high temperatures generated within the stove and proprietary glass cleaners are not recommended as their compositions may contain chemicals that will weaken or etch into the glass Newspaper moistened with water to which a little vinegar has been added will normally remove most staining DO NOT operate the stove if the glass is cracked or broken A replacement glass and glass seal set can be obtained from your local dealer or by contacting Euroheat Spares Departmen
5. ing will be replaced by a number of loud bangs This is due to differing rates of expansion of the body of the stove when heating and cooling and has no practical significance for the function of the stove and does not constitute a safety risk or a fault in the construction of the stove Q The stove keeps going out for no apparent reason A Contact your suitably qualified Gas Safe engineer as it may be that one of the stoves safety devices is shutting the stove off for safety reasons Q I would like to have the remote control option fitted after the stove has been installed is that possible A Yes the thermostatic remote control can be fitted at a later date Contact your local supplier who will be able to supply and install this for you Q What are the benefits of fitting the thermostatic remote control option A The remote control allows for easier manual operation of the stove as the output can be altered from the comfort of your chair manually using the hand set Or it can be set to adjust the heat output from the stove to maintain the rooms temperature using a thermostat within the hand set so only using the minimum amount of gas to heat the room Euroheat and Nestor Martin have a policy of continual research and development and reserve the right to modify its appliances without prior notice We make every effort to ensure that the information provided in this document is correct and accurate at the time of printing Continued updates
6. n the on off knob smaller control knob towards the ignition position then press in and turn anti clockwise There will be an audible click as the Piezo spark is generated If the pilot lights hold in the control knob for 30 seconds If it has not lit repeat the pilot lighting procedure to a maximum of 6 clicks If after 6 clicks the pilot has not ignited leave the appliance for 5 minutes before attempting again Once the pilot has been established let out the small control knob and turn it fully anti clockwise Main Burner Control On Off The control should be set Pilot Setting to its OFF position when the stove s pilot is lit Important If after 6 attempts to light the pilot flame including the 5 minutes rest periods between attempts 30 minutes in total and the pilot flame will not light contact your Gas Safe service engineer No further attempts should be made to light the stove Euroheat Distributors H B S Ltd June 2009 3 E amp OE Instructions Part Number IN1123 Ed G Main Burner Control Turn the main burner control anti clockwise to increase the burner output clockwise to decrease On Off Turn the control knob fully anti clockwise to allow gas to the main burner Main Burner Control Turn the control knob anti clockwise to increase the burner output clockwise to decrease In the picture above it is set in its maximum output posititon Turning off the Stove but leaving it on its Pilot Setting To turn off the m
7. t 01885 491126 The glass clips should only hold the glass securely and not clamp it tightly Allowing for its expansion when hot The Stove Body Dusting the stove may be carried out when the stove is at its minimum heat output temperature using light strokes of a real bristle paint brush Thorough cleaning or any attempt to remove marks on the stove body must only be done when the stove is cold Stoves with a matt cast black finish must never be cleaned with a cloth as the texture of the cast iron surface and the paint will abrade and collect lint from the cloth which will be almost impossible to remove Vigorous brushing with a stiff bristle brush will remove all dust but where the paint is marked the stains are better obliterated with a spray of suitable stove paint rather than attempting to clean them off Suitable paint may be purchased from your stove retailer or directly from Euroheat Part number 40785 Stoves with an enamel finish should be cleaned with a damp cloth or very gentle use of a cleaner recommended for enamel finishes It should be noted that even approved cleaners will damage the highly polished finish of the stove if used too vigorously All traces of the cleaner must be removed before the stove is lit and no finishing polishes must ever be used as these will produce an obnoxious smell and leave unsightly streaks on the stove when it becomes hot Euroheat Distributors H B S Ltd June 2009 2 E amp OE Instr
8. to become hot and should be located away from pedestrian traffic furniture and draperies Advise all adults and especially children to be alert to the hazard of the stove s high surface temperatures Supervise young children when they are in the same room as the appliance and fit a suitable fireguard to safeguard young people or the infirm It is imperative that all stove and room ventilation air passageways are kept clear The appliance should be serviced annually by a suitably qualified Gas Safe registered engineer The registration document must be completed by the installer and returned within fourteen days to Euroheat Distributers H B S Ltd Euroheat Distributors H B S Ltd June 2009 1 E amp OE Instructions Part Number IN1123 Ed G First Lighting of the Stove Read the operating instructions and acquaint yourself with the operation of the controls before attempting to light the stove The Stove s Burner Controls The controls to operate the stove are hidden behind the lower door of the stove the main door should never be opened while the stove Is operating To open the lower door lift the left hand side of the door upwards Slightly to release the catch and then pull the door outwards Depending upon the model of stove the gas valve may be installed vertically or horizontally however the operation of the controls is the same for both orientations Curing the Stove On Off Pilot Setting and Ignition Control
9. uctions Part Number IN1123 Ed G Questions amp Answers Q Can I run the stove with the door open A No the stove has been certified as a closed appliance Operating the stove with the door open may damage the stove be a fire hazard and cause dangerous gasses to be released into the room Q Can I leave the pilot light on during the heating season A This is permissable and can be very beneficial It can prolong the life of the thermocouple and the very small amount of heat generated will help maintain a chimney draught Q The pilot flame lights but when remove the pressure from the on off control the pilot flame goes out A First ensure that the ON OFF control has been held in for 30 seconds if it has the most likely cause of this is that the thermocouple has failed and will need to be replaced by a suitably qualified Gas Safe engineer Q How often should the stove be serviced A This should be done once a year by a Gas Safe qualified engineer for not only the efficient running of the stove but also for the safety of the occupants of the property Q Where can I purchase spare parts for my stove A These can be obtained from the company who supplied you with the stove or directly from the Euroheat web site www euroheat co uk Q When heating up the stove makes a loud noise is this normal A This is called fulmination Most stoves will make a ticking sound when heating up and cooling down In a few cases this normal tick
Download Pdf Manuals
Related Search