User manual and medical device booklet
Contents
1. Auedwos ueisiuy99L AN 9 5 Ayu naas 18 Conditions of warranty Valid only within the European Union Reinecker Reha Technik GmbH grants a warranty of 24 months against defects in manufacture and subsequent usage All parts that have been replaced when repairing the unit will auto matically become property of Reinecker Reha Technik GmbH Damage caused by improper use or by non compliance with the operating instructions will result in the invalidation of the warranty Interventions from persons other than Reinecker Reha Technik GmbH authorized specialists may lead to invalidity of warranty if the damage is caused by this intervention Not included in this warranty are the lamps for illumination of the x y table and other parts subject to wear and tear If a warranty claim is necessary the unit must be returned in the original packaging We will not take responsibility for any transpor tation cost Service Hotline 49 0 6257 93110 View our General Terms and Conditions Your authorized distributor 19 Headquarters Germany and Export Development Production Sales Service Reinecker Reha Technik GmbH Sandwiesenstra e 19 DE 64665 Alsbach H hnlein Tel 49 0 6257 9311 0 Fax 49 0 6257 2561 Email info reineckerreha com www reineckerreha com Bitte wenden Sie sich bei Fragen oder einem Servicefall dire2. P 0 0 5 With the colour selection control O the following background colours can be selected Position 1 Full colour display Position 2 white font black background Position 3 black font white background Position 4 green font black background Position 5 yellow font black background Position 6 yellow font blue background Contrast brightness INN Setting the contrast with the Symbol control influences the difference between bright and dark parts of the screen Contrast and brightness are adjusted at the same time low contrast low brightness stop position left maximum contrast maximum brightness stop position right Line marker blanking CE From the left limit stop of the control to the central position the blanking is activated evenly from bottom and top From the central position of the control to the right limit stop the line marker is activated It can be positioned over the entire screen 10 Adjustment of the magnification ZOOM ZOOM The magnification range of the reading system is between 17 TFT monitor from approx x3 x75 19 TFT monitor from approx x3 3 x85 22 TFT monitor from approx x4 4 x104 The magnification depends on the distance between the document and the camera The magnification setting last used will be active when the system is switched on again While adjusting the magnification the current levle will be shown temporarily
3. Relative air humidity 30 to 80 e Air pressure 700 1000 hPa Power cable Please use only the original power cable Article number 30059 supplied by Reinecker Reha Technik GmbH Warning Using other accessories than the ones specified may lead to increased emission and or reduced immunity Power input socket with fuse 2xT1 6 L 250 V AC The plug socket is for the TFT monitors 17 19 22 Only connect the mounted monitor Power input 100 240 VAC 13 14 Product Identity Type Videomatic LUX 17 TFT Videomatic LUX 22 TFT Videomatic LUX 19 TFT Serial Number Manufacturer Reinecker Reha Technik GmbH Supplier Year of purchase Operator 1 4 2 3 6 Power supply 100 240 VAC 50 60 Hz Power consumption ca 70 Watt to ca 90 Watt Classification Attention When changing of operator the new operator shall be named in the corresponding column If re using the unit a new safety check is required dwejs sjeijiuy SUOI ONAISU 2 1591 L AN S pue dwejs sjeinug pue zo AN 9 59 18 10119 uonydunyenN 16 dwejs sienuj z ng Aq
4. The camera adjusts automatically within its scale of repro duction to optimum focus At the maximum magnification the camera automatically provides a sharp picture up to a thickness of the document of 4 5 cm Automatic colour saturation Brightness and saturation are automatically adjusted colours are displayed true to original Monitor settings on the TFT Videomatic LUX is preset in the factory The settings must not be changed on the TFT monitor Saving favourite settings automatically When you reset the device all settings used before will be activated again Operating the x y table The use of x y table is quick and easy to learn l The x y table can be moved in all directions ll The x y table can be moved only to the right or left The x y table is locked in position Important when writing or for transport Warning x y table is only to be used for reading Do not place anything within the movement area of the x y table Changing the lamps Attention Before replacing lamps the mains plug must be disconnected The system is equipped with 2x20 watt halogenlamps If replacement of lamps is required only original halogenlamps order number 26019 shall be used The replacement shall only be done by a specialist or by Reinecker Reha Technik GmbH m 11 12 Use in conjunction with medical products If the operator or user intends to run this opto electronic device together
5. with other medical devices such as cardiac pacemakers the written permission of Reinecker Reha Technik GmbH is required first Daeling with faults If technical problems do occur the unit must be switched off immediately and the mains plug disconnected In this condition the unit shall not be used Refer directly to your local dealer or to Reinecker headquarters Security checks Security checks must only be executed by technicians of Reinecker Reha Technik GmbH or by technicians authorized by the manufacturer Reinecker Reha Technik GmbH does not rule deadlines for safety checks The statements made in 6 MP Betreiber Verordnung regarding deadlines every two years at the latest are recommended Statements of the safety condition of a device will be made whilst safety checking according to the standard VDE 0751 Environmentally friendly disposal according to EC directive 2002 96 EG The appliance contains electronic components In order to avoid risks or dangers for the environment through non professional disposal the dispo sal of the product including all accessories has to correspond to the valid directives Special advice for transport and storage For reasons of safety the unit must only be transported and stored in the original packing The unit must be stored in dry and closed rooms in the original packing The following conditions for storage and transport have to be respected Temperature range 5 to 50
6. User manual and medical device booklet Videomatic LUX REINSCKER REHA TECHNIK Reinecker Reha Technik GmbH 19 D 64665 Alsbach Hahnlein Er Tel 06257 9311 0 Fax 06257 2561 Konformitatserklarung Declaration of conformity Wir erkl ren in alleiniger Verantwortung dass das Produkt We declare under our sole responsibility that the product Videomatic LUX auf das sich diese Erkl rung bezieht mit der den folgenden Normen oder normatischen Dokumenten bereinstimmt to which this declaration relates is in conformity with the following guidelines Es entspricht damit den Bestimmungen der folgenden Richtlinie it corresponds to the rules of the following guidelines Richtlinie 93 42 EWG des Rates vom 14 Juli 1993 ber Medizinprodukte Klasse I nach Anhang VII Guideline 93 42 EWG of The Council of 14th June 1993 about medical products Class I Annexe VII Die CE Kennzeichnung auf dem Ger t dokumentiert diese bereinstimmung The CE mark on the system points out this accordance Reinecker Gesch ftsf hrer Alsbach H hnlein M oe CEO 2 14 01 2008 Ort und Datum der Ausstellung Name Unterschrift des Befugten Name and signature of the authorized person Place and date of issue Contents EC Declaration of 2 Important notes on the operation of Videomatic LUX 5 de
7. d dry rooms exclusively In medical environments this device must not be operated on the same electrical circuit as devices for purposes of maintaining life This device should not be operated in explosion endangered environ ments This opto electronic device should only be installed in conjunction with modern electrical circuitry It is a device of a protection class The openings in the casing ensure optimum cooling and must not be covered INOTE Make sure that no liquids get inside the unit Classification of degree of protection Type B The systems are classified according to type B Should the leakage current of the entire unit exceed the maximum admissible value by using a monitor with excessive leakage current in the worst case a prickle in the fingers can occur R Installation Connection The screen reading system will be delivered set up and explained by an adviser of medical products Take the camera system out of its packing and put it on a solid sub surface You might use the height adjustable tabels by Reinecker Reha Technik GmbH If the reading system should be set up with a height adjustable table you have to fix it with 3 screws which are included in the delivery Attaching the remote control bracket See supplement Connection and switching on The camera system must be connected to a mains wall socket by using the mains lead included in the delivery Please note The plug socket is exclusivel
8. erating the system simultaneously with other systems however the possibility of disturbances of the system or other systems should not be neglected For this reason it should be ensured that the system is not placed directly beside or on top of another system If the set up of the system in the proximity of medical analogical measu ring devices cannot be avoided the operator of these devices has to be informed that it is necessary to observe the performance of the system to control the conventional use of the system in the chosen set up Electronic devices are sensitive towards electric discharge and towards high frequency electro magnetic fields In order to avoid high frequency disturbances the operator should respect a minimum distance of one meter to portable and mobile HF telecommu nication devices User Manual please read carefully Product description Electronic reading devices magnify text or pictures The text or pictures are recorded the camera and are displayed on the integrated screen The frame rate is 60Hz at a resolution of 1280x1024 Purpose Reading systems are medical devices to assist with the reading of printed text Visually impaired people compensate for their deficiency or illness by using this device Product life Seven years from the date of production provided that the recommended maintenance measures are carried out Security advice The devices are conceived for installation in closed an
9. kt an unser Hauptwerk in Alsbach H hnlein oder an eine unserer Niederlassungen In case service is necessary please contact your authorized distributor REINSCKER REHA TECHNIK Version V 1 1 Stand 01 08 Art Nr 000 10 219 Zentrale Deutschland und Export Entwicklung Produktion Vertrieb Kundenberatung und Kundendienste Reinecker Reha Technik GmbH SandwiesenstraBe 19 64665 Alsbach H hnlein Tel 06257 9311 0 Fax 06257 2561 Email info reineckerreha de www reineckerreha de
10. scription i ze uses stunden nalen ter 6 Sellerie 6 6 Security 6 Classification ans On 6 7 Attaching the remote control 7 Connection and Switching 7 Adjusting the monitor 7 EIGONDMIE NDICE des 8 Adjusting the monitor angle 8 and CONOIS os tn 8 Power 8 Remote 8 Colour selecto 9 Contrast Brightness 9 9 Adjusting the magnification Zoom 10 Automatic colour saturation 10 Monitor 10 Automatic saving of the instrument 10 Operation of the table 11 Changing the lamps 4208 pete neh 11 Use in conjunction with medical products 12 Dealing een 12 Sec rity Rete 12 En
11. vironmentally friendly disposal according to EC directive 2002 96 12 Special advice for transport and storage 13 Power Cable an Gah ESE EER ERE REE CS 13 Power input socket with 13 ana 14 Operating and 5 15 Malfunctions or repeated error record 16 Maintenance rec rd ara nn Ce apana ee 17 Security CHECKS done ewes 18 Conditions of warranty 19 GOMAGCE Sac ae ee 20 Important notes on the operation of Videomatic LUX Read these notes carefully before initial operation 1 Notes on the electromagnetic compatibility EMV The opto electronic reading device is suited for use in all set ups including the domicile that are connected directly to a public mains supply that powers buildings for residential purposes The opto electronic reading device is designed for use in the indicated electro magnetic environment The customer or user should ensure the use in the indicated environment The opto electronic reading device operates on HF energy exclusively for its own function Therefore the emitted interference of high frequency dis turbances is very low and the interference other appliances operated close by is improbable When op
12. y for the operation of the TFT monitor supplied The system is now ready for use Adjusting the monitor height The highly flexible monitor arm enables the user to adjust the monitor height and angle to meet individual needs d Ergonomic notice In order to prevent reflections on the screen you should avoid direct light falling on it when adjusting the Videomatic LUX Always position the rea ding systems monitor to avoid reflections Adjusting the monitor angle The level of contrast and brightness on the TFT will change depending on the angle of the screen These will have to be adjusted to accomodate your position in relation to the monitor Switches and controls Power switch The on off switch of the device is found on the front panel After switching the device on the reading table will be illuminated Please note If the reading table does not illuminate you should check that the leads and plugs are all firmly connected to the wall socket at the camera as well as at the camera system Remote Control AF autofocus on off oC 0 choice of colour N contrast brightness gt rig line ruler line cover ZOOM magnification zoom By pressing the AF button the autofocus will be switched on off If the autofocus is switched on the AF LED display flashes Within its reproduction scale the camera sets automatically its optimal sharpness Colour selection 2 8 08
Download Pdf Manuals
Related Search