Home Decorators Collection 26655 Troubleshooting Guide
Contents
1. Measure from a point on the center of the blade to the point on the ceiling Rotate the fan until the next blade is positioned for measurement and measure from the same point on each blade to the ceiling Repeat for each blade Any measurement deviation should be within 1 8 in Run the fan for ten minutes If the fan continues to wobble please contact Home Decorators Collection Customer Service and a balancing kit will be sent to you at no charge The mounting bracket is not firmly attached to the outlet box Make sure the mounting bracket is completely tightened to the outlet box The ball of the downrod assembly is not properly seated in the mounting bracket The ball has a notch that aligns with a tab on the mounting bracket Change the dip switch pattern in the remote control and repeat the learning process found in your ceiling fan owners manual If after you have changed the dip switches to all 16 possible settings the fan continues to turn itself on off replace the remote receiver The fan will not The fan needs to be running prior to pushing the reverse button Press a speed button on your remote and allow change direction the fan to start moving then press and hold the reverse button for 10 seconds The lights are flickering If you are using CFL light bulbs open the back of the remote control and verify that the ON DIM dipswitch is set to the ON position If you wish to use the DIM fea2. Troubleshooting Problem Solution S The fan will not start The fan is noisy The fan wobbles The fan turns itself on off Check the main and branch circuit fuses or breakers Check the line wire connections to the fan and switch wire connections in the switch housing Check the battery in the remote control Ensure you are in the normal range of 10 20 feet Remember to turn off the power supply before checking the dip switch settings Ensure all motor housing screws are snug Ensure the screws that attach the fan blade bracket to the motor hub are tight Ensure the wire nut connections are not rattling against each other or the interior wall of the switch housing Allow a 24 hour breaking in period Most noises associated with a new fan disappear during this time If you are using the Ceiling Fan light kit ensure the screws securing the glassware are tight Check that the light bulbs are also secure Ensure the canopy is a short distance from the ceiling It should not touch the ceiling Ensure your outlet box is secure and rubber isolator pads were used between the mounting plate and outlet box Check that all blade and blade arm screws are secure Most fan wobble problems are caused when blade levels are unequal Check this level by selecting a point on the ceiling above the tip of one of the blades
3. ture change the light bulbs to 60 watt max incandescent bulbs Replace the CFL bulbs with new CFL bulbs Do not use LED bulbs as they may damage the receiver use CFL or incandescent bulbs only
Download Pdf Manuals
Related Search