Intec K10000-02 Installation Guide
Contents
1. h Hopper Power Cord Agitotor E Z WARNING2. off position a This product requires the use of a power cord In Connect the machine s power cord to a dedicated circuit addition to the supplied power cord care should be 115V 20amp or 15amp exercised in the selection and use of an extension ard To power machine first turn the control panel s blower switch b The extension cord shall be a grounded 3 wire cord to the on position then the agitator switch to the on c The extension cord should be arranged so that it will position Now use the remote switches to first turn the not drape over the countertop or tabletop where it blower then agitator on When turning machine off turn can be tripped over snagged or pulled on agitator off first then blower unintentionally especially by children Open a bag of insulation and feed the insulation material into d An outdoor rated extension cord should be used with the hopper Do not let the plastic bag or other foreign objects this machine An outdoor use extension cord is fall into the hopper do not force feed insulation marked with suffix letter W and with a tag stating Suitable for Use with Outdoor Appliances e The marked electrical rating of the extension cord shall be rated for at least 15 amps f To unplug or disconnect Put the blower and agitator control panel and remote buttons in the stop position before removing plug from outlet Do not unplug by pulling on the power cord To u
3. Operation and Safety Guide Model K10000 02 FORCE 1 Vendor Website www inteccorp com Support Phone No 800 666 161 1 Tool Application Overview of system http www inteccorp com force1 SAFETY TOPICS Tool Operation To avoid personal injury do not attempt to operate this Step Action equipment until you thoroughly read and completely understand the operator s manual Please visit Unload the machine using safe lifting techniques Position http Awww inteccorp com force1 for additional the machine in a dry hazard free environment to allow for information suitable material feed and access to electrical power Note At cold temperatures below 35 F oil thickens and will cause SAFETY CHECKLIST machine to start up hard To prevent hard startup leave Read all the instructions before using the insulation machine in warm area overnight 8 hours blower 2 Secure 100 feet of blowing hose to machine outlet with a hose clamp Remove slide gate locking pin open the slide gate to the last hole position for attic blow amp re insert locking pin See To reduce the risk of injury close supervision is necessary when an insulation blower is used near children 3 Do not contact moving parts 4 Only use attachments recommended or sold by the owner s manual for wall applications manufacturer Ensure all controls both on control panel and remote are 5 Use of Extension and Power Cord in the
4. nplug grasp the male and female plugs and pull Remote Control Cord apart Unplug from outlet when not in use and before servicing or cleaning i Do not operate any insulation blower with a damaged cord or plug or after the machine malfunctions or is dropped or damaged in any manner moll bel 6 Inthe case of a non operable or malfunctioning blower return the insulation blower to the nearest authorized service facility for examination repair or electrical or mechanical adjustment 7 Store insulation blower indoors when not in use Keep out of the reach of children 8 Never operate this equipment if the operator or the machine is standing in water snow or rain Do not clean Base this insulation blower with water spray or the like 9 Connect to a properly grounded outlet only 10 Wear long sleeve shirt gloves a hat safety glasses or goggles and a nose amp mouth dust mask At completion use the remote or control panel switch to turn machine off Remove any insulation still in the system Return machine hose wired remote and power cord to the rental center from which it was obtained Slide Gate Distribution Hose Never reach into the hopper when system is operating Wheels Keep all foreign materials out of hopper Agitator Motor Mlok Stop all motors and disconnect power cord before Blower em attempting to remove a foreign object or jam Never point insulation hose in direction of people or g
Download Pdf Manuals
Related Search