GB user guide
Contents
1. 31 ODP teleloop amplifier Your local representative MPhonicEar International 45 3917 7101 germany kostenlose Rufnummer 0800 1844736 user 8 Ul d gt u s 800 227 0735 then press 7 canada 800 263 8700 website www phonicear dk other resources online at www phonicear dk O 2005 Phonic Ear A S 921 21 110 00 Rev table of contents 188 o a LOOP E A LOOP accesoires e eretiers E EEEE 0 Bs 2 lt eecascacennd dtre nkk Troubleshooting s sasse een ese aitam ddam ana pa a a aaia ii eepe e a the a a E eee a P a es PAAA Loop function LOOP is the PUZZLE systems teleloop amplifier LOOP transfers the sound from TV and radio directly to your hearing aid or telemagnetic receiver and you receive the sound loud and clear Loop can also receive alarms from the PUZZLE system s alerting transmitters DETECT DOOR and or OBSERVER When an alarm is received the signal from the radio or the TV is turned down and an alarm signal is heard instead LOOP can receive up to seven different alarms apart from the alarm for battery change Each alarm has its own unique sound pattern which makes it easier to distinguish between the different alarm signals The individual sound patterns are set on the alerting transmitters DETECT DOOR and or OBSERVER important Use only cables and jack plugs supplied by an authorized Phonic Ear representative installer or LOOP may be damaged Loop features C channel tuner To set persona2. by an output connection Can also be used to amplify conversations 17 boundary microphone not shown cusion loop not shown A Loop instructions teleloop installation lt 1 Place teleloop cable along wall floor or top view of room ceiling of room where Loop will be used and secure with cable clips To avoid cable damage run cable under carpet behind baseboard or around doorframe ATTENTION Make sure that teleloop cable is fully stretched out If cable is too long shorten it to fit room size Cushion Loop sold separately Place cushion loop pad under a cush ion in the seat where you are listening to the sound source The cushion loop limits the range of the teleloop and possible interference ability It can also be easily moved around the room as necessary lt I gt Remove gray Loop con nector from back of unit Loosen cable connection screws on the Loop connector Strip ends of cable to expose 1 cm of wire Insert ends of cable into connector holes and 12V AC Q 18V DC Radio TV i tighten screws using the screwdriver Replace gray connector into Loop hole on unit Loop instructions connect to TV and radio Channel TV connection Plug one end of the cable from connector set into one of the Radio TV connections on back of LOOP Then plug other end of the cable into Line Out or SCART connection on TV Radio connection Plug one end of the cable fr
3. erning sale of consumer goods Your distributor may have issued a war ranty that goes beyond the clauses of this limited warranty Please consult your distributor for further information what to do if you need service If you require service under the terms of this warranty carefully package the instrument to pre vent damage and return it to your distributor see information on back cover Please provide your receipt a detailed description of the problem your full name billing address and telephone number 11
4. l code for use with other PUZZLE systems 12V AC Q loop connection B chan sv DC Radionv To connect teleloop cable G 12V AC 18V DC connection To connect 12volt power transformer 4 radio TV connections To connect radio television etc 5 microphone connection To connect external microphone 6 indicator light Shows that power is on 7 volume control To adjust volume level bass control To adjust bass levels 9 treble control To adjust treble levels channel type To set channels to X or Y Maintain in X Position for I MPhonicEar normal use 10 05 02 CE Radio tv E Loop accessories included with Loop system 11 teleloop cable Installed in rooms where Loop will be used 12 teleloop cable clips To secure the teleloop cable along the wall floor and or ceiling 13 screwdriver To adjust bass and treble controls and to set personal code connector set Includes e Adaptor SCART phono e Adaptor 6 3mm 25in plug stereo to 3 5mm 125in stereo jack e Connector cable 2m 6 5ft 3 5mm 125in plug stereo to 3 5mm 125in stereo plug e Stereo cable 2m 6 5ft 3 5mm 125in stereo plug to 2 x phono plug Power transformer optional in some countries not shown Loop accessories not included sold separately Clip microphone Placed in front of source loudspeaker if sound source cannot be attached to teleloop amplifer
5. lume should be adjusted so that you dont experience irritating changes in volume when you change between M and T positions on your hearing aid Loop instructions 9 adjusting bass and treble Turn left control on bottom of LOOP clockwise to increase bass level and counterclockwise to reduce bass level Turn right control on bottom of LOOP clockwise to increase treble level and counterclockwise to reduce treble level NOTE Use the screwdriver included with LOOP to adjust bass and treble controls hearing aid setting JN Set hearing aid to T Pr Y position when using teleloop troubleshooting Should your LOOP teleloop amplifier not function satisfactorily please check the list below The red light on the front of Loop unit does not come on e Check to see that the wall contact is switched on e Switch off the wall contact for 10 seconds and then switch it on again The red light on the front of Loop comes on but there is no signal when the TV or radio is turned on e Check that the volume is correctly adjusted See 8 e Check that all the connections are connected properly e Check that your hearing aid is set to the position telecoil The red light on the front of Loop comes on but no signal is heard when one of Puzzle system s alerting transmitters is activated e Check that the personal code on LOOP and PUZZLE systems transmitters are the same See 6 Loop give
6. om connec tor set into one of the Radio TV connections on back of LOOP Then plug other end of the cable into Line Out connection on radio NOTE Sound sources other than TV and radio can be connected to LOOP Contact an authorized Phonic Ear repre sentative installer for more information If sound source cannot be attached to teleloop amplifier by an output connection then microphone can be placed in front of the source loudspeaker Plug microphone cable into Mic connection on back of LOOP NOTE When Clip microphone or boundary microphone are used for conversations the TV and radio should be switched off Loop instructions connecting transformer Plug transformer cord into 12V AC 18V DC connec tion on back of LOOP Plug transformer into wall socket Red light on front of LOOP should go on 6 selecting personal code Use Channel tuner on back of LOOP to set personal code as H 12v acy Chann eS 18V DC Radio TV NOTE Use the screwdriver included with LOOP to turn dial to desired setting All other PUZZLE alarm transmitters and receivers should be set to the same personal code Loop instructions Channel type X and Y Dip switch on underside of LOOP should be in X position as stan dard to use channels 0 E 16 adjusting volume Use volume control on front of LOOP to adjust volume level Min Lowest volume Max Highest volume NOTE As a general rule the vo
7. s a signal for no apparent reason e Change the personal code using the turner marked Channel on the back of Loop See 6 The signal from Loop sounds distorted e Check that the volume is not too high See 8 If you still have trouble after trying the ideas above please contact your local authorized Phonic Far representative installer see information on back cover test and approval Hereby Phonic Ear declares that this LOOP is in compliance with the essential requirements and other relevant provisions of Directive 1999 5 EC C E lt Waste from electronic equipment must be handled according to ON local regulations warranty one year limited warranty is issued to the original consumer of this product s by Phonic Ear two years inside the EU time period of warranty This warranty will go into effect upon the date of original purchase of this equipment and will remain in effect for one calendar year two years inside the EU from that date as long as the instru ment remains the property of the original consumer what is covered by this warranty Any electronic component which because of workmanship manufacturing or design defects fails to function properly under normal use during the life of this warranty will be replaced or repaired at no charge for parts or labor when returned to the factory service center Transportation in is paid by the customer If it is determined that repair is not feasible the entire uni
8. t may be replaced with an equivalent unit upon mutual agreement of the manufacturer and customer what is not covered by this warranty 1 Malfunctions resulting from abuse neglect or accident 2 Peripheral accessories as itemized within the product brochure when such items are returned after 90 days from the original purchase 3 Alkaline batteries if applicable 4 Instruments connected installed used or adjusted in a manner contrary to instructions pro vided by the manufacturer 5 Consequential damages and damages resulting from delay or loss of this instrument The exclusive remedy under this warranty is strictly limited to repair or replacement as herein provided 6 Products damaged in transit unless investigated by the shipper and returned to the warrantor with the investigation report Phonic Ear reserves the right to make changes in the design or construction of any of its instru ments at any time without incurring any obligation to make any changes whatsoever on units previously purchased This warranty is in lieu of all other expressed warranties All expressed and implied warranties will terminate upon the expiration of this written warranty No representa tive or person is authorized to represent or assume for us any liability in connection with the sale or use of our products other than as set forth above The above warranty does not affect any legal rights that you might have under applicable national legislation gov
Download Pdf Manuals
Related Search