Operating instructions
Contents
1. Start up instructions FDS Tool V4 x_1 english Gos STOBER ANTRIEBSTECHNIK Savety Precautions Before putting into operation of FDS Tool together with the FDS inverter or the SDS inverter read and pay attention to the documentation of the frequency inverter of the type FBS FDS Impr Nr 441 408 You have to observe the safety instructions FDS Tool FDS Tool is a support program for all setting and diagnostic operations of the frequency inverters type FBS FDS 3xxx and 4xxx and the servo inverters type SDS 4xxx from STOBER Antriebstechnik It runs at all IBM compatible PCs with Microsoft Windows version 3 1 or higher With FDS Tool all parameter of the inverter can be adjusted commented saved printed and sent to the FDS All displays of the FDS and a lot of additional diagnostic data can be read from the FDS checked documented saved and administerd You can transmit data with the FDS via serial communication RS232 or Parabox With the Scope function you can record dynamical processes in real time and then you can watch and analyse the data The programm is used like other Windows programs and because of this it is very easy to handle All operation steps are explained in the online help System requirements For the operation of FDS Tool together with the frequency inverter type FBS FDS and servo inverter type SDS the following minimum requirements are necessary IBM compatible PC with 386 processor or higher rec2. ommended 486 processor 66MHz Microsoft Windows version 3 1 or higher available RAM 4MB harddisk with 4MB free memory mouse or corresponding input device is recommended FBS FDS 3xxx or 4xxx device of the 3 or 4 generation with 6 keys Parabox serial connection cable Installation Before starting the installation of FDS Tool Microsoft Windows version 3 1 or higher Windows 95 98 too must be installed You can start the installation with the Windows programm manager with menu command file execute or with the task bar from Windows 95 98 start execute a setup exe If the disk is in another drive you have to replace a by e g b Now you can select respectively modify the source and the destination directory You can do this directly in the corresponding input box or you search your drives by clicking the button right beside The actual installation directory is set as source directory normally A and as destination directory C FDSToolE Attention Instead of reading a long documentation about working with FDS Tool you can always press F1 to get online help from FDS Tool and FDS Impr Nr 441409 00 00
Download Pdf Manuals
Related Search