Home Decorators Collection 25-898-72 Instructions / Assembly
Contents
1. 5 DD lt 4 y 4 Mounting 1 3 8 in Nylon Strap Wall 5 8 in Remote Bracket Screw Anchor Screw Control 2 2 QTY 2 QTY 2 QTY 1 PART DESCRIPTION QUANTITY PART NO A Mantel with Insert AA Mounting Bracket BB 1 3 8 Screw Nylon Strap DD Wall Anchor 5 8in Screw FF Control 22 N N KN 35 890mm Technical Specifications VOLTAGE 120 VAC FREQUENCY 60Hz HEATER RATING 1350W 12 5A MAX AMPS 4 fe u Main Power Button This button supplies power to all the functions of the log set The main power button must be in the ON position either from the remote or controls on the log set for the functions to work Heater Control Button This button controls the heater ON OFF and 5 temperature modes from Low to High When the heater is first turned on it will come on at the lowest room temperature setting The log set will remember the last heat setting and in later use the heater will start at that set2. a x BULB 1 BULB 2 are 5 AC120V 60HZ GND 4 40W 40 N ae POWER VO M gt gt CIRCUIT XA RN FAN NS FLAMEVO VV ae BOARD HEATER lt lt HEATER I O FLAME EFFECT MOTOR e WARNING DISCONNECT POWER BEFORE SERVICING Promo IR 23 Circuit principle diagram
3. ting unless power to the unit has been interrupted Each time the temperature button is pressed the temperature set point increases allowing you to adjust the ambient temperature HEATER locking function when fireplace is ON press the POWER button for 10 seconds The HEATER will be locked and the HEATER button on the control panel as well as on remote control will be disabled Before the heater is locked the flame will flash 6 times To un lock the heater press the POWER button for 10 seconds Before the heater is un locked the flame will flash 6 times Flame Control Button This button controls the brightness of the flame effect with settings at High Medium and Low When the log set is first turned on the flame will come on at the highest setting The log set will remember the last flame setting used and in later use the flame brightness will start at that setting unless power to the unit has been interrupted Each time the flame button is pressed the flame brightness decreases The only way to turn off the flame effect completely is to turn off the main power button u lt WARNING Do not exceed 40 watts bulb Use of higher rated bulbs may result a fire causing property damage or personal injury L RLY1 THERMAL THERMAL CUTOFF FUSE HEATER ELEMENT _
Download Pdf Manuals
Related Search