Smeg combined installation manual A 300807
Contents
1. instruction concerning use of the appliance in a safe way and understand the hazards involved Children aged from 3 years and less than 8 years shall not plug in regulate and clean the appliance or perform user maintenance 7 WARNING This heater is not equipped with a device to control the room temperature Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own unless constant supervision is provided Do not allow the heater to be covered as this may cause overheating The appliance must not be placed near curtains or similar material A clearance space of at least one metre should be allowed in front of the appliance The electrical socket that the appliance uses MUST be easily accessible Do not route the supply cord directly over or above the heater unit If the cord is damaged it must be replaced by a service agent or competent person This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance The LCD displays are produced using highly accurate technology however black pixels may be found or red blue and green pixels may not disap pear This is perfectly normal and within pro2. or after Ist February 2009 For all gas fires purchased the 3 year guarantee commences from the date of purchase provided that the following 3 terms and conditions are adhered to Registration is not required For any claim to be made within the 3 years from date of purchase you will be required to provide and supply us with your proof of purchase 2 Your gas fire must have been commissioned by a CORGI Gas Safe registered installer evidence of which you must provide together with the CORGI Gas Safe registration number 3 Your appliance must have been serviced annually irrespective of use by a CORGI Gas Safe registered installer evidence of which must be provided such as the receipt Please note all consumable items such as any ceramics including coals pebbles the matrix front strips side cheeks rear panels and tapered rear panels are not covered by the 3 year guarantee For all Electric fires purchased the 3 year guarantee commences from the date of purchase providing that you can supply the proof of purchase This does not cover consumable items such as pebbles coals or light bulbs Making a claim is easy If you wish to make a claim under our 3 year guarantee and all the terms and conditions for your product have been met then please submit the following information for the attention of the 3G Service Department to the address below Alternatively you can email or fax Please note that this does not affect your statutory right
3. INSTALLATION amp USER INSTRUCTIONS LCD ELECTRIC FIRE MODELS COVERED BY THESE INSTRUCTIONS T fi 1030 LCD INSET ELECTRIC FIRE Tel 01202 588 638 Fax 01202 499 639 www ekofires co uk e mail sales ekofires co uk T Christchurch Dorset BH23 2BT FRET AND FRAME OPTIONS AVAILABLE CE MODEL SHOWN EKO 1030 LCD INSET ELECTRIC FIRE Cal guarantee PLEASE NOTE EKO 1030 ELECTRIC FIRES MAY BE SUPPLIED WITH DIFFERENT FRET amp FRAME THAN SHOWN Please note Except where otherwise stated all rights All instructions must be handed to the user including copyright in the text images and layout of this forisafalccenin booklet is owned by Focal Point Fires plc You are not per ping mitted to copy or adapt any of the content without the prior written permission of Focal Point Fires plc Revision B 01 14 2014 Focal Point Fires plc INSTALLATION amp USER INSTRUCTIONS GBIE Section Contents Page No Section Contents Page No 1 0 Preliminary Notes 2 7 0 Fitting The Decorative Frame And Front 3 2 0 Appliance Data 8 0 Operating The Appliance 4 3 0 Installation Requirements 9 0 Saftey Cut Out System 4 0 Unpacking The Appliance 10 0 Cleaning And Maintenance 5 0 Component Checklist 11 0 Servicing 6 0 Installing The Appliance 12 0 Appliance Dimensions 13 0 Guarantee Terms And Conditions 1 0 PRELI
4. MINARY NOTES The LCD inset electric fire heater provides convected heating in conjunction with a LCD screen which can display a number of different fuel effects and scenes The appliance is designed for indoor use and can be simply floor mounted in the majority of floor positions anticipated It can be located in any household room with the exception of bathrooms Read all of the instructions before commencing installation Retain for future_reference and pass on as necessary to subsequent owners of the appliance e DO NOT use this appliance immediately below a fixed socket outlet e DO NOT use this appliance in the immediate vicinity of a bath shower swimming pool or other area where water moisture could pres ent a hazard CAUTION This appliance must not be used in conjunction with any timer programmer or thermal control or any other device that will switch on the appliance automatically as a fire risk may occur if the heaters are accidentally covered or displaced CA ON some parts of this product can become very hot and cause burns Particular attention has to be given where children and Wwwwnn auuuwuw vunerable people are present s WARNIN Children of less than 3 years should be kept away unless continuously supervised Children aged from 3 years and less than 8 years shall only switch on off the applaince provided that it has been placed or installed in its intended normal operating position and they have been given supervision or
5. duct specification This should not be regarded as a fault 2 0 APPLIANCE DATA Weight kg 10 kg Voltage Volts 230 240V a c 50Hz Heating Elements 2 x 900 1000 Watts Supply Cord 2 metres Supply Plug BS 1363 13A Fused Location Indoor Use LCD Display 25 Watts 3 0 INSTALLATION REQUIREMENTS The appliance is suitable for installation into all proprietary surrounds with an opening of 406mm by 559mm 16 by 22 The appliance is sup plied fitted with 2 spacer frames enabling it to be fitted with no need for a recess into a wall or surround back panel Each spacer frame has a different depth and once detached from the frame and fitted individually the mounting depths can be either 75mm or 20mm Alternatively the appliance can be fully recessed if the opening depth is 100mm or greater and neither spacer is used It may be installed directly into any propri etary surround which can house this size of rebate without the need to recess the appliance into a wall opening or fabricate a false chimney breast 2014 Focal Point Fires plc 3 0 INSTALLATION REQUIREMENTS CONTINUED ED This appliance should be positioned on a firm level surface and in a clean dust free environment If the fire is to be sited in a fire surround then the suitability of the surround for use with electrical heaters should be established with the fire surround manufacturer If fitted into an open draught fireplace it is advisable to blank off the chimne
6. ently of the heating features The next switch down with a single bar marked I operates the low heat IkVV setting The switch at the bottom with two single bars marked II operates the high heat 2kW setting To operate the fire in any of the above modes the top switch marked Ol must be switched to the on position Fig 2 Log fire Fig 3 Twig fire Fig 4 Coal fire Controlling the LCD display panel LCD on off control The LCD display may be switched on and off indepenently of the heater Fig 6 Gas fire high functions by using the LCD on off button as shown in figure I Scene select buttons The appliance is pre programmed with nine different scenes as shown in figures 2 through 10 These scenes have been specially edited to run in a seamless loop When the appliance is switched on the log fire scene will auto matically run To select a different scene press the appropriate scene select button to LCD choose the desired scene During normal operation the footage may occasionally be seen enor contro to freeze for a fraction of a second This happens as the scene is recycled to loop again This is perfectly normal and should be no cause for concern ane select buttons Volume up down and mute button Some of the LCD scenes include sound effects These buttons raise and lower the volume The Mute button mutes the speakers While the speakers are muted a symbol
7. gloves is recommended Decorative frames The appliance is supplied either with a one piece or three piece decorative frame For one piece frames dependent on model The appliance is supplied with a one piece decorative frame that is attached to the front of the firebox with the magnets provided Place the decorative firefront in front of the fire and slide the ashpan door into place The firefront shown in these instructions may be different to the one supplied with the appliance For three piece frames The side pieces of the clip on assembly should be pushed into position first followed by the top bar which overlap the sides Cast frame models Remove the decorative frame from it s protective packaging The frame is retained onto the firebox with a mount ing bracket at the top of the frame and three magnets on each leg of the frame C3 2014 Focal Point Fires plc lt D Check that the heater outlet grille mounted at the top of the appliance is not covered or obstructed in anyway and ensure the power to the Read All Instructions Before Use fire is switched on The power to the LCD display panel and the heater functions are controlled using three switches mounted underneath the hood on the left hand side Controlling the heater functions The first switch towards the top marked 01 controls the main power to the appliance and switches on the LCD display panel This feature can be used independ
8. pliance is fitted with 2 spacers a 75mm spacer and a 20mm spacer e To remove the spacers Remove the six screws from the rear spacer located at the rear of the appliance To remove the front spacer unscrew the six screws located on the front of the appliance To ensure the appliance is positively located into position it is necessary to secure it in place using the double sided neoprene strips included in the instruction pack Peel off the adhesive backing from one side of each strip and apply to the periphery of the REAR of yl the appliance frame as shown in figure Ensure that the strips are not applied any closer than 5mm N os 1 4 from the edge of the frame attaching the strips closer may present problems when fitting the wi decorative trim Tear off any excess lengths of strip to form a neat border around the frame Before Ne Fig finally fitting the appliance into its location remove the remaining strips of adhesive backing ensure that the mains cable and plug are properly routed locate the fire into the opening and press firmly around the edge of the frame to allow the strips to adhere to the back panel of the surround 7 0 FITTING THE DECORATIVE FRAME AND FRONT The appliance may be supplied with a decorative frame in a variety of finishes IMPORTANT Due to the possibility of sharp edges care should be taken when handling the frame components The use of protective
9. plugged in at the outlet socket If this is not the cause call an electrician 10 0 CLEANING AND MAINTENANCE ALWAYS DISCONNECT THE APPLIANCE AT THE SUPPLY OUTLET SOCKET BEFORE UNDERTAKING ANY CLEANING Except for periodic cleaning of dust there are no specific requirements for care other than regular cleaning of the general appliance A wipe with a dry cloth is normally sufficient DO NOT use abrasive cleaners as they can damage the finish Make sure the heater outlet grille locat ed next to the switches and the air inlet mesh grillesare kept clear of dust pet hair and other airborne household matter These should be vacuum cleaned periodically using a brush attachment GLASS SCREEN This should only be cleaned using a suitable glass cleaner Test on a small area first There are no internal user serviceable parts Check security of supply cable and connections If the supply cable becomes damaged it must be replaced by a service agent or competent per son such as a qualified electrician 11 0 SERVICING The wires in the cable are coloured in accordance with the following code LIVE Brown NEUTRAL Blue EARTH Green Yellow Refer to Section 2 0 Appliance Data for fuse specification Excluding fuses use only genuine manufacturers spare parts available from your sup plier 12 0 APPLIANCE DIMENSIONS All dimensions in mm C55 2014 Focal Point Fires plc cD The 3 year guarantee only covers products purchased on
10. s Eko Fires Itd 3G Service Department Reid Street Christchurch Dorset BH23 2BT Alternatively email service ekofires co uk or fax 01202 499326 Details required 1 Name full address including post code and contact telephone number 2 Receipt of purchase or credit card statement 3 Original installers CORGI Gas Safe registration number gas fires only 4 Annual service receipt for every 2 months gas fires only Gas Safe Register replaced CORGI as the gas registration body in Great Britain and the Isle of Man on Ist April 2009 As our policy is one of continuous improvement and development we therefore hope that you will understand we must retain the right to amend details and or specifica ey Waste electrical products should not be disposed of with household waste Please recycle where facilities exist Check with your local authority or retailer for recycling advice tions without prior notice 6 2014 Focal Point Fires plc F861174
11. will be displayed on screen Press again to de activate Volume and mute The appliance can be switched off at any time irrespective of the particular buttons mode selected by simply switching the first switch marked OI to the off position It is also recommended to unplug the power supply cable at the supply outlet when not in use 3 Figure 2014 Focal Point Fires plc 9 0 SAFETY CUT OUT SYSTEM ED This appliance has a safety cut out system fitted which will activate if the air inlets or heater outlets are obstructed For safety reasons the fire WILL NOT switch on again automatically NOTE The LCD display panel will remain operational if the cut out is activated only the fan heater elements are prevented from operating The following procedure must be carried out before the fire can be operated again Unplug the power supply cable at the outlet socket and place all switches to off at the appliance 2 Leave the fire OFF for a period of not less than 10 minutes ensuring any obstructions are removed 3 Plug in the power supply cable at the outlet socket and then switch on at the appliance If the appliance fails to operate correctly repeat the above procedure If an attempt to switch on is made before the safety cut out has reset the heaters may cut out for a further period of time If the sequence has been followed correctly and the heaters still fail to function check the power supply cable plug is
12. y to reduce the risk of draught through the fire which may cause the safety cut out system in the fan heater to operate DO NOT site in a position where curtains or drapes could cover the appliance site in a position where other soft materials could cover e g below a coat rack site behind an opening door where mechanical impact damage could occur site where the supply cable would become a trip hazard sit stand or forcefully pull on the appliance obstruct cover or force items into the openings use the heater to dry clothes site use in an outdoor location s run the supply cable under carpets Mount on a wall 4 0 UNPACKING THE APPLIANCE Read all the instructions before continuing to unpack or install this appliance Carefully remove the appliance from its packaging and lay on the floor with it s back surface downward Note DO NOT stand the appliance on its frame as this may cause distortion Check that the remaining packaging contents correlate with the component checklist below Please dispose of all packaging with care at your local recycling centre 5 0 COMPONENT CHECKLIST QUANTITY DESCRIPTION l Heater main body l Decorative Frame l Decorative Fret with aspan door l Remote control handset l Mains supply cord l Neoprene securing strips l Instruction Booklet 6 0 INSTALLING THE APPLIANCE CAUTION DO NOT CONNECT THE APPLIANCE TO THE ELECTRICAL SUPPLY AT THIS TIME Neoprene Strip The ap
Download Pdf Manuals
Related Search