Unique Home Designs 5SH910BLACK36 Installation Guide
Contents
1. Installation Instructions This Door Seal Kit fills in gap between bottom of security door and threshold of doorway If your existing threshold extends under security door only the bug sweep and top seal need to be installed Skip steps 1 and 2 4 fm Attach Bottom Bar to Door Frame Make any necessary modifications to the bottom bar assembly to fit your door width and jamb size To fit a door narrower than 36 pe part can be trimmed with a hacksaw To fit door jambs less than 1 1 2 the rear vertical legs must be broken off of each end a aT Adjust bottom bar assembly by sliding part B in or out of part ae that the legs fit into the door Fame tubes Adjust height so that top of bottom bar is level with existing threshold Using a 5 32 dril bit drill four pilot holes through the door frame into the permanent vertical leg as shown Install bottom bar using four 10 self tapping screws F as shown Note Be sure to secure the bottom bar to the permanent leg _ Bottom of Door with Bottom Bar Installed Attach Bug Sweep to Bottom of Door If the bug sweep is wider than the door opening mark width of opening between left and right frame on the bug sweep Using a hack saw trim ug sweep D at your markings to match opening Measure at each end and at center of door the gap between metal flange on bug sweep D and threshold plate Using a razor knife and a straight edge trim bug sweep to lar2. d clean rubber bug sweep with non oily product such as mineral spirits MK628 Made in China Patent Pending
3. gest gap measurement Using a 1 8 drill bit and the bug sweep D as a template drill four pilot holes in the interior side of door Attach bug sweep D to interior side of door using four 8 self tapping screws H Bottom of Door with Bottom Bar Threshold Plate and Bug Sweep Installed For questions please contact Unique Home Designs at 877 340 3667 from Zam to 5pm MST send an email to 247info uhdco com or write to Unique Home Designs Customer Service at 973 N Colorado Street Gilbert AZ 85233 4 UNIQUE HOME DESIGNS Secure Threshold Plate to Existing Threshold Slide threshold plate C over the bottom bar and into place extending over the existing threshold Using a 1 8 drill bit drill six pilot holes through the threshold plate and into your existing threshold Fasten threshold plate to your existing threshold or stoop and to the bottom bar using six fs black screws G as shown Note Threshold plate may need to be cut to fit using tin snips a jigsaw or other suitable power tool Bottom of Door with Bottom Bar and Threshold Plate Installed Attach Top Seal to Top of Door Using 1 8 drill bit and top seal plate E as a template drill three pilot oles in top of door Attach top seal plate E using three 8 self tapping screws H Note This part is made to fit a 36 door and cannot be modified to fit smaller openings Top of Door with Top Seal Plate Installed Care and Maintenance As neede
Download Pdf Manuals
Related Search