Buffalo Tools AR38 Use and Care Manual
Contents
1. 5 160 0 1 4 GAUGE PORTS P 74 1 Installation instruction 1 Theassembly of all calibration shall meet the maximum flow requirement 2 Maximum pressure of 144PSI 3 Direction air flow in the triangle on the primary unit 4 Place as close to the unit to be protected as possible S Place free of direct sun shine hot arca and hazardous chemicals b The water drainage shall be deployed beneath the water discharges for outlet of water into proper area 2 Regulation 1 Regulation of pressure a Raise off the part 1 and turn it clockwise to have the pressure up and counterclockwise to have the pressure down b Regulate the pressure to the desired level and press down the part 11 to lock it up 2 Drainage a Ifno pneumatic pressure water willdischarge the air into the atmosphere b When the water level exceeds the maximum limit please close the pressure and let the unit has no pneumatic pressure for draining offthe water to keep optimal dehumidification 3 Maintenance 1 Shutoff the alr supply and discharge the air into the atmosphere 2 Turnoffthe part 3 counterclockwise and then turn off the part 4 counterclockwise to remove the part 5 filter 3 The filter that makes the air flow outward is available for repeated use 4 Clean the transparent P C cup with a clean and dry cloth Do not use any chemical that would be hazardous to the P C material 100 _LUBRICATOR2. _ L Installation instruction 1 Site asclose to theunit tobe lubfticated as possible 2 Directinstallation of filted pressure regulator before the lubricator 4 Add the lubricant into the oil cup i Oil drop regulation i Regulation of the needle vaive Turn it clockwise for loss oil drop Turn it counterclockwise for more oil drop 2 flow regulation After setting the needle valve More air flow more oil dron Less air flow less oil drop 3 Oiling i Qiling is available without closing the air piping 2 Turn off the part 43 counterclockwise Use 1500 0232 or similar lubricants 4 After adding oil to the maximum Ievel tighten the part 43 to have oil drop Do not remove the oil cup directly for oiling 4 Maintenance i Shut off the air supply and discharge the air into the atmosphere 2 Turn offthe part 3 counterciockwise and remove the part 42 3 Ciean the transparent P C cup with a clean and dry cloth 100 not use any chemical that would be hazardous tothe P C material d When assembling thekit again please be sure that the SEAL and O RING are in correct positions NOTICE The productin reference is applicable in industriai pressure systems rather than in premises of pressure and temperature exceeding the marked ones This is not applicable in other fluids neither such as alcohol pas and gasoline as itis hazardous to the products by presenting leakage or flame 2 The plastic 7 armel paris when e
3. xposed to painis poor oil products and Chemicals resin polyethylene acetic acid and others would lead to aging in material in material and other defects
Download Pdf Manuals
Related Search