Home

Installation Manual

image

Contents

1. it pops in 14 Lightly grease the large pivot ball before installing the TWM shifter into the plastic assembly in place of the stock shifter Id hy Kal z Error MARCA Erate a oe Page 6 15 Re install the clip on the bottom of the shifter 16 Replace the top plastic retaining ring and rubber grommet 17 Replace the top part of the assembly drive the rear pin back in and re insert the L shaped shift arm Page 18 Install the clip included in the kit onto the shaft at the front of the assembly Drive the clip on with a 12mm socket to secure it properly against the plastic assembly Be sure the shaft is pushed all the way into the assembly and the clip is on all the way so there is no free play 19 Re install the clip on the driver s side of the L shaped shift arm Bolt the assembly back to the chassis using the 4 bolts and washers included with the kit 20 Re install the console boot and shift knob and you re ready to drive HR Y UM pn ar zn Page 8
2. Page 1 Installation Manual TWM Performance Short Shift Kit 2003 Hyundai Tiburon 5 speed 1 Unscrew the shift knob and remove the boot a e E 3 s EL o E EA ts Se P al a E See ae es eee So TOSS Se a 0 a ea a 2 Remove the cover which surrounds the shifter Pull up on it and it pops out marl by fT A A hs ere E Page 2 3 Remove the screws on either side of the center console There are 3 sets of screws securing the console There is one set toward the front of the console one set near the center as shown in the picture on the left and one set toward the rear of the console 4 Remove the 2 screws at the front of the console Once these screws have been removed The console just lifts out 5 Carefully slide an exacto knife under the clip on the right side of the assembly to remove it CAUTION Be extremely careful in this step if the knife is torqued too hard the blade could break and become a dangerous projectile Fa ae j F a pee chy Ved F N A Ls LS i PEORFORMAMNCO Erate a oe Page 3 6 Insert a flat head screw driver into the gap created by the exacto knife to pry the clip off Use a punch to drive out the pin on the opposite side of the shifter Tap lightly with a hammer until the pin is driven out of the assembly 8 Remove the clip on the left side of the assembly ri co I N Ef i f ee PERFORMANCE mF nun Page 4 9 Remove
3. the four bolts securing the assembly to the chassis Remove the steel inserts from the rubber bushings by pushing them out through the bottom of the bushing Push the rubber bushings out through the bottom of the plastic assembly Now insert the aluminum bushings included with the kit in place of the rubber ones you just removed They will slide in beneath the plastic assembly be sure their smallest diameter is facing up and is inserted into the hole in the assembly Place a bolt and washer included in the kit through the assembly and bushing tighten later 10 Lift up the assembly and remove the bottom clip holding the shifter to the linkage 11 Pull out the pin and the L shaped arm which was held on by the clip and remove the shifter Page 5 12 Use the cup remover tool included with the kit to remove both plastic cups on the original shifter To do so place the cup remover tool on top of the open jaws of a vice the jaws should be approximately 1 apart Hang the shifter from the tool as shown be sure the shifter is inserted completely into the slot in the tool Insert a punch into the center hole through the plastic cup and tap firmly with a hammer to separate the original shifter from cup Repeat for 2nd cup 13 Install the plastic cups which you removed from the original shifter onto the TWM shifter Grease the cups and pivot balls Place the cup on a firm surface and push the TWM shifter into it until

Download Pdf Manuals

image

Related Search

Related Contents

8_M3Section7SettingU..  Wings 4 and CPR: Curve finding, fitting What`s a spline, and why use  DEEP VACUUM PUMP OPERATING INSTRUCTIONS  OLK XXX Tender for Supply of geological equipment  PDF Manual de instrucciones PS 1000 (ES), 1.9 MB  RD547 Intelligent Geophone  Samsung VC-6814VN Brugervejledning  OCT 2014 - Ville de Clapiers    user manual - Recambios, accesorios y repuestos  

Copyright © All rights reserved.
Failed to retrieve file