Gemmy 37631 Instructions / Assembly
Contents
1. WARNING READ AND UNDERSTAND ALL INSTRUCTIONS Failure to follow all instructions listed below may result in electric shock fire and or serious personal injury WARNING ELECTRIC PRODUCT Keep away from children Not recom mended for children under 3 years of age As with all electri cal products precautions should be observed during handling and use to reduce the risk of electric shock If the supply cord is damaged it must be replaced by the manufacturer its service agent or similarly qualified persons in order to avoid a hazard To avoid the risk of electrical shock always make sure the figure is unplugged from the electrical outlet before assembling disas sembling or relocating WARNING This product is to be assembled by adults only IMPORTANT SAFETY INSTRUCTIONS WHEN USING ELECTRICAL PRODUCTS BASIC PRECAUTIONS SHOULD ALWAYS BE FOLLOWED INCLUDING THE FOLLOWING READ AND FOLLOW ALL SAFETY INSTRUCTIONS 1 This is an electrical product not a toy To avoid risk of fire burns personal injury and electric shock it should not be played with or placed where small children can reach it 2 Do not use seasonal products outdoors unless marked suitable for indoor and outdoor use When products are used in outdoor applications connect the product to a Ground Fault Circuit Interrupting GFCI outlet If one is not provided contact a qualified electrician for proper installation This seasonal use product is2. blown Inflatable Unit 1 piece Base Stakes 6 pieces Tether Stakes A pieces Nylon Tethers 4 pieces Extra C 7 Light Bulb 1 piece 5 Amp 125V Fuse 1 piece GENERAL INSTRUCTION 1 Remove contents from packaging Lay out deflated Airblown Inflatable in a clear area 2 Locate four clips on the bottom of the fabric and attach to the plastic legs See illustration 1 illustration 1 3 Tum unit upright Make sure the air intake is clear of fabric or other ob struction and zipper is fully closed A Insert the base stakes through the plastic legs into the ground See illus tration 2 pan illustration 2 5 Plug into receptacle or other outlet device to inflate your Airblown Inflatable 6 Once fully inflated clip the tethers to each of the nylon loops on the side of the Airblown Inflatable See illustration 3 0S illustration 3 7 Insert the tether stakes into the ground and attach the tethers See illustration 4 8 Locate the nylon Loops on the bottom of the fabric base and insert the base stakes through the nylon loops and into the ground 9 To deflate unplug fan For faster deflation unzip zipper after unplugging fan Do not unplug by pulling on cord USER SERVICING INSTRUCTIONS Lamp Replacement Disconnect the plug from the electrical outlet and allow the lamp to cool completely before replacing bulb Do not touch the bulb when the power is ON as it is extremely hot and make ca
3. ct from the outlet Also unplug any additional string or products that may be attached to the product Replace the tuse as per the user servicing instructions follow product markings for proper fuse rating and check the product If replacement fuse blows a short circuit may be present and the product should be discarded 15 Read and follow all instructions that are on the product or provided with the product SAVE THESE INSTRUCTIONS USE AND CARE INSTRUCTIONS 1 When the product is placed on a live tree the tree should be well maintained and fresh Do not place on live trees in which the needles are brown or break off easily Keep the tree holder filled with water 2 If the product is placed on a tree the tree should be well secured and stable 3 Before using and reusing inspect the product carefully Discard any products that have cut damaged or frayed wire insulation cords cracks lamp holders or enclosures loose connections or exposed copper wire 4 When storing the product carefully remove the product from wherever it is placed including trees branches or bushes to avoid any undue strain or stress on the product conductors connections and wires 5 When not in use store neatly in a cool dry location protect ed from sunlight Congratulations You re the proud owner of a Gemmy Airblown Inflatable Please read over the directions carefully before using your Gemmy Airblown Inflatable CONTENTS Air
4. erference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures e Reorient or relocate the receiving antenna e Increase the distance between the equipment and receiver e Connect the equipment into an outlet on a circuit different from that to which the receiver is connected e Consult the dealer or an experienced radio TV technician for help THESE INSTRUCTIONS ARE FOR THESE ITEMS 37631 37631 B Visit WW GEMMY COMformoreinformation 2015 GEMMY INDUSTRIES CORP 117 WRANGLER DRIVE SUITE 100 COPPELL TX 75019 U S A 1 877 250 9032 MADE IN CHINA PRINTED IN CHINA
5. irblown Inflatable during unusually strong winds If it becomes too windy for safe operation simply allow your Airblown Inflatable to deflate and wait for better conditions before re inflating Protect the electric fan and power cord from direct exposure to water This precaution will reduce the risk of electrical shock When the temperature is below 14 F 10 C the motor may temporarily stop running The motor will begin functioning again higher temperatures WARNING Remove all plastic fasteners and tags These are part of the packaging and should be discarded This item is not a toy and should be used for decorative purposes only For indoor and outdoor use 120 V 60 Hz TROUBLE SHOOTING CHECKLIST If your Animated Airblown Inflatable is not inflating the problem may be 1 The power source is disabled or the cord may be unplugged 2 Debris may be lodged in the motor 3 The zipper may not be securely fastened sealing the Animated Airblown Inflatable 4 The temperature may be below 14 F 10 C NOTE ONCE FAN IS UNPLUGGED AND STOPS BLOWING YOUR Airblown Inflatable WILL DEFLATE FREQUENTLY ASKED QUESTIONS FAQ s 1 Can I continually run my Airblown Inflatable Yes you can run your Airblown Inflatable during the day and at night We recommend that you turn off your Airblown Inflatable when leaving the immediate area and when retiring for the evening Otherwise your Airblown Inflatab
6. le is designed to run continually as you see fit 2 Whathappensifmy Airblown Inflatablebecomestorn Rips in the Airblown Inflatable can be sewn by hand no special thread is required or taped with clear packing tape 3 How can I clean my Airblown Inflatable Wipe clean with a damp cloth and allow to dry before storing away Use mild detergent if necessary 4 Whenlunplugmy Airblown Inflatable itdeflates Whyis this Your Airblown Inflatable will not stay inflated unless it is plugged in and the fan is blowing air 5 HowmuchelectricitydoesanAirblown Inflatableconsume It uses about as much energy as a standard string of holiday lights 6 Whatisthebestwaytostoremy Airblown Inflatable Store in a bag box or other storage container and keep in a cool dry location WARNING This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions 1 this device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment NOTE This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful int
7. not intended for permanent installation or use Do not mount or place near gas or electric heaters fireplaces candles or other similar sources of heat Do not secure product wiring with staples or nails or place on sharp hooks or nails Do not let lamps rest on the supply cord or on any wire Unplug the product when leaving the house when retiring for the night or if left unattended Do not use this product for other than its intended purpose Do not hang ornaments or other objects from cord wire or light string Do not close doors or windows on the product or extension cords as this may damage the wire insulation 11 Do not cover the product with a cloth paper or any material not part of the product when in use 12 Do not place the product against carpeting furniture or any other fabric when in use 13 This product has a polarized plug one blade is wider than the other as a feature to reduce the risk of electric shock This plug will fit in a polarized outlet only one way If the plug does not fit fully in the outlet reverse the plug If the plug still does not fit contact a qualified electrician Do not use an extension cord unless the plug can be fully inserted Do not alter or replace the plug 14 This product employs overload protection fuse A blown fuse indicates an overload or a short circuit condition If the fuse NO n A oe 37631 E INSTRUCTIONS blows unplug the produ
8. use electrocution 1 Grasp plug and remove from receptacle or other outlet device Do not unplug by pulling on the cord 2 Open the zipper opening on the Airblown Inflatable 3 Open the protective light cover carefully by pressing down on the two locking side tabs simultaneously 4 Replace lamp with same type ZW maximum candelabra base UL classified 5 Do not over tighten the lamp as this may damage the lamp or lamp holder CAUTION Replace only with same type C7 7 Watt Max Candelabra base 120 Volt UL Classified lamps Fuse Replacement WARNING Risk of Fire Replace only with same size and type of fuse WARNING Risk of Fire Do not replace the attachment plug Contains a safety device fuse that should not be removed Discard product if attachment plug is damaged 1 Grasp plug and remove from the receptacle or other outlet device Do not unplug by pulling on S the cord 2 Open fuse cover Slide open the fuse access cover on top of the attachment plug towards blades See illustration 3 Remove fuse carefully 4 Replace fuse only with 5 Amp Max 125 Volt provided with product SA 5 Close the fuse cover Slide closed the fuse access cover on top of the attachment plug CAUTION Do not connect to another lighting string decorative outfit or seasonal product To reduce the risk of fire do not deliberately reposition either lamp holder contact Do not attemptto inflate your A
Download Pdf Manuals
Related Search