none BL01 Installation Guide
Contents
1. Line your toilet up It doesnt have to be perfect because this gasket is very forgiving and you can make some mistakes with no problems Set the stool down on the gasket and straighten it up to the wall om ea TOILET GASKET Lean on the toilet and feel it bottom out Put the plastic cap bottom washer and nuts on both bolts Dont tighten one side down and then the other Alternate tightening either side till they are snug but dont crank down and over tighten them Detailed instructions on toilet installation using Sani Seal Cut off your bolt about 1 8 above the nut with your hacksaw or bolt cutters Place your beauty caps and snap them on To get started you will need a few tools Install Sani Seal in 4 Easy Steps 1 Remove Toilet 2 Scrape wax off flange and bottom of bowl 3 Place Sani Seal over flange and bolts 4 Set bowl in place and tighten bolts snug Scan code with your phone to m 3s m watch our installation video Tools Reconnect your new supply line and hand tighten it till it s snug Turn your water on Check for leaks from the supply line d pever mataphae mra om amp an adjustable wrench a scraper or putty knife a Sani Seal Toilet Gasket or 2 depending on the depth of your flange anew bolt kit and a hack saw or bolt cutters Your toilet is ready for use q gt2. Shut off the water supply to the tank Disconnect the supply line from tank If you have an old stiff supply line we recommend you buy a new flexible supply line for a few dollars at your local hardware store Remove your beauty caps that are covering the bolts If your old bolts are rusted take your hacksaw and cut between the plastic and the nut to get it loose Once you remove the nut pull your stool off You probably had an old wax ring installed so take out the old bolts and use your putty knife or scraper to scrape off any residue on the flange and bottom of the stool It doesn t have to be perfect this gasket works just fine with a little residue on the flange and stool Place the Sani Seal Toilet Gasket over the bolts and line them up A great thing about this gasket is that it fits down over your bolts and helps hold them straight up for easy installation If your flange sits below floor level more than 3 8 this gasket is easily stacked You can also use plumbers paste or silicon on top in between or below the gaskets for added protection but it is not necessary On a second floor or over a finished basement we like to take silicon and fill in any voids on and around the flange so the water has no where to go but down the drain Normal Installation Unique design holds bolts upright and gasket in place Simple Easy Waxless Toilet Installation a o if installing toilet to a flange with a
3. ledge or shelf that does not allow the Sani Seal Toilet Gasket to slide down into the floor flange please install the Sani Seal Toilet Gasket as it is packaged with the flange folded in on itself and also upside down
Download Pdf Manuals
Related Search