Quick User Guide
Contents
1. LIFESAVER Quick User Guide INSTRUCTIONS This quick user guide should be used in conjuction with the Instruction Manual provided with your LIFESAVER cube The full technical instruction booklet can be found online at www lifesaversystems com FIRST USE 1 Priming Unscrew and remove the pump from the LIFESAVER cube Fill with tap water camp water or water from any clean source to the top Screw pump firmly back into place Let stand for 5 10 minutes 2 Pump amp Discard Turn the tap to the open position Pump several times until water starts to flow Empty cube through tap do not drink Repeat twice Your LIFESAVER cube is ready to use ROUTINE USE Caution When filling the LIFESAVER cube with water take care to keep the tap area clean An 2 Filling Unscrew and remove pump Fill with water from tap camp river lake stream or other source to the top Use the cleanest water source available This will prolong the life of your LIFESAVER cube 3 Pumping Ensure tap is closed and pump a few times 4 Drinking Push tap cap down and turn tap cap to open position or twist and lock tap cap to enable clean sterile drinking water to flow Continue to pump to improve flow Turn tap off after use O Operation amp Storage Your LIFESAVER cube will work in different orientations As the water gets low changing the orientations will improve the flow rate Protect from freez2. ing and shocks IMPORTANT e Ensure the product is always kept full of water once primed e Do not drop or subject to shock e Be careful not to over pump amp over pressurise this product 2007 2013 LIFESAVER systems Itd All rights reserved Patents and registered designs pending and granted LIFESAVER is a registered trade mark The following are trademarks of the LIFESAVER group of companies FOR A HOSTILE WORLD FILL PUMPDRINK FAILSAFE V1 0 LIFESAVER How to install a new LIFESAVER cube UF cartridge Empty the cube of water and release pressure by unscrewing pump cap Unscrew and remove tap cap and tap Remove the old cartridge and discard it responsibly along with the O rings Clean the LIFESAVER cube and pump completely by washing it with mild washing up liquid in warm water use a soft cloth for this Ensure that all dirt is removed and the cube is thoroughly clean Rinse thoroughly and allow to dry Remove the new LIFESAVER cube UF cartridge from it s packaging Insert the new cartridge complete with new O rings into the cube and press down Thread tap cap onto the cube Ensure that the tap cap is tightened firmly with the tap pointing straight forward Prime the cartridge please follow instructions for the first use shown on the reverse of this guide Ready to use your LIFESAVER cube again please follow instructions for routine use show
3. n on the reverse of this guide O O O O Caution When replacing the LIFESAVER filter cartridge the O rings positioned above and below the filter must be renewed Ensure O rings are positioned correctly tight against the flange of the filter and are not pinched during reassembly The full technical instruction booklet can be found online at www lifesaversystems com LIFESAVER systems Itd Hall Chase London Road Marks Tey Colchester Essex CO6 1EH UK 44 0 1206 581 4 0 1206 215679 info lifesaversystems com www C
Download Pdf Manuals
Related Search